•3G Modem Push Button: Briefly push the button down with the tip of a ballpoint
pen to toggle the power state of the 3G modem. You must use this button to
power off the modem when regulatory requirements apply, such as when the
airplane you have boarded is taking off or landing.
•Master Power Switch: Using the tip of a paper clip, slide the switch towards the
connector end of the card to shutdown the card and towards the antenna end of
the card to restart it. You can power-cycle the card (shutdown/restart) if the
card stops working. This switch is only accessible when the card is not plugged
into the laptop.
•SD Card Slot: The SD card slot is not operational in this release of the
OmniAccess 3500 NLG card. Do not insert an SD card in the slot.
Before You Begin
Before you begin your installation, make sure that:
•The Client for Microsoft Networks is enabled in your laptop.
•Your laptop is already a member of the Windows NT domain that the enterprise
designates for OmniAccess 3500 NLG end users. When you log into your laptop
before beginning installation, use your Windows NT credentials for that domain.
•No IPsec VPN client is installed in your laptop (if there are any, they must be
uninstalled).
•The Master Power Switch of your OmniAccess 3500 NLG card is set to the ON
position (towards the antenna end of the card).
You must obtain the following information from your administrator to download the
client software and complete the installation of your card:
•Software distribution key for the Alcatel-Lucent software download website (or
alternate instructions if your enterprise adopts a proprietary method for
distribution of the OmniAccess 3500 NLG client software).
•Certificate file for the OmniAccess 3500 NLG enterprise gateway.
•Certificate file for the user.
•The private key associated with the user’s certificate file.
Save the certificate files to a directory of your choice on your laptop’s hard disk or to
a mounted USB drive before beginning installation.
You will perform the following procedures to complete the installation of your card:
•Download and install the client software into your laptop.
•Insert your card into the laptop.
•Activate the card.
This document explains how to perform these procedures.
