ADTRAN Total Access 612 Bedienungsanleitung

TOTAL ACCESS 612/616/624 (T1 TDM) P/N 4200624L1#TDM

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

Connecting to the Total Access 6xx (T1 TDM)

Connecting a VT100 terminal (or VT100 terminal emulator) to the CRAFT

interface (on the rear panel of the unit) allows access to the terminal menus

and management features of the Total Access 6xx (T1 TDM).

Perform Steps Below in the Order Listed:

1. Configure a VT100 terminal (or terminal emulation software) with the

following settings:

If the terminal has a parallel setting, disable it and use serial.

2. Connect one end of the 6” data cable (supplied) into the Total Access 6xx

(T1 TDM) CRAFT port. (This connection is RJ-45.) Make the connection to

the VT100 terminal as appropriate for your connection. The pinout for the

DB-9 to RJ-45 adapter follows:

3. Initiate a terminal session and the LOGIN screen displays. By default, there

is no password assigned to the Total Access 6xx (T1 TDM) unit. Refer to

the Total Access 600 Series System Manual for details on assigning a

password to the CRAFT interface.

Data Rate: 9600 baud Stop Bits: 1

Data Bits: 8 Flow Control: None

Parity Bits: None

DB-9 RJ-45 Description

2 5 TX Data - Transmit Data from Unit

3 3 RX Data - Transmit Data from Terminal

5 1 GND - Ground

Status LEDs

The Status LEDs display the status of the network T1, 10/100BaseT interface, voice

connection, and other system parameters for the Total Access 6xx (T1 TDM). For a

more detailed discussion of the front panel LEDs, refer to Section 2, Engineering

Guidelines, of the Total Access 600 Series System Manual.

Connecting Power to the Total Access 6xx (T1 TDM)

The AC powered Total Access 6xx (T1 TDM) comes equipped with a detachable

8-foot power cord with a 3-prong plug for connected to a grounded power receptacle.

Please refer to Section 3, Network Turnup Procedures, of the Total Access 600 Series

System Manual for more detailed instructions.

LED DESCRIPTION

TX/RX Indicates data traffic on the 10/100BaseT interface.

LINK Indicates the status of the 10/100BaseT interface (link up or down).

V.35 RX Indicates received data traffic on the V.35 DTE interface.

V/35 TX Indicates transmit data traffic on the V.35 DTE interface.

DATA Indicates T1 status such as Test, RED alarm, or T1 sync loss.

VOICE Indicates the status of the Voice port.

BATT Indicates the status of the Battery Backup Connection.

PWR NET Indicates the physical status of the T1 interface.

• This unit shall be installed in accordance with Article 400 and 364.8

of the NEC NFPA 70 when installed outside of a Restricted Access

Location (i.e., central office, behind a locked door, service

personnel only area).

• Power to the Total Access 6xx (T1 TDM) must be from a grounded

90-240 VAC, 50/60 Hz source.

• The power receptacle uses double-pole, neutral fusing.

• Maximum recommended ambient operating temperature is 45°C

Reviewing the Front Panel

TOTAL ACCESS 612/616/624 (T1 TDM) P/N 4200624L1#TDM

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

AC Power Connection

Network (T1)

Connection

Life Line

POTS

Battery Backup

Connection

10/100BaseT

Ethernet

V.35 DTE

Connection

Voice Connection

CRAFT Interface

Reviewing the Rear Panel Design

Voice Connection

A single 50-pin female amphenol connector provides the interconnect wiring for

the analog circuits (FXS, FXO). Refer to Section 2, Engineering Guidelines, of

the Total Access 600 Series System Manual for a detailed pinout.

LIFE LINE POTS Pinout

NTWK (T1) Pinout

V.35 Connection

The V.35 DTE interface is compliant with ITU Recommendations through a

standard 34-pin Winchester connector. Refer to Section 2, Engineering

Guidelines, of the Total Access 600 Series System Manual for a detailed pinout.

PIN NAME DESCRIPTION

1,2, 5, 6 UNUSED —

3 RING Life Line Ring Connection

4 TIP Life Line Tip Connection

PIN NAME DESCRIPTION

1 R1 | RXDATA-RING Receive data from the network (RING)

2 T1 | RXDATA-TIP Receive data from the network (TIP)

3 UNUSED —

4 R | TXDATA-RING Transmit data towards the network (RING)

5 T | TXDATA-TIP Transmit data towards the network (TIP)

6,7,8 UNUSED —

CRAFT Pinout

10/100BaseT Ethernet Pinout

Battery Backup Connection

An optional battery backup system is available for the Total Access 6xx (T1 TDM)

(P/N 1175044L1, 2, or 4). Refer to the documentation available for your specific

battery backup unit for more information on this connection.

PIN NAME DESCRIPTION

1 GND Ground - connected to unit chassis

2 RTS Request to send - flow control

3 RXDATA Data received by the unit

4 DTR Data terminal ready

5 TXDATA Data transmitted by the unit

6 CD Carrier detect

7 UNUSED —

8 CTS Clear to send - flow control

PIN NAME DESCRIPTION

1 TX1 Transmit Positive

2 TX2 Transmit Negative

3 RX1 Receive Positive

4,5 — Unused

6 RX2 Receive Negative

7, 8 — Unused

Dieses Handbuch passt für folgende Modelle

Andere ADTRAN Drahtloser Zugangspunkt Handbücher

ADTRAN

ADTRAN BSAP 6040 Bedienungsanleitung

ADTRAN

ADTRAN BSAP 6120 Bedienungsanleitung

ADTRAN

ADTRAN ATLAS 550 Bedienungsanleitung

ADTRAN

ADTRAN BLUESOCKET 2135 Bedienungsanleitung

ADTRAN

ADTRAN 2135 Bedienungsanleitung

ADTRAN

ADTRAN Bluesocket 3040 Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 150 Bedienungsanleitung

ADTRAN

ADTRAN BLUESOCKET 1920 Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 900 Series Bedienungsanleitung

ADTRAN

ADTRAN BLUESOCKET 1940 Bedienungsanleitung

ADTRAN

ADTRAN Total Access 850 Bedienungsanleitung

ADTRAN

ADTRAN Total Access 5004 Bedienungsanleitung

ADTRAN

ADTRAN BLUESOCKET 1930 Bedienungsanleitung

ADTRAN

ADTRAN SMART/RG SR506n Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 2054 Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 160 Bedienungsanleitung

ADTRAN

ADTRAN Bluesocket 2020 Series Bedienungsanleitung

ADTRAN

ADTRAN T400TAC Wartungs- und Serviceanleitung

ADTRAN

ADTRAN 1700412E1 Bedienungsanleitung

ADTRAN

ADTRAN BLUESOCKET 3045 Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 950 IAD Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 150 Series Handbuch

ADTRAN

ADTRAN NetVanta 160 Montageanleitung

ADTRAN

ADTRAN BLUESOCKET 3040 Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM2 Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung