Alto ELVIS 15.2XL Bedienungsanleitung

User's Manual

www.altoproaudio.com

Version 1.0 Feb. 2007

LTO

English

ELVIS 15.2XL Series

SAFETY RELATED SYMBOLS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol, wherever used, alerts

you to the presence of un-insulated

and dangerous voltages within the

product enclosure. These are voltages

that may be sufficient to constitute the

risk of electric shock or death.

WARNING

Describes precautions that should be

observed to prevent the possibility of

death or injury to the user.

Describes precautions that should be

observed to prevent damage to the

product.

CAUTION

Operating Conditions

Always install in accordance with the

manufacturer's instructions.

This symbol, wherever used, alerts

you to important operating and ma-

intenance instructions. Please read.

Protective Ground Terminal

AC mains (Alternating Current)

Hazardous Live Terminal

ON:

OFF:

Denotes the product is turned on.

Denotes the product is turned off.

WARNING

Power Supply

Ensure that the mains source voltage (AC

outlet) matches the voltage rating of the

product. Failure to do so could result in

damage to the product and possibly the user.

External Connection

Do not Remove any Covers

Fuse

To prevent fire and damage to the

product, use only the recommended

fuse type as indicated in this manual.

Do not short-circuit the fuse holder.

Before replacing the fuse, make sure

that the product is OFF and disconnected

from the AC outlet.

Always use proper ready-made insulated

mains cabling (power cord). Failure to do

so could result in shock/death or fire. If

in doubt, seek advice, from a registered

electrician.

Within the product are areas where high

voltages may present. To reduce the risk

of electric shock do not remove any

covers unless the AC mains power cord

is removed.

Covers should be removed by qualified

service personnel only.

No user serviceable parts inside.

Unplug the product before electrical storms

occur and when unused for long periods of

time to reduce the risk of electric shock or

fire.

Protective Ground

Before turning the product ON, make sure

that it is connected to Ground. This is to

prevent the risk of electric shock.

Never cut internal or external Ground wires.

Likewise, never remove Ground wiring

from the Protective Ground Terminal.

Disposing of this product should

not be placed in municipal waste

and should be separate collection.

Do not install this product near any direct

heat source.

Do not block areas of ventilation. Failure

to do so could result in fire.

Keep product away from naked flames.

IMPORTANT SAFETY INSTRUCTIONS

Read these instructions

Follow all instructions

Keep these instructions. Do not discard.

Heed all warnings.

Only use attachments/accessories

specified by the manufacturer.

Power Cord and Plug

Do not tamper with the power cord or plug.

These are designed for your safety.

Do not remove Ground connections!

If the plug does not fit your AC outlet seek

advice from a qualified electrician.

Protect the power cord and plug from any

physical stress to avoid risk of electric shock.

Do not place heavy objects on the power

cord. This could cause electric shock or fire.

Cleaning

When required, either blow off dust from

the product or use a dry cloth.

Do not use any solvents such as Benzol

or Alcohol.

For safety, keep product clean and free

from dust.

Servicing

Refer all servicing to qualified service

personnel only.

Do not perform any servicing other than

those instructions contained within the

User's Manual.

To avoid the risk of electric shock and

damage, do not subject this product to

any liquid/rain or moisture. Do not use this

product when in close proximity to water.

TABLE OF CONTENT

1. QUICK START - PASSIVE/ SPEAKER CABINET........................4ACTIVE

-. For Passive Full-range Speakers

2. CONNECTION PLATE .....................................................................6.........

-. PASSIVE FULL-RANGE Speaker for ELVIS 15.2XL

-. Active FULL-RANGE Speaker for ELVIS15.2XLA

4. TECHNICAL SPECIFICATIONS..................................................................9

-. For Active Full-range Speakers

3. WIRE CONNECTIONS...............................................................................8

-. For Passive Full-range Speakers

-. For Active Full-range Speakers

QUICK START

Elvis Passive Full-range Speakers

Stereo

Power Amplifier

speaker cable

Left

Main Mix

Output

Right

Main Mix

Output

Mixer

3). Turn on your mixer first, then the stereo power amplifier.

4). Turn up the volume controls of your amplifier to about 70%.

2). Complete other connections as illustrated.

1). Connect one side of the speaker cable to the Output CHA/CHB or Binding Post of

your stereo power amplifier and the other side to the Input socket of your speaker

cabinet.

5). Use PFL function to get the proper input level for the mixer, and adjust the Main Mix

control to manipulate the output level.Level

6). After using, turn off your stereo power amplifier first, then the mixer.

speaker cable

1. QUICK START - PASSIVE /ACTIVE SPEAKER CABINET

-. For Passive Full-range Speakers

Make all initial connections with all the equipment powered off, and ensure that all

main volume controls are turned completelythe down.

3). Turn on your mixer first, then the active speaker cabinets.

-. For Active Full-range Speakers

1). Connect one side of the signal cable at your audio mixer in to Output Left /Right

(with Stereo-Jack or XLR) and the other side of the cable in to the Line Input (COMBO)

of your active speaker cabinet (with Stereo-Jack or XLR).

2). Connect the power cord to mains.

5). Use PFL function to get the proper input level for the mixer, and adjust the Main Mix

Level control to manipulate the output level.

4). Turn up the volume control of the active speaker cabinets.

6). After using, turn off your active speaker cabinets first, then the mixer.

QUICK START

Elvis Active Full-range Speakers

speaker cable

Left

Main Mix

Output

Right

Main Mix

Output

Mixer

speaker cable

THRU

LINK

INPUT

SOUND REINFORCEMENT SPEAKER SYSTEM

DESIGNED AND DEVELOPMENT IN ITALY

CONTINUE - 500 Watts

POWER HANDLING:

PEAK - 1K Watts

IMPEDANCE:

4 ohms nominal

SERIAL

MODEL

ELVIS 15.2XL

LTO

2. CONNECTION PLATE

- PASSIVE FULL-RANGE Speaker for ELVIS 15.2XL

(1) INPUT: Receive the power coming from an external power amplifier (SPK +1/-1

connected; +2/-2 not connected).

(2) THRU: Direct LINK for connect in parallel a second speaker cabinet (SPK +1/-1

connected; +2/-2 not connected).

-. ACTIVE FULL- RANGE Speaker for ELVIS15.2XLA

(1) Bi-polar main power switch

(2) Input AC power socket with main fuse

(3)

(4)

(5)

(6)

(7)

(8) SIGNAL LIMIT

Fan

VOLUME main power amplifier control

LINE OUT at + 4dB on XLR connector

LINE IN at + 4dB on COMBO connector

Ground Swicth

POWER, Green LED, indicate ON status

, Red LED, indicate ON status

(9)

AC INPUT

BAL

LINK

INPUT

POWER

ON OFF

SIGNAL

LIMIT

VOLUME

MIN MAX

0dB

100-120V~60Hz

FUSE: T6.3AL 250V

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS RODUCT TO RAIN OR MOISTURE."WARNING"

MODEL

SERIAL

LTO

ELVIS 15.2XLA

Use only with a 250V fuse

NEW TIDE

(2)

(3)(4)(5) (6)

(9)

(7) (8) (1)

3. WIRE CONNECTIONS

Please use only the power connectors to make connections with other signal source

equipment for the passive speaker cabinets. The power connector has four

terminals: 1+, 1-, 2+, 2-.

-. For Active Speaker Cabinets

Tip

Ring

Sleeve

Tip

Sleeve

TIP SLEEVE

TIP RING SLEEVE

Tip

Ring

Sleeve

Tip

Ring

Sleeve

Tip

Ring

Sleeve

Tip

Sleeve

TIP RING SLEEVE

TIP SLEEVE

SLEEVE RING TIP

Unbalanced

TIP RING SLEEVE

Balanced

SLEEVE TIP

SLEEVE RING TIP

In our cabinets, only 1+/1- are used to connect the Speaker+/Speaker-, and 2+/2- are

not used.

-. For Passive Speaker Cabinets

As to these circumstances, audio connections is mostly intended for the signal flow,

so, determine the wire configuration according to your real application system and its

connecting facility. Normally, you have the following choices:

Tip

Ring

Sleeve

Tip

Sleeve

Tip

Ring

Sleeve

4. TECHNICAL SPECIFICATIONS

11.91CFT

Trapezoidal Cabinet in 18mm Particle Board P.B. -Covered with Resistant Carpet -Black Metal Grille Protection

System Type

Continuous Power

Peak Power Rating

Sensitivity (1W, 1m)

Frequency Response

Impedance

Crossover Frequency

Model No.

External Control

Dimensions (H x W x D)

Model No.

Active System Type

Low Output Power

High Output Power

Max SPL 1mt

1000W Peak

101dB /122 dB Max

55Hz /20kHz +/-6dB

4 Nominal

2200Hz 12dB/oct

ELVIS15.2XL

3-Way Vented Box

500W AES Standard

Electronics High Frequencies Protection

2*15"/385mm Woofer

1"Compression Driver

Custom Horn with Polypropilene Reinforced

80 H 80 V

2 x SPK4 Input/Link @+1/-1 Connected - +2/-2 not connected

1114 452 449 mm

93.92lbs/42.60kg

107.94lbs/48.96kg

Volume

High-Frequency

Spherical Wave Guide

Horn Coverage

Connectors (+1/-1)

Enclosure

Dimensions (H xWxD)

Net Weight (lbs/kg)

Gross Weight (lbs/kg)

Protection

Low-Frequency

Frequency Response

Protection Low - High

Low Frequency Device

High Frequency Device

Coverage (H x V )

Input Sensitivity

ELVIS15.2XLA

2-Way Bi-Amp

350 Watt EIAJ

65 Watt EIAJ

Analog Limiter

2 x 15" woofer / 2.5" Voice Coil

1" Driver / 1" oice Coil

80 H x 80 V Spherical Wave Guide

Line +4dB

122dB SPL Calculated

55Hz-20kHz at -10dB

Connectors

Enclosure

Input Impedance

Net Weight (lbs/kg)

30k Balanced / 15k Unbalanced

Input with Combo / Link with XLR

Trapezoidal Shape / Particle Board/ Plastic Handle / Gray Carpet Finishing

Line Volume / Clipping LED indicator / Ground Switch

1114 x 452 x 449 (mm)

97.89lbs/44.4kg

Power Section

Output Power 350 WATT EIAJ (300WATT RMS)

Impedance 4 Load

S/N ratio >110 dB/A

Distortion <0.05% (THD, DIM, SMPTE)

Gain 32dB

Bandwidth 10Hz to 50 kHz

Protections Overload / Short Circuite / Soft Clip Limiter / Thermal Protection Fan Cooling

Andere Handbücher für ELVIS 15.2XL

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Alto Sprecher Handbücher

Alto

Alto Why Compromise COMPACT 300 Betriebsanleitung

Alto

Alto OEX600 Bedienungsanleitung

Alto

Alto AMX 180FX-USB Bedienungsanleitung

Alto

Alto TX10 Bedienungsanleitung

Alto

Alto Busker Bedienungsanleitung

Alto

Alto REVO1 Bedienungsanleitung

Alto

Alto RMX1008 DFX Bedienungsanleitung

Alto

Alto BLACK 15SUB Bedienungsanleitung

Alto

Alto ts115a truesonic Bedienungsanleitung

Alto

Alto MS8 Bedienungsanleitung

Alto

Alto Elvis Series Bedienungsanleitung

Alto

Alto TS115 Vibe Bedienungsanleitung

Alto

Alto MICRO3 Bedienungsanleitung

Alto

Alto M Series Monitor Bedienungsanleitung

Alto

Alto MS8MA Bedienungsanleitung

Alto

Alto TSL115 Bedienungsanleitung

Alto

Alto PS4 Bedienungsanleitung

Alto

Alto PS Series Bedienungsanleitung

Alto

Alto OEX900 Bedienungsanleitung

Alto

Alto TS115 truesonic Bedienungsanleitung

Alto

Alto TX15 Bedienungsanleitung

Alto

Alto MICRO3 Bedienungsanleitung

Alto

Alto MS8 Bedienungsanleitung

Alto

Alto PAM5 Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung