AMC IMIX 2 Bedienungsanleitung

User

Manual

iMIX 2

Zone mixer

Safety instructions

USER MANUAL iMIX 2 Zone mixer

When using this electronic device, basic precautions

should always be taken, including the following:

1Read all instructions before using the product.

2Do not use this product near water (e.g., near a bathtub, washbowl,

kitchen sink, in a wet basement or near a swimming pool etc).

3 Use this device when you are sure that preampliﬁer has

a stable base and it is ﬁxed securely.

4This product, in combination with ampliﬁer and audio source may be

capable of producing sound levels that could cause permanent hearing

loss. Do not operate for a long period of time at a high volume level or at

a level that is uncomfortable. If you experience any hearing loss or ringing

in the ears, you should consult with otorhinolaryngologists.

5The product should be located away from heat sources such as radiators,

heat vents, or other devices that produce heat.

6The product should be connected to a power supply that is described

in the operating instructions or are marked on the product.

7The power supply should be undamaged and never share an outlet

or extension cord with other devices. Never leave device plugged

into the outlet when it is not being used for a long period of time.

8Care should be taken that objects do not fall into liquids and liquids

would not be spilled on the device.

9The product should be serviced by qualiﬁed service personnel if:

– The power supply or the plug has been damaged.

– Objects have fallen into or liquid has been spilled on the product.

– The product has been exposed to rain.

– The product has been dropped or the enclosure damaged.

10 There are some areas with high voltage inside, to reduce the risk of electric

shock do not remove cover of the microphone receiver or power supply.

The cover should be removed by the qualiﬁed personnel only.

CAUTION

To reduce the risk of electric shock, do not remove screws.

No user-serviceable parts inside. Refer servicing to qualied

service personnel. To reduce the risk of re, electric shock

or product damage, do not expose this apparatus to rain,

moisture, dripping or splashing and that no objects lled

with liquids, such as vases, shall be placed on the apparatus.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

Maximum Usage 65mm

Minimum Usage 18mm

Maximum Usage 65mm

Max

Min

axi

xim

nim

mum

m U

ge 6

e 1

18m

Table of contents

USER MANUAL iMIX 2 Zone mixer

Before you start

Introduction......................................................................................................................................................2

Features................................................................................................................................................................2

Operation

Front panel ........................................................................................................................................................3

Rear panel...........................................................................................................................................................4

Front panel operation................................................................................................................................5

Rear panel operation..................................................................................................................................6

Controls...........................................................................................................................................................7-8

Speciﬁcations

General speciﬁcations................................................................................................................................9

USER MANUAL iMIX 2 Zone mixer

Before you start

iMIX 2 – two-zone stereo mixer preampliﬁers with universal balanced Phoenix and stereo RCA inputs. These

zone mixers have all main functions like input gain control, phantom power on/oﬀ, input priority, tone,

balance control and RS232 interface for remote control. iMIX2 zone mixers are all-purpose devices so you can

easy create 2 stereo zone or 2 mono zone audio systems with paging possibilities.

FEATURES

• 4Microphone/LineBalancedinput

• 2RCAstereoinput

• 2Balancedstereooutput

• Priorityinput

• Phantompower

• RS232control

• Microphonetonecontrol

• Outputtone,balancecontrol

•Mastervolumecontrol

•Stereo&monoswitch

•1Uheight

•19”rack

USER MANUAL iMIX 2 Zone mixer

Front Panel

1.Powerswitch|2.LevelcontrolforZone-2|3. Balance control |4. Tone controls

5. Audio input selector |6.LevelcontrolforZone-1|7.Volume/bass/treble/balanceLEDindicators

8.Tonecontrolfor3&4inputs| 9.Levelcontrolfor3&4inputs| 10.Levelcontrolfor1&2inputs

Operation

USER MANUAL iMIX 2 Zone mixer04

Operation

Rear Panel

11.VOXlevelcontrol|12.Microphone/lineaudioinput|13.Inputgainselector,phantompowerswitch|14.StereoRCAaudioinput|

15.Balancedstereooutputs|16.MonoorStereooutputmodeswitch

17.RS-232connector|18.Mainpowerconnectorandfuse

USER MANUAL iMIX 2 Zone mixer

Front panel operation

POWER SWITCH

ToswitchunitONorOFFpressthisbutton.LEDindicatorwillshowwhenthe

unit is switched on.

LEVEL CONTROL FOR ZONE-1

Designedtoadjustaudiolevelinzone1output.

BALANCE CONTROL

Control relative volume of left and right audio outputs.

TONE CONTROL

The separate tone controls provide attenuation of bass and treble response.

The ﬂat position is obtained when the knobs are set to middle position.

Operation

SOURCE INPUT SELECTOR

Inputselectordesignedtoswitchaudiofrominput1orinput2toaudiooutput.

LEVEL CONTROL FOR ZONE-2

Designed to adjust audio level in zone 2 output.

LED

VOLUME:0-10stepoutputlevel0%to100%

TREBLE:(+/-)5step0=default1=2db2=4db3=6db4=9db5=12db

BASS:(+/-)5step0=default1=2db2=4db3=6db4=9db5=12db

BALANCE:(+/-)5step-5=LeftCh+5=RightCh.

SOURCE:S1/S2selectorsourceinput.

USER MANUAL iMIX 2 Zone mixer06

Operation

Rear panel operation

VOX LEVEL CONTROL

This knob is used to adjust mute signal level sensitivity

MICROPHONE/LINE AUDIO INPUT

A balanced signal can be connected to these euro block connectors.

MIC/LINE, PHANTOM POWER SWITCH

Line-selectinputleveltoLineorMicrophone

Phantom power oﬀ - select phantom power ON / OFF.

Tozone-combine3&4inputsignalstobothzones.

AC INPUT WITH FUSE

To replace the fuse, please disconnect the power cord, remove the damaged

andinstalnew1.0ATfuse.

USER MANUAL iMIX 2 Zone mixer

Controls

IMIX2 RS232

Protocol:Baudrate:9600bps,DataBit:8bits,STOPBit:1bit,Parity:None,

FlowCntrl : No

Sendcommands ASCII String Hexadecimal String

Power On #W001 23 57 30 30 31

Power O #W002 23 57 30 30 32

Zone 1 mute On #aM01 23 61 4D 30 31

Zone 1 mute O #aM02 23 61 4D 30 32

Zone 2 mute On #bM01 23 62 4D 30 31

Zone 2 mute O #bM02 23 62 4D 30 32

Zone 1 select input 1 #aS04 23 61 53 30 34

Zone 1 select input 2 #aS03 23 61 53 30 33

Mute input1 and input2 in zone 1 #aS00 23 61 53 30 30

Zone 2 select input 1 #bS04 23 62 53 30 34

Zone 2 select input 2 #bS03 23 62 53 30 33

Mute input1 and input2 in zone 2 #bS00 23 62 53 30 30

Zone 1 input selector $aFUP or $aFDW 23 61 46 55 50 or 23 61 44 57

Zone 2 input selector $bFUP or $bFDW 23 62 46 55 50 or 23 62 44 57

Zone 1 volume #aV(level) 23 61 56 3a 3b

Zone 2 volume #bV(level) 23 62 56 3a 3b

Zone 1 bass #aJ(level) 23 61 4A 30 n

Zone 2 bass #bJ(level) 23 62 4A 30 n

Zone 1 treble #aT(level) 23 61 54 30 n

Zone 2 treble #bT(level) 23 62 54 30 n

Zone 1 balance #aY(level) 23 61 59 30 n

Zone 2 balance #bY(level) 23 62 59 30 n

USER MANUAL iMIX 2 Zone mixer08

Controls

Volume level:min-01,max-79

Zone1andZone2volumecontrolHexstring’s(xx)=(level)

ForexamplesettingZone1volumetolevel48:inASCII#aV48,in

Hex:2361563438

Volume adjusting by steps: $xGUP is a RS232 command for

volume increasing by one step, $xGDW for volume reducing by

onestepx=zonenumber.Pleaseuse“a”insteadxforzone1and

“b”forzone2

For example:

Zone1volumeincreasingbytwostepssend$aGUPcommand

twice:inASCII$aGUP,inHex:2361475550

Zone2volumeincreasingbytwostepssend$bGUPtwice:in

ASCII$bGUP,inHex:2362475550

Bass level:inASCIImin-02,max-0Cin

Hexmin-32,max-43

Treble level:inASCIImin-02,max-0Cin

Hexmin-32,max-43

Balance level:inASCIImin-02,max-0C

inHexmin-32,max-43

Request Com-

mands

ASCII

String

Hexadecimal

string

Receive Strings ASCII

string

Hexadecimal String

Power Status #R001 23 52 30 30 31 Power On #W001 23 57 30 30 31

Power O #W002 23 57 30 30 32

CH1 Mute Status #R002 23 52 30 30 32 C CH1 MUTE On #aM01 23 61 4D 30 31

CH1 MUTE O #aM02 23 61 4D 30 32

CH2 Mute Status #R003 23 52 30 30 33 CH2 MUTE On #bM01 23 62 4D 30 31

CH2 MUTE Of #bM02 23 62 4D 30 32

CH1 VOL Status #R006 23 52 30 30 36 CH1 VOL #aVxx 23 61 56 3x 3x

CH2 VOL Status #R007 23 52 30 30 37 CH2 VOL #bVxx 23 62 56 3x 3x

CH1 SOURCE Status #R00A 2 23 52 30 30 41 CH1 SOURCE INPUT 1 Status #aS04 23 61 53 30 34

CH1 SOURCE INPUT 2 Status #aS03 23 61 53 30 33

CH2 SOURCE Status #R00B 23 52 30 30 42 CH2 SOURCE INPUT 1 Status #bS04 23 62 53 30 34

CH2 SOURCE INPUT 2 Status #bS03 23 62 53 30 33

CH1 TRE Status #R00E 23 52 30 30 45 CH1 TRE #aJ0x 23 61 4A 30 3x

CH2 TRE Status #R00F 23 52 30 30 46 CH2 TRE #bJ0x 23 62 4A 30 3x

CH1 BASS Status #R012 23 52 30 31 32 CH1 BASS #aT0x 23 61 54 30 3x

CH2 BASS Status #R013 23 52 30 31 33 CH2 BASS #bT0x 23 62 54 30 3x

Andere Handbücher für iMIX 2

Inhaltsverzeichnis

Andere AMC Mischer Handbücher

AMC

AMC iMIX2 Bedienungsanleitung

Beliebte Mischer Handbücher anderer Marken

Bosch

Bosch GRW 9 Bedienungsanleitung

MULTIQUIP

MULTIQUIP Whiteman WM45E Leitfaden

KitchenAid

KitchenAid KSM7581BZ0 Kurzanleitung

Jay-Lor

Jay-Lor 5050 Bedienungsanleitung

Sunbeam

Sunbeam FPSBSM210X Bedienungsanleitung

Thinky

Thinky ARE-250 Bedienungsanleitung

Midas

Midas XL4 Bedienungsanleitung

bianco

bianco PURO 4 Bedienungsanleitung

Paso

Paso DAG9200 Bedienungsanleitung

Sima

Sima SFX-9A Bedienungsanleitung

better chef

better chef IM-815WC Montageanleitung

ALLEN & HEATH

ALLEN & HEATH GR1 Bedienungsanleitung

Lacor

Lacor 69083 Technisches Datenblatt

Buffalo

Buffalo CP921 Bedienungsanleitung

Pentair

Pentair HYPRO Cleanload 3376-0870 Betriebsanleitung

Cuisinart

Cuisinart SM50WHE Bedienungsanleitung

Hobart

Hobart HCM-300 Bedienungsanleitung

Kenwood

Kenwood Chef KM400 series Bedienungsanleitung

AMC iMIX 2 Bedienungsanleitung

Beliebte Mischer Handbücher anderer Marken