2
IMPORTANT INSTRUCTIONS
WARNINGS & PRECAUTIONS
BEFORE INSTALLING THE TOWEL WARMER CAREFULLY READ ALL INSTRUCTIONS
Ensure that VOLTAGE (V) & FREQUENCY (HZ) indicated in the serial number plate correspond to
the voltage & frequency available in the place of installation
At receipt of goods, ensure that packaging is intact:
ANY DAMAGES THAT OCCUR DURING TRANSPORT
ARE NOT COVERED BY WARRANTY
• This heater is hot when in use — to avoid burns do not let bare skin touch hot surfaces
• For indoor use only
• Wiring procedures & connections shall be in accordance with the national & local codes having jurisdiction
• Piling multiple towels on top of each other increases the risk of discoloring due to heat
• Discoloration of some towels may occur — this could be the result of fabric makeup, detergent residue,
or if too many towels are placed on the towel warmer. For these reasons amba products cannot be held
liable for any damage to towels. Consider the option of using a digital heat controller for delicates,
acrylics, or nylon — for further protection do not place items directly on unit
• When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock, & injury to persons, including the following:
• Caution: high temperature, risk of fire — keep electrical cords, drapery, furnishings, & other combustibles away
from front of heater
• Bad smells may be caused by residues inside the heater, or by the inner plastic parts as unit operates with no
liquids inside (dry system)
• Do not use heater in case of damaged wire or plug, in case of malfunction, drop, or other kind of circumstance
that may require adjustments or repair: contact Amba Products
• We recommend the p.V.C. Protective tape is left in place until the heater is fully installed: please remove tape
from bracket location first — after the installation, remove the P.V.C. Protective tape to avoid glue residue
• Be careful while handling the heater to avoid scratching, marking, grazing or denting the surface: these damages
are not covered by the warranty
• Be careful during installation & use in the presence of children & disabled people
• To switch off the heater, press the on/off button
• Wiring the connection to the power source incorrectly will cause sparks & burning/breaking of the heater —
consult installation instructions & wiring diagram carefully
• Ensure that the room trip switch is off before any maintenance operation
• Do not insert foreign bodies inside the heater in order to avoid electrical shocks, fire and damages to the heater
• Do not use the heater close to combustibles, paints, or any other flammable liquid
• Keep the heater away from water in order to avoid electrical shocks or damage to the unit
• Always install per local electrical code
Amba Products declines any responsibility if the instructions mentioned above are not kept
• Utilize the heater only for warming rooms, or warming & drying towels
• Utilize the heater as described in this manual only. Any other use not recommended by Amba Products
may cause fire, electric shock, or injuries to individuals
• Use only on 15 ampere branch circuit —a dedicated circuit is not required.
• The unit has to be connected to a power-supply circuit equipped with an omni-polar disconnection
electrical system, with a distance among contacts of 1/8”
