Altec Lansing SHOCKWAVE 100 Bedienungsanleitung

IMT7001

Quick Start Guide

IMT7001

Adapter

AUX. Audio cable

Wired Mic.x1

AUX: For line level or headphone output

from audio sources

USB OUT: For charging your mobile devices

DC IN: Plug for power adapter

MIC2: For 2nd wired microphone

MIC1:

For 1st wired microphone

Descriptions about the various ports on the speaker

INPUT/OUTPUT PORTS

Play/pause

Previous song

or FM station

Next song or FM station Bass-: decrease bass

Bass+:increase bass

Press and hold button 3 seconds to

power on or power off speaker

Select mode (FM or AUX)

Select Bluetooth mode

Light modes

VOLUME-: decrease volume

VOLUME+: increase volume

Brief introduction to buttons on top panel

Press MIC1 and MIC2 volume buttons

to increase or decrease the volume of

both microphones

MIC Volume Control：Power Button：

(also used for stereo pairing see later section)

(BT mode only)

AL Shockwave 100

Bluetooth Connection

Stereo pairing (two speakers) :

1. Have one speaker turned on, paired and playing music. It will serve

as the HOST (the Primary speaker). The display will be showing ‘Bt’

(Pair by pressing the BT/PAIR button, BT ashes on the display then

goes solid when paired).

2. Power on an additional compatible speaker. It will serve as a Secondary speaker.

3. Press and hold the BT/PAIR button on the Primary speaker for approximately

two seconds or until the display changes from solid ‘Bt’ to ashing ‘HOSt’.

4. Quickly tap the BT/PAIR button on the Secondary speaker. The display should

change from ashing ‘Bt’ (normal pairing) to ashing ‘St PAIr’ (stereo pairing).

5.The speakers will connect and then both displays will show ‘Bt’.

The speakers will now play the same music from the same audio

source, one will play Left and one will play Right.

Go to the Bluetooth settings menu on your phone. Make sure

that Bluetooth is turned on. Connect to the device listed

as “AL Shockwave 100”

Primary Speaker Secondary Speaker

LIGHTING CONTROL

Briey press the LIGHTS button for lighting control:

(Noted: Cone’s light will be displayed while unit is playing music)

LED 1: Side lights scrolling multi-color, cones’ color change with the beat;

press and hold to change as single color scrolls one by one;

Length of Audio cable(stereo-to-stereo):90cm

Length of adaptor:110cm

Length of wired micphone’s cable:285cm

L267xW238xH504(mm)

43W (RMS)

150W (Peak) Total

5.25” x2 + 2” x1

DC input:15V 1.5A

LED 2:

Sides & cones follow music and change color automatically every 3 seconds;

LED 3: Side lighting one color, cones follow music to ash the same color,

press and hold for 3 seconds to change to the other color;

LED 4: Sides o, just cones ash into one color,

press and hold for 3 seconds to change to the other color;

LED 5: Sides do a bar graph from the middle in one color and cones ash

the same color, press and hold for 3 seconds to change to the other color;

LED 6:

Sides and cones slowly change colors automatically every 3 seconds,

press and hold to turn cone lights o;

LED 7: Sides ash one color, cones no light,

press and hold for 3 seconds to change to the other color;

LED 8: Sides do a multi-color bar graph from the middle, cones o;

LED 9: Sides fade between colors, cones o;

OFF : Lighting o.

Supplier's Declaration of Conformity

47 CFR § 2.1077 Compliance Information

Unique Identier

Trade Name: Altec Lansing

Model No.: IMT7001

Responsible Party – U.S. Contact Information

US Company Name: SAKAR INTERNATIONAL INC.

Address: Edison, NJ 08817

Telephone number or internet contact information: 855-292-4087

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated

with minimum distance 20cm between the radiator and your body.

RF Exposure Compliance

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions – All the safety and operating instructions should be

read before this product is operated.

2.Keep these instructions – The safety and operating instructions should be

retained for future reference.

3.Heed all warnings – All warnings on the appliance and in the operating

instructions should be adhered to.

Follow all instructions – All operating and use instructions should be followed.

5.Do not use this apparatus near water – The appliance should not be used

near water or moisture – for example, in a wet basement or near a swimming

pool, and the like.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the

manufacture’s instructions.

Do not install near any heat sources such as radiators, heat registers, stoves,

or other apparatus (including amplifiers) that produce heat.

Do not defeat the safety purpose of the polarized or grounding plug. A polarized

plug has two blades with one wider than the other. A grounding plug has two

blades and a third grounding prong. The wide blade or the third prong is

provided for your safety. If the provided plug does not fit into your outlet,

consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at the

plugs, convenience receptacles, and at the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus. When a cart or rack is used, use

caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug the apparatus during lightning storms or when unused for long

periods of time.

14.Refer all servicing to qualified personnel. Servicing is required when the

apparatus has been damaged in any way, such as power supply cord or plug

is damaged, liquid has been spilled or objects have fallen into the apparatus

has been exposed to rain or moisture, does not operate normally, or has been

dropped.

15.CAUTION: These servicing instructions are for use by qualified service

personnel only. To reduce the risk of electric shock, do not perform any servicing

other than that contained in the operating instructions unless you are qualified

to do so.

16.WARNING：To reduce the risk of fire or electric shock, do not expose this

apparatus to rain or moisture. The apparatus shall not be exposed to dripping

or splashing and that objects filled with liquids, such as vases, shall not be

placed on apparatus.

17.

WARNING：For the terminals marked with symbol of “ ” may be of sufficient

magnitude to constitute a risk of electric shock. The external wiring connected

to the terminals requires installation by an instructed person or the used of

ready-made leads or cords.

18. This equipment is a Class II or double insulated electrical appliance. It

has been designed in such a way that it does not require a safety connection

to electrical earth.

Andere Handbücher für SHOCKWAVE 100

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Altec Lansing Sprecher Handbücher

Altec Lansing

Altec Lansing 409-8D CEILING SPEAKER Bedienungsanleitung

Altec Lansing

Altec Lansing 307 CEILING SPEAKERS Bedienungsanleitung

Altec Lansing

Altec Lansing AL-SND325F Bedienungsanleitung

Altec Lansing

Altec Lansing inMotion SoundBlade Bedienungsanleitung

Altec Lansing

Altec Lansing Jacket H20 Bedienungsanleitung

Altec Lansing

Altec Lansing Duplex DTS945A-F Bedienungsanleitung

Altec Lansing

Altec Lansing 807-8A HF DRIVERS Bedienungsanleitung

Altec Lansing

Altec Lansing IML 237 Bedienungsanleitung

Altec Lansing

Altec Lansing Shockwave 200 Bedienungsanleitung

Altec Lansing

Altec Lansing Expressionist BASS FX3022 Montageanleitung

Altec Lansing

Altec Lansing 288C HF DRIVER Bedienungsanleitung

Altec Lansing

Altec Lansing CD308-16T Bedienungsanleitung

Altec Lansing

Altec Lansing DTS942A-F SPEAKER SYSTEM Bedienungsanleitung

Altec Lansing

Altec Lansing 515-8LF LF SPEAKER Bedienungsanleitung

Altec Lansing

Altec Lansing 405-8H Bedienungsanleitung

Altec Lansing

Altec Lansing EXPRESSIONIST CLASSIC - Bedienungsanleitung

Altec Lansing

Altec Lansing inMotion SoundBlade Bedienungsanleitung

Altec Lansing

Altec Lansing 515-8LFE LF SPEAKER Bedienungsanleitung

Altec Lansing

Altec Lansing 75-BK SPEAKER SYSTEM Bedienungsanleitung

Altec Lansing

Altec Lansing 299-16A HF DRIVER Bedienungsanleitung

Altec Lansing

Altec Lansing 808-16A HF DRIVERS Bedienungsanleitung

Altec Lansing

Altec Lansing 3127 LF SPEAKER Bedienungsanleitung

Altec Lansing

Altec Lansing inMotion IM310 Bedienungsanleitung

Altec Lansing

Altec Lansing 406B LF SPEAKER Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung