AEG NM 1800 Bedienungsanleitung

Instruction Manual

Sewing Machine NM 1600/1800

Instruction Manual

Sewing Machine NM 1600/1800

Bedienungsanl.1800/1600 GB 30.08.2004 17:44 Uhr Seite 2

Contents

Contents Page

Page

Important introduction 2

Important instructions 3

Name of Parts 4

Accessory 5

Power supply 5

Change the electric light bulb 5

Change the needle 6

Selection of the right needle 7

Remove and attach presser foot 7

Adjust the threading tension 7

Adjust the lower threading tension 8

Reverse stitch 8

Stitch selection dial 8

Remove the bobbin case 9

Wind the bobbin 10

Thread the upper threading 11

Draw up lower threading 11

Straight sewing and zigzag sewing 12

Start sewing 12

Change sewing direction 12

Strengthen the stitches 12

Tricot stitch 13

Witchcraft or herringbone stitch 13

Zipper insertion 13

Make a buttonhole 14

Hem 15

Button sewing 15

Blind hem sewing 16

Free arm sewing 16

Clean the bobbin case 17

Clean feed dog 17

Oil the machine 18

Bedienungsanl.1800/1600 GB 30.08.2004 17:44 Uhr Seite 3

Impor

Important intr

tant introduction

oduction

Before using the machine please read the following instructions carefully.

Take enough time to read it.

By doing that, you’ll get a general idea of functioning and of the function

of the machine what will help you to work more easily and successfully.

The better you familiarize yourself with the work, the straighter you can

use the sewing machine.

This sewing machine has only been produced for use in the home.

Bedienungsanl.1800/1600 GB 30.08.2004 17:44 Uhr Seite 4

Important instructions!

Before using the sewing machine, the following instructions should always

be followed:

1. Operate the machine with the adequate caution - because of the needle

going up and down – and keep an eye at the sewing place while working!

2. Always unplug before changing the light bulb, the needle, the sewing foot,

the spool, the needle plate as well as during interruption of work without

supervision or during maintenance for reasons of safety.

Always unplug from the electrical outlet in these cases!

3. The light bulb’s maximal power is 15 watts. The sewing machine is

supplied with a commercial screw light bulb (thread name E14).

Bedienungsanl.1800/1600 GB 30.08.2004 17:44 Uhr Seite 5

Name of parts

1 Bobbin case cover

2 Needle plate

3 Presser foot

4 Needle

5 Thread cover

6 Front cover, bulb cover

7 Thread take-up leaver

8 Upper threading tension

9 Thread guidance

10 Thread retainer guidance

11 Presser foot lever

12 Stitch selection button

13 Stitch length selection button

14 Cover

15 Thread retainer stopper

16 Sewing spool

17 Balance wheel

18 Coupling

19 Reverse button

20 Light switch

21 Cloth plate

Bedienungsanl.1800/1600 GB 30.08.2004 17:44 Uhr Seite 6

Accessory

Power supply

Put the coupling plug into the sewing

machine.

Put the plug into the wall socket.

(See figure)

Change the electric light bulb

The sewing lamp is behind the front cover.

Open the front cover with a screw driver

and unscrew the light bulb.

After that, put in the new light bulb.

WARNING! Pull the plug out of the

wall socket!

1. screw driver

2. ripper

3. felt plate

4. needles

5. oilcan

6. shuttles

7. sew on button foot

8. buttonhole foot

9. hem foot

10. zipper foot

11. blind stitch foot

Bedienungsanl.1800/1600 GB 30.08.2004 17:45 Uhr Seite 7

Change the needle

Turn the balance wheel into your direction

until the needle is in the highest position.

Loosen the needle screw and remove the

needle from the fixture (see figure).

After that, put the new needle into the fixture

– with its flat side at the back. Press the nee-

dle as wide as possible up into the needle fix-

ture. Tighten the needle fixture screw secu-

rely again.

Selection of the right needle

The needle’s thickness is displayed

on the shaft.

In any case, do not use a bent or

blunt needle!

Bedienungsanl.1800/1600 GB 30.08.2004 17:45 Uhr Seite 8

Remove and attach pr

Remove and attach presser foot

esser foot

Remove:

Turn the hand wheel as wide as you can into

your direction until the needle reaches its hig-

hest position.

By lifting the presser foot lever you lift the

presser foot (1).

The presser foot falls down if you lift the lever

at the back of the foot switch (2).

Warning: Do not use force!

Attach:

Put the presser foot on the needle plate so

that the groove at the foot is directly situated

under the groove of the foot holder.

Adjust the threading tension

If you can pull the thread slightly with a small

resistance out of the bobbin, the threading

tension is correct.

As the lower threading tension is already set

by the factory concerning general sewing, it

needs not to be regulated very often.

In the case of very light or heavy materials,

the lower threading has to be regulated.

Adjust the lower threading

tension:

Turn the screw clockwise to increase the

tension.

Bedienungsanl.1800/1600 GB 30.08.2004 17:45 Uhr Seite 9

Stitch length selection dial

To change the stitch length you can

turn the selection dial so that the

number of the desired stitch length

is at the mark.

The numbers stand for the approximate

stitch length in mm.

The lower the number is the shorter the

stitch is.

Reverse stitch

Press the button down to use

the reverse stitch.

Stitch selection dial

You can set the desired stitch

using the stitch selection dial.

Stich length

selection

button

Bedienungsanl.1800/1600 GB 30.08.2004 17:45 Uhr Seite 10

Remove the bobbin case

Set up the presser foot, turn the hand wheel

into your direction until the thread take-up

lever is on its position (figure 1).

Open the bobbin cover (figure 2).

After that, open the bobbin case and

take the case out of the machine

(figure 3). As long as you keep the

cover of the bobbin case open, the

bobbin cannot fall out.

As soon as you release the cover,

the bobbin falls out.

Bedienungsanl.1800/1600 GB 30.08.2004 17:45 Uhr Seite 11

Inhaltsverzeichnis

Beliebte Nähmaschine Handbücher anderer Marken

Riccar

Riccar RL634DE Bedienungsanleitung

Pfaff

Pfaff 3307-1 SERIES Bedienungsanleitung

Siruba

Siruba C007JP Bedienungsanleitung

Husqvarna Viking

Husqvarna Viking Designer SE Bedienungsanleitung

Singer

Singer 148-5 Bedienungsanleitung

IKEA

IKEA SY Bedienungsanleitung

Pfaff

Pfaff 571 Bedienungsanleitung

Singer

Singer 15-91 Bedienungsanleitung

Brother

Brother BB370 Bedienungsanleitung

Pegasus

Pegasus WT100 Series Bedienungsanleitung

Reliable

Reliable 7100DB Bedienungsanleitung

Pfaff

Pfaff 937 Bedienungsanleitung

Singer

Singer 6038 Bedienungsanleitung

Singer

Singer 413K Bedienungsanleitung

Pfaff

Pfaff 1471 E1 Bedienungsanleitung

Kenmore

Kenmore 16677 - Serger Sewing Machine Bedienungsanleitung

HIGHLEAD

HIGHLEAD GC2008-M Bedienungsanleitung

Singer

Singer 400W4 Bedienungsanleitung