CA210-T Quick Guide
2-EN
STARTING UP THE SYSTEM
1. Turn on your in-car audio system.
2. Switch the car radio to FM 87.6MHz, which is the same as CA210-T default FM frequency setting.
3. Turn on the CA210-T car adapter and the screen will show
《
DABradio
》
.
4. For the first time, it is necessary to perform a Scan function before using the CA210-T DAB adapter.
Note: 1. CA210-T needs to operate with an RDS car radio in order to properly display the relevant
system message of CA210-T via the in-car radio display.
2. CA210-T will be turned off to stay in sleep mode automatically if there is no any key of the
remote controller being pressed within 4 hours. Pressing any key of the remote controller will
revert the system to the last operation before shut down.
SYSTEM OPERATION
To Scan the DAB Services
There are two Scan types available in the CA210-T: Quick and Full.
When a Quick scan is performed, the CA210-T will scan only the part of band III (from channel 10A to
channel 13F). In a Full scan, the CA210-T will scan the entire band III from channel 5A to channel 13F.
1. Press SCAN and then press
▲
or
▼
to select a desired Scan type.
2. Press ENTER to begin scanning for DAB services in the selected channel range.
Note: 1. During Scan DAB Services, the screen will show
《
FFF N
》
. FFF represents which channel
is currently being scanned and N indicates how many services have been detected so far.
2.When the Scan DAB Services process is finished, the CA210-T will revert to playing the last
DAB program. If the DAB Service List is empty before scanning, the CA210-T will tune in the
first service of the new DAB Service List resulted from this DAB Scan. If the DAB Service List
is empty before scanning, and there are no services detected by DAB Scan, the screen will
show
《
Empty
》
.
3.When the Scan operation is in process, you can press SCAN at any time to stop Scan
function and revert to listening to the currently selected station. All keys except SCAN are
disabled when Scan DAB Services is in progress
To Listen to the DAB Services
1. Quick Tune: Press I◄◄ or ►►Ito quickly move from one page to another in alphabetical order.
2. Step Tune: Press
▲
or
▼
to select the desired DAB service.
3. Press ENTER to start tuning the service selected. If you do not press ENTER within 3 seconds, the
system will revert to the original screen automatically. The screen will show
《
Tuning
》
.
Note: 1.When the DAB service you selected is not available, the screen will show
《
Unavail
》
.
2.When the signal strength of the DAB service you selected is too weak, the screen will show
《
PoorSig.
》
.
To Show the Signal Strength
1. Press ENTER when you are listening to a DAB service, caused the screen to show
《
Sig xx%
》
. This
indicates the signal strength in percentage terms of the current service.
2. Press ENTER again to revert to the normal DAB service screen.
To Set User Presets
The CA210-T provides individual memory settings for up to three Users. Each user can set his/her own
Memory Presets of DAB services and has his/her own Latest Service list based on the listening history
of each User.
1. Press
▼
USER
▼
to select a particular User.
2. The screen will show
《
User 1
》
,
《
User 2
》
and
《
User 3
》
in sequence each time you press
▼
USER
▼
. Stop when the desired User number is displayed. The system will revert to the original station
name screen display after 3 seconds.
Note: The default setting is User 1.
