ADJ Mega Go Bar 50 Gebrauchs- und Pflegehandbuch

Inhaltsverzeichnis

Andere ADJ DJ-Equipment Handbücher

ADJ

ADJ MEGA TRI BAR Bedienungsanleitung

ADJ

ADJ ENCORE FR50Z Bedienungsanleitung

ADJ

ADJ StarTec Series Bedienungsanleitung

ADJ

ADJ MDF2PSUX156 Benutzerhandbuch

ADJ

ADJ WOLFMIX WMX1 Bedienungsanleitung

ADJ

ADJ 1226100361 Bedienungsanleitung

ADJ

ADJ MOD TWIOO Bedienungsanleitung

ADJ

ADJ Startec RAYZER Bedienungsanleitung

ADJ

ADJ SCENE SETTER 48 Bedienungsanleitung

ADJ

ADJ POCKET PRO Bedienungsanleitung

ADJ

ADJ Vizi BSW 300 Bedienungsanleitung

ADJ

ADJ StarTec Series Bedienungsanleitung

ADJ

ADJ M-103HD Bedienungsanleitung

ADJ

ADJ HEX206 Bedienungsanleitung

ADJ

ADJ 1223200047 Leitfaden

ADJ

ADJ WiFly QA5 IP Bedienungsanleitung

ADJ

ADJ 18P HEX IP Bedienungsanleitung

ADJ

ADJ ENCORE LP7P Bedienungsanleitung

ADJ

ADJ VIZI CMY300 Bedienungsanleitung

ADJ

ADJ 5PX HEX PEARL Bedienungsanleitung

ADJ

ADJ M-1212 Bedienungsanleitung

ADJ

ADJ BOOM BOX FX3 Bedienungsanleitung

ADJ

ADJ Startec STINGER Bedienungsanleitung

ADJ

ADJ VF SNOW FLURRY HO Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung

KAM

KAM DMX Laser80 FScan Bedienungsanleitung

BATTERY REPLACEMENT

Start by removing both bracket end caps. Unscrew the four phillips screws that hold each end in

place.

The following instructions will help you replace your dead battery in the Mega Go Bar 50. To replace

the battery you need to carefully follow these instructions. If you have any questions please contact

American DJ customer support.

Customer Support: American DJ provides a customer support line, to provide set up help and to answer any

question should you encounter problems during your set up or initial operation. You may also visit us on the

web at www.American DJ.com for any comments or suggestions. Service Hours are Monday through Friday

8:00 a.m. to 4:30 p.m. Pacic Standard Time.

Voice: (800) 322-6337

Fax: (323) 582-2941

E-mail: support@AmericanDJ.com

Once the bracket end caps have

been removed, slide out the plastic

LED cover.

After you have removed the LED

cover. Look carefully at the LED strip.

You should see an area at one end

where the LED strip seperates. At that

end, slide the LED strip out, so that

small strip is removed from the hous-

ing. It is still connected to the other

strip, so do not try to fully remove it.

After this strip is out of the housing.

Slide the larger LED strip back the

opposite way.

Slide the strip until the full battery

housing is shown. This is as far as

you need to slide the LED strip. Slid-

ing it any farther could seperate wires

and cause damage.

Carefully disconnect the LED wire

harness from the PC board.

After disconnecting the wire harness,

“ip” the bar over so the rear is facing

up. Remove the two phillips screws

that secure the battery bracket.

After unscrewing and removing the

screws, “ip” the unit back over, and

carefully remove the battery bracket.

Disconnect the IR sensor cable from

the PC board.

Disconnect the DMX In connection

cable.

Disconnect the DMX Out connection

cable.

Disconnect the battery cable.

Carefully remove the battery.

After you have replaced the battery,

simply reassemble in reverse order.

Make sure that all cables are con-

nected correctly. When sliding the

LED strip back into place, do this

gently. You might feel some resis-

tance. DO NOT force the LED strip.

Slide the strip back in the opposite

direction, make sure that all cables

are out of the way. Please contact

American DJ customer service if you

need any help.