Agora Models JAGUAR E-TYPE Handbuch

STAGE 32: STEERING SYSTEM COMPONENTS

STAGE 33: COOLING SYSTEM COMPONENTS

STAGE 34: THE FRONT BULKHEAD

STAGE 35: BULKHEAD FITTINGS

AND PIPEWORK

STAGE 36: BULKHEAD FITTINGS

STAGE 37: ENGINE BAY FITTINGS

STAGE 38: RIGHT FRONT WHEEL

STAGE 39: RIGHT FRONT WHEEL

STAGE 40: RIGHT FRONT WHEEL

Pack 05

BUILD INSTRUCTIONS

AGORAMODELS JAGUAR E-TYPE

Spare screws are included with each part. Occasionally, you may be instructed to keep spare or

unused screws for a later stage. Keep these spares in a safe place and label them correctly.

Please make sure you don’t mix up the screws. They look quite similar, but the threads do vary

slightly. Using the wrong screws may damage the parts.

When securing parts together using multiple screws, ﬁt each screw loosely to ensure all the

parts are correctly aligned before gently tightening them ﬁrmly, but not overtight, in the order

in which you placed them.

The screwdriver can be magnetized by stroking it with a magnet (fridge magnet, etc.) enabling

it to hold the screws and make assembly easier.

If a screw is tight going into a metal part, do not force it as you may shear the head off. Remove

it and put a tiny smear of Vaseline, soap or light oil on the thread. That will lubricate it and make

it easier to drive home.

During the course of this build, you will receive many pieces that you will assemble immediately

– following the instructions in the corresponding stage – and other pieces that you should store

safely to one side, for use in future assembly stages.

Left and Right! When building your Jaguar, the left or right hand side refers to each side as you

are sitting in the car.

WARNING: Some parts are assembled using magnets. These magnets can cause serious injury

if they are swallowed. Keep away from children. If you suspect a magnet has been swallowed,

seek medical help straight away.

Advice from the experts

AGORAMODELS JAGUAR E-TYPE

Name

Steering column assembly Steering column assembly

Rack mountings x2

Water pump

Steering rack assembly

Radiator hose

Anti roll-bar links x2

Anti roll-bar mountings x2

Anti-roll bar

Steering rack mounting

Water hose

Screws type AM01 x5

Screws type AG04 x3

Screws type AM16 x3

Screws type AM17 x3

Screws type AG06 x3

Screws type AG08 x5

STAGE 32 PARTS LIST

In this ﬁrst stage of pack 5, you will add

components for the steering system

to the subframe, and add further

components to the engine, before

ﬁtting the engine to the subframe.

Stage 32: Steering System Components

Steering rack assembly

AM01 x5

Anti-roll bar

Rack mountings x2 Water pump

Steering column assembly

AG08 x5

AG06 x3

AM17 x3

AM16 x3

AG04 x3

Steering rack

mounting

Water hose

Anti roll-bar mountings x2

Anti roll-bar links x2

Radiator hose

AGORAMODELS JAGUAR E-TYPE

STEP 1

Take the anti-roll bar and push one of the anti-roll bar links over the

pin at one end. Make sure the pin on the link faces the anti-roll bar.

Repeat the process to ﬁt the second link on the opposite end.

Secure the link with an AG08 screw.

Position the anti-roll bar on the front of the subframe, within the

triangles formed by the diagonal stays at the front of the subframe.

Stage 32: Steering System Components

AG08

AGORAMODELS JAGUAR E-TYPE

Locate the ﬂat tabs on both ends of the anti-roll bar on the supports

on the subframe.

Secure the link from the front using an AG08 screw.

Feed the pins on the end of the links into the holes in the bottom

wishbone.

Fit the link on the other end of the anti-roll bar in the same way,

securing it with another AG08 screw.

Stage 32: Steering System Components

AG08 AG08

AGORAMODELS JAGUAR E-TYPE

Take one of the anti-roll bar mountings and ﬁt it over the anti-roll bar,

lining up the hole and the pin. Note: you may need to ﬁle a little excess

plastic off the pin and/or clearn any ﬂash or paint from the hole to

ensure a good ﬁt.

Repeat the process on the opposite end of the anti-roll bar, securing

the second mounting in place with another AM17 screw.

Secure the mounting in place with an AM17 screw.

Take the steering rack mounting and align the pins on the underside

with the matching holes in the subframe.

Stage 32: Steering System Components

AM17

AGORAMODELS JAGUAR E-TYPE

Press the mounting onto the subframe

Take the right-hand lower brace from stage 26 and ﬁt it across the

subframe with the screwhole in the end aligned with the second

screwhole on the steering rack mounting.

Secure in place from the underside using an AG04 screw.

Secure the right-hand lower brace to the steering rack mounting

using an AG04 screw. Be careful not to over tighten this screw.

Stage 32: Steering System Components

AG04

AGORAMODELS JAGUAR E-TYPE

Now take the engine assembly and position the water pump above

the engine pulleys as shown.

Fit the water hose by pushing one end over the pin on the water

pump, and tuck the other end behind the plug leads.

Fit the water pump behind the uppermost pulley.

This is how the water hose should look once ﬁtted.

Stage 32: Steering System Components

AGORAMODELS JAGUAR E-TYPE

21 22

Returning to the subframe assembly, feed the steering column

assembly through the subframe until the gear at the end of the

steering column sits in the steering rack mounting (see step 22).

Now feed the steering rack assembly through the triangular braces

at the front of the subframe. Check that the teeth on the rack are

positioned so that they will align with the gear.

Note: when the wheels are pointing straight ahead, the ﬂat side of the

‘D’ on the end of the steering column assembly (opposite the gear)

should be level and facing upwards (inset).

Press the gear into the mounting.

Check that the teeth on the rack are positioned so that they align and

mesh with the gear (arrow No 1). Fit the ends of the steering rack over

the posts on the steering uprights (arrow No 2).

Stage 32: Steering System Components

AGORAMODELS JAGUAR E-TYPE

Secure the steering rack to each upright using an AM16 screw

Secure the mounting in place using 2 x AM01 screws.

Take one of the steering rack mountings, using tweezers, position it

over the steering rack, lining up the two screwholes with the holes on

the subframe.

Repeat steps 26 & 27 to ﬁt the other mounting to the right-hand side.

Stage 32: Steering System Components

AM16 AM16

2 x AM01 2 x AM01

Andere Handbücher für JAGUAR E-TYPE

Andere Agora Models Motorisiertes Spielzeugauto Handbücher

Agora Models

Agora Models STEVE MCQUEEN'S ICONIC PORSCHE 917KH Handbuch

Agora Models

Agora Models STEVE MCQUEEN'S ICONIC PORSCHE 917KH Pack 10 Handbuch

Agora Models

Agora Models Hachette Mitsubishi A6MZERO FIGHTER Bedienungsanleitung

Agora Models

Agora Models Steve McQueen's Iconic Porsche 917KH Pack 01 Handbuch

Agora Models

Agora Models JAGUAR E-TYPE Handbuch

Agora Models

Agora Models MERCEDES-BENZ 300SL GULLWING 1955 Pack 02 Handbuch

Agora Models

Agora Models Pack 07 Handbuch

Agora Models

Agora Models 1965 SHELBY COBRA 427 S/C Handbuch

Agora Models

Agora Models SHELBY COBRA 427 SEMI-COMPETITION 1965 Handbuch

Agora Models

Agora Models FDNY Fire Truck Handbuch

Agora Models

Agora Models SHELBY COBRA 427 SEMI-COMPETITION 1965 Handbuch

Agora Models

Agora Models Lamborghini MIURA Pack 11 Handbuch

Agora Models

Agora Models Jaguar E-Type Pack 10 Handbuch

Agora Models

Agora Models Shelby GT500 1967 Super Snake Handbuch

Agora Models

Agora Models LAMBORGHINI MIURA Pack 12 Handbuch

Agora Models

Agora Models SHELBY COBRA 427 SEMI-COMPETITION 1965 Handbuch

Agora Models

Agora Models STEVE MCQUEEN'S ICONIC PORSCHE 917KH Pack 02 Handbuch

Agora Models

Agora Models MERCEDES-BENZ W196R Handbuch

Agora Models

Agora Models RM 857 Handbuch

Agora Models

Agora Models MERSEDES-BENZ 300SL GULLWING 1955 Pack 03 Handbuch

Agora Models

Agora Models SHELBY COBRA 1965 Handbuch

Agora Models

Agora Models FDNY FIRE TRUCK TOWER LADDER 9 Handbuch

Agora Models

Agora Models LAMBORGHINI MIURA Pack 01 Handbuch

Agora Models

Agora Models Mercedes 300SL Gullwing 1955 Handbuch

Beliebte Motorisiertes Spielzeugauto Handbücher anderer Marken

Eduard

Eduard Humber Scout Car Mk.I exterior Bedienungsanleitung

Traxxas

Traxxas 4995X Bedienungsanleitung

Jamara

Jamara VW T1 Bus Bedienungsanleitung

REVELL

REVELL 68 CHEVY CHEVELLE SS 396 Bedienungsanleitung

Schumacher

Schumacher Pro Cat Bedienungsanleitung

Tamiya

Tamiya TT-01 TYPE E Bedienungsanleitung

Eduard

Eduard Krupp Protze 6x4 1/48 Bedienungsanleitung

New Bright

New Bright 61072UEP Bedienungsanleitung

Team Durango

Team Durango DEX410v5 Bedienungsanleitung

Jamara

Jamara Mercedes Actros Muldenkipper 2,4 GHz Bedienungsanleitung

PLAYMOBIL

PLAYMOBIL 9536 Bedienungsanleitung

Atomic

Atomic BZ3 Bedienungsanleitung

Aiyaplay

Aiyaplay 370-290V00 Bedienungsanleitung

Power Wheels

Power Wheels GRJ53 Bedienungsanleitung

ZEROTRIBE

ZEROTRIBE Zetricks ZT1144 Bedienungsanleitung

INJUSA

INJUSA 412 Bedienungsanleitung

Maverick

Maverick MSC-30BR-WP Bedienungsanleitung

Land of B.

Land of B. Rollin' Riders Bedienungsanleitung