more than one impact
Sensitivity Sensitivity level of the shock sensor
Ignore simple impact If active, the detector ignores single hit
Tilt sensor If active, sensor will detect tilt
Tilt Selecting the normal angle of the sensor. Above
this limit, the sensor detects an alarm
Tilt alarm delay The number of seconds from the moment the
sensor is tilted to the alarm
Always active When turned on, the detector is always armed
External Contact Type Selecting the type of
Time before alarm, sec
(available for roller shutter motion detector
only)
The time in seconds during which a given
number of impulses should be counted. This
time is counted after the rst impulse of the
detector.
Impulses before alarm
(available for roller shutter motion detector
only)
Number of detector impulses required to raise
an alarm
Alert with a siren if opening detected If active, and are
activated when opening detected
Alert with a siren if an external contact is open If active, HomeSiren and StreetSiren are
activated during an external detector alarm
Alert with a siren if shock is detected If active, HomeSiren and StreetSiren are
activated during a shock alarm
Alert with a siren if tilt is detected If active, HomeSiren and StreetSiren are
activated during a tilt alarm
Jeweller Signal Strength Test Switches the detector to the signal strength test
mode
Detection Zone Test Switches the detector to the detection area test
Attenuation test
Switches the detector to the signal fade test
mode (available in detectors with rmware
version 3.50 and later)
Temporary Deactivation Allows the user to disconnect the device
without removing it from the system.
Two options are available:
external wired
detector
HomeSiren StreetSiren
