FCC
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which and be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions (1) This device may not cause
harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation
Changes and modification not expressly approved by the manufacturer
or registrant of this equipment can void your authority to pperate this
equipment under Fedral Communications Commissions rules.
F i x t h e C a e r a
Please follow the steps below if you want to fix the camera to wall or
ceiling.
1. Fix to Wal l
1.1 Drill one hole on the mounting surface, insert the anchor into the
hole, then align the mounting plate with the hole you just drilled
and drive the screw through the plate into the anchor;
1.2 Hang the camera on the hooks of mounting plate;
1.3 Push downwards the camera firmly.
2. Fix to Ceiling
2.1 Detach the universal bracket from the camera and then install it to
the camera top for avoiding reverse picture;
2.2 Secure the mounting plate to ceiling with screw;
2.3 Hang the camera on the hooks of mounting plate;
2.4 Push the camera firmly as the shown direction.
2 11
