Advantech PCM-4862 Bedienungsanleitung

PCM-4862

All-in-One 486 Single Board

Computer with SVGA, Ethernet,

and SSD

This document is copyrighted, 1996. All rights are reserved. The

original manufacturer reserves the right to make improvements to

the products described in this manual at any time without notice.

No part of this manual may be reproduced, copied, translated or

transmitted in any form or by any means without the prior written

permission of the original manufacturer. Information provided in

this manual is intended to be accurate and reliable. However, the

original manufacturer assumes no responsibility for its use, nor for

any infringements upon the rights of third parties which may result

from its use.

Acknowledgements

VIA is a trademark of VIA Technology, Inc.

AMD is a trademark of Advanced Micro Devices, Inc.

Award is a trademark of Award Software International, Inc.

Cyrix is a trademark of Cyrix Corporation.

IBM, PC/AT, PS/2 and VGA are trademarks of International

Business Machines Corporation.

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows ®is a registered trademark of Microsoft Corp.

SMC is a trademark of Standard Microsystems Corporation.

RTL is a trademark of Realtek Semi-Conductor Co., Ltd.

C&T is a trademark of Chips and Technologies, Inc.

UMC is a trademark of United Microelectronics Corporation.

All other product names or trademarks are properties of their

respective owners.

Part No. 2006862020 3rd Edition

Printed in Taiwan September 1997

Packing list

Before you begin installing your card, please make sure that the

following materials have been shipped:

• 1 PCM-4862 All-in-One Single Board Computer

• 1 utility disk with system BIOS, VGA BIOS, and Ethernet

utility programs

• 1 utility disk with SVGA utility programs and drivers for

Windows 3.1 and Windows 95

• 1 utility disk with Ethernet drivers

If any of these items are missing or damaged, contact your

distributor or sales representative immediately.

Contents

Chapter 1 General Information ................................. 1

Introduction............................................................................ 2

Features ................................................................................... 3

Specifications.......................................................................... 3

Standard SBC functions ....................................................... 3

Local-bus flat panel/VGA interface ..................................... 4

Ethernet controller function ................................................. 5

Solid state disk function ....................................................... 5

PC/104 bus expansion .......................................................... 5

Mechanical and environmental ............................................ 5

Board layout and dimensions ................................................ 6

Chapter 2 Installation ................................................ 7

Jumpers and connectors........................................................ 8

Locating jumpers ................................................................. 10

Locating connectors ............................................................. 11

Setting jumpers .................................................................... 12

Safety precautions ................................................................ 13

Installing the CPU................................................................ 13

Removing a CPU................................................................ 13

Installing a CPU ................................................................. 14

CPU type select (J1-J13, J17-J19) ..................................... 15

CPU power supply select (J4, J6) ....................................... 17

CPU clock select (J1, J2, J3).............................................. 17

CMOS setup (J14).............................................................. 17

Buzzer enabled/disabled (J21) ........................................... 17

Installing DRAM (SIMMs) ................................................. 18

Installing SIMMs ............................................................... 18

IDE hard drive connector (CN12) ...................................... 19

Connecting the hard drive .................................................. 19

Floppy drive connector (CN15)........................................... 20

Connecting the floppy drive ............................................... 20

Parallel port connector (CN16)........................................... 21

Parallel port IRQ ................................................................ 21

Keyboard and PS/2 connector (CN9) ................................. 21

Front panel connector (CN4) .............................................. 22

Power connectors (CN6, CN11, CN14)............................... 22

Peripheral power connector, -5V, -12V (CN6) ................... 22

Main power connector, +5V, +12V (CN11) ....................... 22

Fan power supply connector (CN14).................................. 22

Serial ports (CN13, CN8) .................................................... 23

COM1 RS-232 port (CN13)............................................... 23

COM2 RS-232/422/485 selection (CN8)........................... 23

VGA interface connections.................................................. 24

CRT display connector (CN1)............................................ 24

Flat panel display connector (CN2) ................................... 24

Ethernet configuration ........................................................ 25

10BASE-2/10BASE-5 AUI connector (CN7) .................... 25

10BASE-T connector (CN10) ............................................ 26

Network boot ...................................................................... 26

Watchdog timer configuration............................................ 26

Watchdog timer enable/disable .......................................... 26

Watchdog timer action (J23, J24)....................................... 26

Solid State Disk Configuration ........................................... 27

Memory devices ................................................................. 28

Memory address selection (J27) ........................................ 29

I/O address selection (J27) ................................................. 29

Drive emulated (J27) .......................................................... 30

SSD device and size selection (J31, J30) ........................... 31

SSD hardware enable/disable (J29).................................... 31

DOS 5.0 .............................................................................. 32

DOS 3.3 .............................................................................. 32

Booting from the Flash/ROM disk..................................... 33

Inserting memory devices .................................................. 33

Using a memory manager (EMM386.EXE) ...................... 34

Chapter 3 Software Configuration ......................... 33

Introduction.......................................................................... 34

Utility disk ............................................................................ 34

VGA display software configuration .................................. 36

Connections for four standard LCDs ................................. 38

Connections to Sharp LM64183P

(640 x 480 DSTN MONO LCD)........................................ 38

Connections to PLANAR EL

(640 x 480 AD4 EL)........................................................... 39

Connections to Toshiba LTM09C016

(640 x 480 TFT Color LCD) .............................................. 40

Connections to Sharp LM64C142

(640 x 480 DSTN Color LCD)........................................... 41

Ethernet software configuration......................................... 42

Chapter 4 Award BIOS Setup .................................... 45

System test and initialization .............................................. 46

System configuration verification ..................................... 46

AWARD BIOS setup............................................................. 47

Entering setup..................................................................... 47

Standard CMOS setup........................................................ 48

BIOS features setup............................................................ 49

CHIPSET features setup .................................................... 50

Power management setup ................................................... 51

Load BIOS defaults............................................................ 52

Change password ................................................................ 53

Auto detect hard disk ......................................................... 54

Save & exit setup................................................................ 54

Exit without saving............................................................. 54

Chapter 5 SVGA Setup............................................... 55

Simultaneous display mode ................................................. 56

Sleep mode ............................................................................ 56

Software support .................................................................. 57

Driver installation ................................................................ 58

Windows setup ................................................................... 59

AutoCAD R12.................................................................... 62

Lotus 1-2-3 and Lotus Symphony...................................... 64

VESA ................................................................................. 66

Word ................................................................................... 67

WordPerfect ........................................................................ 68

Appendix A Programming the Watchdog Timer .... 71

Appendix B Installing PC/104 Modules .................... 73

Installing PC/104 modules................................................... 74

Appendix C Pin Assignments ................................... 77

CRT display connector (CN1)............................................ 78

Flat panel display connector (CN2) ................................... 78

PC/104 connectors (CN3, CN5)......................................... 79

Front panel connector (CN4) ............................................. 80

Peripheral power connector (CN6)..................................... 80

10BASE-2/10BASE-5 AUI connector (CN7) .................... 80

COM2 RS-232/422/485 serial port (CN8)......................... 81

Keyboard and mouse connector (CN9) .............................. 81

Ethernet 10BASE-T connector (CN10) ............................. 82

Main power connector (CN11)........................................... 82

IDE hard drive connector (CN12) ...................................... 82

COM1 RS-232 serial port (CN13) ..................................... 83

Fan power connector (CN14) ............................................. 83

Floppy drive connector (CN15) ......................................... 84

Parallel port connector (CN16) .......................................... 85

Appendix D Optional Extras ..................................... 87

PCM-10586-1 Cable kit for PCM-4862/5860.................... 88

PCM-20486-1 Boot ROM binary files for............................

PCM-4860/4862 ................................................................. 88

Chapter 1 General Information 1

General

Information

This chapter gives background informa-

tion on the PCM-4862.

Sections include:

• Card specifications

• Card layout and dimensions

CHAPTER

2PCM-4862 User's Manual

Introduction

The PCM-4862 is an enhanced, all-in-one single board 486

computer with an on-board Ethernet interface, local-bus SVGA

controller and solid state disk. The PCM-4862 offers all the

functions of an AT-compatible industrial computer on a single

board, but it fits in the space of a 5¼" floppy drive (only 5.75" x

8"). For maximum performance, the PCM-4862 also supports 2nd

level cache sizes from 128 KB to 512 KB (32 KB x 8, 64 KB x 8,

or 128 KB x 8).

On-board features include two serial ports (RS-232 and RS-232/

422/485), one parallel port, an enhanced IDE hard-drive controller

(for up to two drives), a floppy-drive controller and a keyboard/PS/

2 mouse interface. The board's watchdog timer can automatically

reset the system or generate an interrupt if it stops due to a program

bug or EMI problem.

An on-board solid state disk (SSD) emulates a floppy drive using

EPROM or Flash memory devices. You access the SSD using

standard DOS commands or BIOS I/O. The system can even boot

from the SSD. Disk capacity is up to 1.44 MB, depending on the

size of the memory chips. If you use Flash memory, you can read

and write to the disk just like a floppy. If you use EPROM, the disk

is read-only and you must program the chips with an EPROM

programmer.

The PCM-4862 also complies with the "Green Function" standard

and supports three types of power saving features: Doze mode,

Standby mode, and Suspend mode.

All display and Ethernet configuration is done through software. A

single Flash chip holds the system BIOS, VGA BIOS and the

network boot ROM image. This minimizes the number of chips and

eases configuration. You can change the display BIOS or install a

boot ROM simply by programming the Flash chip.

If you need any additional functions, you can add up to six

industry-standard PC/104 expansion modules. For those who

require special functions, we have developed a PC/104 to ISA

adaptor so you can use your standard ISA card.

Andere Handbücher für PCM-4862

Inhaltsverzeichnis

Andere Advantech Hauptplatine Handbücher

Advantech

Advantech AIMB-641 Bedienungsanleitung

Advantech

Advantech ACP-4020 Bedienungsanleitung

Advantech

Advantech PCM-9588 Installations- und Betriebshandbuch

Advantech

Advantech SOM-5787 Bedienungsanleitung

Advantech

Advantech SOM-ETX Series Leitfaden

Advantech

Advantech ASMB-787 Bedienungsanleitung

Advantech

Advantech SIMB-982 Bedienungsanleitung

Advantech

Advantech PCA-6168 Bedienungsanleitung

Advantech

Advantech PCI-7030 Bedienungsanleitung

Advantech

Advantech ASR-1000K-00A1E Installations- und Betriebshandbuch

Advantech

Advantech MIC-3385 Bedienungsanleitung

Advantech

Advantech AIMB-240 Series Installations- und Betriebshandbuch

Advantech

Advantech SOM-6868 Bedienungsanleitung

Advantech

Advantech SIMB-U01 Bedienungsanleitung

Advantech

Advantech AIMB-562 KIOSK Bedienungsanleitung

Advantech

Advantech AIMB-275 Bedienungsanleitung

Advantech

Advantech PCM-9590 Bedienungsanleitung

Advantech

Advantech AIMB-233 Bedienungsanleitung

Advantech

Advantech ASMB-782 Installations- und Betriebshandbuch

Advantech

Advantech AIMB-242 Bedienungsanleitung

Advantech

Advantech PCM-4372 Bedienungsanleitung

Advantech

Advantech AIMB-341 Bedienungsanleitung

Advantech

Advantech AIMB-276 Bedienungsanleitung

Advantech

Advantech ASMB-788 Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Biostar

Biostar M7VIT Bravo Bedienungs- und Montageanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung