Airspan AS4000 Leitfaden
605-0000-453 Issue 1.2dr Date 7/02/00
AS4000
Wireless Local Loop System
Demand Assignment
Access Concentrator
Installation and Commissioning
AS4000 Access Concentrator
Installation and Commissioning Preface
605-0000-453
Issue 1.2dr Date 7/02/00
Page 2 of 8
This Page Intentionally Blank
AS4000 Access Concentrator
Installation and Commissioning Preface
605-0000-453
Issue 1.2dr Date 7/02/00
Page 3 of 8
Notice
1. This manual is subject to revision.
2. All rights reserved.
3. Right of modification reserved.
4. This manual is supplied without liability for errors or omissions.
5. No part of this manual may be reproduced or used except as authorised by contract or other
written permission.
6. This equipment is conditioned by the requirement that no modifications will be made to the
equipment unless the changes or modifications are expressly approved by ACC
Communications.
7. Prerequisite skills: Personnel installing, commissioning, and maintaining the Airspan
products must have a basic knowledge of telephony and radio communications, and have
experience in installing, commissioning and maintaining telecommunications products.
ACC provides a range of comprehensive training courses specifically aimed at providing
operators/users of AS4000 products with the prerequisite skills to install, commission and
or maintain the product. The courses can be tailored to provide the level of training
required by the operator/user.
8. Airspanand Sitespanare Registered Trademarks of Airspan Communications
Corporation.
For additional information on Airspan Systems, please call your ACC Representative, or
contact ACC at: Cambridge House
Oxford Road
Uxbridge
Middlesex
UB8 1UN
Call (44) 1784 886700
AS4000 Access Concentrator
Installation and Commissioning Preface
605-0000-453
Issue 1.2dr Date 7/02/00
Page 4 of 8
This Page Intentionally Blank
AS4000 Access Concentrator
Installation and Commissioning Preface
605-0000-453
Issue 1.2dr Date 7/02/00
Page 5 of 8
Safety Instructions - Warnings and Cautions
SAFETY
1. Read and follow all warning notices and instructions marked on the product or included in
this manual
2. Do not allow anything to rest on any power cord and do not locate the product where
persons could step or walk on a power cord.
3. When installed in the final configuration, the product must comply with the applicable
Safety Standards and regulatory requirements of the country in which it is installed. If
necessary, consult with the appropriate regulatory agencies and inspection authorities to
ensure compliance.
4. No hazardous RF radiation is emitted from the equipment. Measured at the surface of
the CRU radome, when transmitting, the maximum total power radiated from the CRU is
0.a1% of the UK National Radiological Protection Board basic restriction per kg. of body
part.
WARNING - HAZARDOUS VOLTAGES
On AC installations, hazardous voltages exist. Use caution when verifying or working with
AC power. Remove metal jewellery that could come into contact with AC power.
On DC sections, short circuiting the low voltage, low impedance circuits can cause severe
arcing that may result in burns or eye damage. Remove rings, watches etc. to avoid shorting
DC circuits.
Electro-Static Discharge ESD
Electro-Static Discharge. Many circuits contain devices that are susceptible to damage from
high impedance voltage sources. To avoid such risks always follow anti-static procedures
where marked.
AS4000 Access Concentrator
Installation and Commissioning Preface
605-0000-453
Issue 1.2dr Date 7/02/00
Page 6 of 8
NOTE
AS4000 products do not contain hazardous substances (as defined in UK ‘Control of
Substances Hazardous to Health Regulations 1989’, and the ‘Dangerous Substances
Regulations 1990’). At the end of any Airspan product’s life cycle, the customer should
consult with Airspan to ensure that the product is disposed of in conformance with the
relevant regulatory requirements
The Symbol on an Airspan product signifies that it has been certified according to the
EMC directive 89/336/EEC. The product fulfils the requirements according to the following
standards:
EN50082-1 Immunity.
EN55022 Group 1 Class A for the Central Terminal Emissions.
EN55022 Group 1 Class B for the Subscriber Terminal Emissions.
NOTE
The Subscriber Terminal equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
AS4000 Access Concentrator
Installation and Commissioning Preface
605-0000-453
Issue 1.2dr Date 7/02/00
Page 7 of 8
User Response Form
Mail: Airspan Communications Limited Fax: (44) 01895-467182
Cambridge House
Oxford Road
Uxbridge
Middlesex
UB8 1UN
Document Rating Excellent Good Average Below Average Poor
Accuracy / Completeness qqqqq
Clarity / Organisation qqqqq
Figures qqqqq
Table of Contents/Index qqqqq
The nature of this response is Addition qDeletion qCorrection q
Please enter details of response below (include precise reference to Section, Page, Paragraph)
Please complete the following for acknowledgement/response:
Name: ........................................ Address ..........................................
Company ........................................ ..........................................
Job Title ........................................ ..........................................
Department ........................................ ..........................................
Telephone ........................................ ..........................................
Thank you for your co-operation and assistance.
AS4000 Access Concentrator
Installation and Commissioning Preface
605-0000-453
Issue 1.2dr Date 7/02/00
Page 8 of 8
This Page Intentionally Blank
AS4000 Access Concentrator
Installation and Commissioning ICL 001
605-0000-453
Issue 1.2dr Date 7/02/00
Page 1 of 2 © Copyright Airspan Communications Corporation 2000
ISSUE CONTROL LIST
Title Issue Date Issue Details
Title Page 1.2 August 2000
ICL-001 1.2 August 2000
IXL-001 1.2 August 2000
GSI-001 1.2 August 2000
GSI-002 1.2 August 2000
GSI-003 1.2 August 2000
DLP-001 1.2 August 2000
DLP-002 1.2 August 2000
DLP-003 1.2 August 2000
DLP-004 1.2 August 2000
DLP-005 1.2 August 2000
DLP-006 1.2 August 2000
DLP-007 1.2 August 2000
DLP-008 1.2 August 2000
DLP-009 1.2 August 2000
DLP-010 1.2 August 2000
DLP-011 1.2 August 2000
Appendix 1 1.2 April 2000
Appendix 2 1.2 April 2000
Appendix 3 1.2 April 2000
Appendix 4 1.2 April 2000
AS4000 Access Concentrator
Installation and Commissioning ICL 001
605-0000-453
Issue 1.2dr Date 7/02/00
Page 2 of 2
CHANGE TYPE/DATE PURPOSE PAGES AFFECTED
Draft Issue #, Month
Year
Andere Handbücher für AS4000
6
Inhaltsverzeichnis
Andere Airspan Netzwerk-Hardware Handbücher
Airspan
Airspan AirSpeed 1000A Bedienungsanleitung
Airspan
Airspan AirSpeed 1030 B48 Bedienungsanleitung
Airspan
Airspan AS MAX EasyST 4.9 Handbuch
Airspan
Airspan AirHarmony-4000 Bedienungsanleitung
Airspan
Airspan AirSpeed-1200 eNB Bedienungs- und Wartungsanleitung
Airspan
Airspan AIRSTAR 1900 Bedienungsanleitung
Airspan
Airspan AirHarmony-1000 Bedienungsanleitung
Airspan
Airspan AS3010 Handbuch
Airspan
Airspan AirSynergy3 Bedienungsanleitung
Airspan
Airspan AirSpeed 1050 B3 Bedienungsanleitung
Beliebte Netzwerk-Hardware Handbücher anderer Marken
Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung
B&B Electronics
B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung
Yudor
Yudor YDS-16 Bedienungsanleitung
D-Link
D-Link ShareCenter DNS-320L Bedienungsanleitung
Samsung
Samsung ES1642dc Gebrauchsanweisung
Honeywell Home
Honeywell Home LTEM-PV Montageanleitung
