WALL MOUNT RE 2201, RE202, RE203 p
I 222nstruction guide for RE 01, RE 02, RE 03 series wall mount remotes
4. SINGLE CONTROL
5. GROUP CONTROL (LCD)
6. DELETE GROUP CONTROL
7. LCD FOUR CHANNEL TIMER REMOTE
Select a channel by pressing K1/K3 as the current channel, then you can control this channel by pressing a UP/STOP/DOWN button.
01.Time ettingS
03. iming FunctionClose T
In the initial page, press K2 to enter timing setting page, there is a timing clock on the upper left corner.
You can respectively set 8 opening time points and 8 closing time points, in total 16 points.
Press K2 to cycle among 16 time points. Press K3 to choose the output channels which you want (single channel or 4 channels)
02.Timin ettingg S (se ifferent time points to make the motor close or open)t d
18
~
Short press K1/K3 to choose channels
into your group, for example channel
8 as the picture shows.
Short press K1/K3 to choose channels
out 6your group, for example channel
as the picture shows.
Once the hour setting is finished, press
K1 again to adjust minute, the minute
figure will shine. Press UP/DOWN button
to adjust the figure.
Press K2 again to select one point
among 16 timing points.
Press K2 again to select one point
that needs to be closed.
Press STOP button to exit the setting.
Short press K2 to confirm, same method
for other channels.
Short press K2 to confirm, same method
for other channels.
Once the minute setting is finished, press
K1 again to adjust weekday, the weekday
figure will shine. Press UP/DOWN button
to adjust the weekday.
Press K3 to choose your wanted channel
(single channel or 4 channels).
Press K3 until above display appears,
which means the point has closed.
Press K3 again to retrieve this point.
Press UP/STOP/DOWN buttons
to exit the setting.
Press UP/STOP/DOWN buttons
to exit the setting.
After setting, press STOP button to
exit and go back to the initial page.
Press K1 to set time (in the same
way of Time Setting above).
After setting, press STOP button to
exit and go back to the initial page.
Long press K2 for 2 to enter Group Control,s
the current channel on the upper left corner
of the screen will shine.
Long press K2 for 2 to enter Group Controls
the current channel on the upper leftstate,
corner of the screen will shine.
Press K1 button to enter hour setting
page, now the hour figure will shine.
Press UP/DOWN button to adjust
the hour figure.
Press K2 to enter timing setting page.
Press K2 to enter timing setting page.
After one time point is set, press K2 again
to select other time points to set time.
M
Short press K2 button to choose group contro r ingle controll o s S
Note: inwhether or mode, the current channel is always selected.
MS
ALPHA SUPPORT PHONE (02) 4355 4775
