Alfalaval M200 Bedienungsanleitung

Alfa Laval M Gear

Gear Pump

BRITISH ENGLISH

3300-0000

Lit. Code 200009584-1-EN-GB Instruction Manual

Published by

Alfa Laval Kolding A/S

Albuen 31

DK-6000 Kolding, Denmark

+45 79 32 22 00

The original instructions are in English

This document and its contents are subject to copyrights and other intellectual property rights owned by Alfa Laval AB (publ) or any of its affiliates (jointly “Alfa Laval”). No part of this

document may be copied, re-produced or transmitted in any form or by any means, or for any purpose, without Alfa Laval’s prior express written permission. Information and services

provided in this document are made as a benefit and service to the user, and no representations or warranties are made about the accuracy or suitability of this information and these

services for any purpose. All rights are reserved.

Contents

1 Declarations of Conformity.................................................................................5

1.1 EU Declaration of Conformity....................................................................................5

1.2 UK Declaration of Conformity....................................................................................6

2 Safety............................................................................................................................... 7

2.1 Safety Instructions and Warnings..............................................................................7

2.2 Warning Signs in Text.............................................................................................. 11

2.3 Requirements of Personnel.....................................................................................12

2.4 Recycling Information..............................................................................................13

3 Introduction.................................................................................................................15

3.1 Principles.................................................................................................................15

4 Installation................................................................................................................... 17

4.1 Unpacking and Handling......................................................................................... 17

5 Operation..................................................................................................................... 19

5.1 Commissioning and Start Up...................................................................................19

5.2 Cleaning.................................................................................................................. 19

6 Maintenance.............................................................................................................. 21

6.1 Disassembly............................................................................................................ 22

6.2 Assembly.................................................................................................................23

6.2.1 Assemble Drive Shaft Assembly................................................................23

6.2.2 Assemble Pump.........................................................................................25

6.3 Troubleshooting.......................................................................................................27

7 Technical Data..........................................................................................................29

7.1 Weights....................................................................................................................29

7.2 Dimensions..............................................................................................................30

8 Spare Parts.................................................................................................................31

8.1 Ordering Spare Parts...............................................................................................31

8.2 Alfa Laval Service....................................................................................................31

9 Parts List and Exploded View........................................................................ 33

This page is intentionally left blank.

1 Declarations of Conformity

1.1 EU Declaration of Conformity

The Designated Company

Alfa Laval Kolding A/S, Albuen 31, DK-6000 Kolding, Denmark, +45 79 32 22 00

Company name, address and phone number

Hereby declare that

Pump

Designation

M200; M210; M220

Type

Serial number from E10.000 to E1.000.000

Serial number from AAX000000001 to AAX999999999

is in conformity with the following directives with amendments:

• Machinery Directive 2006/42/EC

• RoHS Directive 2011/65/EU and amendments

The person authorised to compile the technical file is the signer of this document.

Global Product Quality Manager Lars Kruse Andersen

Title Name

Kolding, Denmark 2023–06–19

Place Date (YYYY-MM-DD) Signature

DoC Revison_01_062023

200009584-1-EN-GB 5

1.2 UK Declaration of Conformity

The Designated Company

Alfa Laval Kolding A/S, Albuen 31, DK-6000 Kolding, Denmark, +45 79 32 22 00

Company name, address and phone number

Hereby declare that

Pump

Designation

M200; M210; M220

Type

Serial number from E10.000 to E1.000.000

Serial number from AAX000000001 to AAX999999999

is in conformity with the following directives with amendments:

• The Supply of Machinery (Safety) Regulations 2008

• The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regu-

lations 2012

Signed on behalf of: Alfa Laval Kolding A/S

Global Product Quality Manager Lars Kruse Andersen

Title Name

Kolding, Denmark 2023–06–19

Place Date (YYYY-MM-DD) Signature

DoC Revison_01_062023

200009584-1-EN-GB6

1 Declarations of ConformityEN

2 Safety

Read this first

This manual is designed for operators and service engineers working with the supplied

Alfa Laval product.

Operators must read and understand the “Safety, Installation and Operating Instruc-

tions” of the respective product before carrying out any work or before you put the sup-

plied product into service!

Not following the instructions can result in serious accidents.

This documentation describes the authorized way to use the supplied product.

Alfa Laval will take no responsibility for injury or damage if the equipment is used in any

other way.

This Instruction manual is designed to provide the user with the information to perform

tasks safely for all phases in the lifetime of the supplied product.

The user shall always read the safety section first. Hereafter the user can skip to the rele-

vant section for the task to be carried out or for the information needed.

Always read the technical data thoroughly (see Technical Data on page 29).

This is the complete manual for the supplied product.

2.1 Safety Instructions and Warnings

Safety Signs

Use eye protection - safety glasses.

Use protective hand wear - safety gloves.

Wear protective equipment - safety helmet.

Use ear protection in noisy environments - noise protector.

Wear protective equipment - safety shoes.

Corrosive substance.

Hot surface and burning danger.

Cutting danger

200009584-1-EN-GB 7

Safety Signs

Dangerous electrical voltage

Transportation with forklift truck or other industrial vehicles if heavy.

General Safety Precautions

Installation

If the local safety regulations prescribe that the installation has to be inspected and ap-

proved by responsible authorities before the pump is put into service, consult with such

authorities before installing the equipment and have the projected installation approved by

them.

Never start in the wrong direction of rotation with liquid in the pump.

Never put your hands or fingers inside the port connections or anywhere close to rotating

shafts.

Always have the pump electrically connected by authorized personnel. (See the motor in-

struction supplied with the drive unit)

Alfa Laval recommends the supply disconnecting device shall be in accordance with EN

60204-1.

Operation

Never stand on the pump or pipelines.

Never run the pump with either the suction side or the pressure side blocked.

Never put your hands or fingers inside the port connections or anywhere close to rotating

parts.

Never run the pump unless fully assembled and all guards are securely fitted, i.e. pump

head must not be removed from gearcase. !

Always ensure any guards are securely fitting and in good condition.

Never touch the pump or the pipelines when pumping hot liquids or when sterilising.

In certain operating conditions external surfaces of the pump and/or ancillary equipment

may exceed 80° C. As such users should avoid touching the pump and/or ancillary equip-

ment during operation taking precautions if it is unavoidable to do so.

Only handle toxic and acidic liquids in accordance with the manufacturers instructions and

recommendations.

200009584-1-EN-GB8

2 SafetyEN

Maintenance

Always ensure adequate Personal Protective Equipment (PPE) is worn during any main-

tenance activities.

Never service the pump when it is hot.

Never service the pump when the pump and pipelines are pressurised.

Never put your hands or fingers inside the port connections or anywhere close to rotating

parts.

Always comply with any local health and safety regulations when installing and operating

the pump.

Any hazardous and/or hot, drained or leaked, liquid shall be disposed in compliance with

any local health and safety regulations. If requested at the time of quotation, the equip-

ment can be supplied with a means of safe containment of any hazardous and/or hot,

drained or leaked liquid (Drip Pan).

Always ensure the power supply is disconnected (in an off position) and is locked out to

prevent accidental operation. Please refer to any motor/geared motor and coupling operat-

ing manuals supplied with the unit for maintenance instructions.

Always ensure pump and ancillary equipment has been allowed to cool before touching.

Transportation and Lifting

Never lift or elevate in any way other than described in this manual

Always drain the pump head and accessories of any liquid

Always ensure that no leakage of lubricants can occur

Always transport the pump in it’s upright position

Always ensure that the unit is securely fixed during transportation

Always use original packaging or similar during transportation

Always use a suitable transport device i.e. forklift truck or pallet lifter

Storage

Ideally, as a guide Alfa Laval recommend:

• Store supplied product as supplied in original packaging

• Port opening should be protected against any ingress

• Bare steel (not stainless) should be lightly oiled/greased

• Store in a clean, dry place without direct sunlight or UV light

• Temperature range -5 to 40° C

• Relative humidity less than 60%

• No exposure to corrosive substances (also air contained)

Noise

Under certain operating conditions pumps and/or drives and/or the systems within which

they are installed can produce sound pressure levels in excess of 80 dB[A].

When necessary, protection against noise should be taken.

200009584-1-EN-GB 9

Safety 2 EN

Safety check

A visual inspection of any protective device (shield, guard, cover or other) on the supplied

product shall be carried out at least every 12 months. If the protective device is lost or

damaged, especially when this leads to deterioration of safety performance, it shall be re-

placed. The fixing of the protective device should only be replaced with fixings of the same

or an equivalent type.

Inspection acceptance criteria:

• It should not be possible to reach moving parts originally protected by a protective de-

vice

• The protective device must be securely mounted

• Ensure that screws for the protective device are securely tightened

Procedure in case of non-acceptance:

• Fix and/or replace the protective device

How to contact Alfa Laval

Contact details for all countries are continually updated on our website.

Please visit www.alfalaval.com to access the information directly.

200009584-1-EN-GB

2 SafetyEN

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Alfalaval Wasserpumpe Handbücher

Alfalaval

Alfalaval LKH Evap ESE01861-EN4 Bedienungsanleitung

Alfalaval

Alfalaval MR-300 Bedienungsanleitung

Alfalaval

Alfalaval LKH-112 Bedienungsanleitung

Alfalaval

Alfalaval LKHP Bedienungsanleitung

Alfalaval

Alfalaval CSI LKH UltraPure Series Bedienungsanleitung

Alfalaval

Alfalaval SX Series Bedienungsanleitung

Alfalaval

Alfalaval MR-185S Bedienungsanleitung

Alfalaval

Alfalaval LKH Bedienungsanleitung

Alfalaval

Alfalaval LKH Prime UltraPure Bedienungsanleitung

Alfalaval

Alfalaval FM-OS Bedienungsanleitung

Alfalaval

Alfalaval OptiLobe 22 Bedienungsanleitung

Alfalaval

Alfalaval LKH UltraPure Bedienungsanleitung

Alfalaval

Alfalaval SRU series Bedienungsanleitung

Alfalaval

Alfalaval LKH-5 Bedienungsanleitung

Alfalaval

Alfalaval LKHevap-10 Bedienungsanleitung

Alfalaval

Alfalaval N Series Bedienungsanleitung

Alfalaval

Alfalaval SolidC Series Bedienungsanleitung

Alfalaval

Alfalaval SolidC Series Bedienungsanleitung

Alfalaval

Alfalaval SRU series Bedienungsanleitung

Alfalaval

Alfalaval LKH Prime UltraPure Bedienungsanleitung

Alfalaval

Alfalaval SRU series Bedienungsanleitung

Alfalaval

Alfalaval LKHex Bedienungsanleitung

Alfalaval

Alfalaval LKH Series Bedienungsanleitung

Alfalaval

Alfalaval Tri-Clover CL Series Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

moyno

moyno 2000 CC Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung