American DJ Rainbow 250 Bedienungsanleitung

American DJ

4295 Charter Street

Los Angeles Ca. 90058

www.americandj.com

User Instructions

Figure 1

Introduction:

Thank you for purchasing the Rainbow 250™ color changer from American DJ. To optimize the perfor-

mance of this product, please read these operating instructions carefully and familiarize yourself with

the basic operations of this unit. The American DJ® Rainbow 250,™ is a dual channel, DMX, intelligent

color changer. This unit has been lamped and tested at the factory before being shipped to you. There

is no assembly required.

The American DJ® Rainbow 250™ has sound active capabilities so you can use this unit without a

controller. This unit can also be controlled via a standard DMX controller such as the American DJ Show

Designer,™ or the American DJ® DMX Operator,™ giving the user independent control over the color

wheel and dimmer.

Customer Support:

American DJ® provides a toll free customer support line to provide set up help and answers to any

question should you encounter problems during your set up or initial operation. You may also visit us on

the web at www.americandj.com for any comments or suggestions.

Service Hours Monday through Friday are 10:00 a.m. to 5:00 p.m. Pacic Time.

Voice: (800) 322-6337

Fax: (323) 582-2610

E-mail: support@americandj.com

Set Up:

Power Supply:

Before plugging your unit in, be sure the source voltage in your area matches the required voltage for

your American DJ® Rainbow 250.™ The American DJ® Rainbow 250™ is available in a 115v and 230v

version. Because line voltage may vary from venue to venue, you should be sure to plug your power

supply into a matching wall outlet before attempting to operate you controller.

Data Cable (DMX Cable) Requirements:

Your xture and your controller require a standard 3-pin XLR connector for data input and data output

(Figure 1). If you are making your own cables, be sure to use standard two conductor shielded cable

(This cable may be purchased at almost all pro sound and lighting stores). Your cables should be made

with a male and female XLR connector on either end of the cable. Also remember that DMX cable must

be daisy chained and can not be “Y”ed or split.

Notice: Do not use the ground lug on the XLR connec-

tor. Do not connect the cable’s shield conductor to the

ground lug or allow the shield conductor to come in con-

tact with the XLR’s outer casing. Grounding the shield

could cause a short circuit and erratic behavior.

Special Note:

For excessive cable runs totaling 100ft. or more, we recommend using a terminator

XLR MALE SOCKET

1 EARTH HOT 2

3 COLD

XLR FEMALE SOCKET

1 EARTHHOT 2

3 COLD

XLR Pin Configuration:

Pin 1 = Shield

Pin 2 = Data Compliment (negative)

Pin 3 = Data True (positive)

3 HOT

2 COLD

3 HOT

2 COLD 1 GROUND

1 GROUND

of 80-100 ohms/.5w. Long cable runs can sometimes cause erratic behavior. Using a cable terminator

will decrease the possibilities of erratic behavior by completing the data circuit. To make a terminator

simply jump a 80-100 ohm/.5w resistor between pins two (2) and three (3) on a male XLR connector.

Plug the terminator in to the female data connector on the last xture in the line.

Operation Modes:

For best results use fog or special effects smoke to enhance the beam projections.

Stand-Alone Operation (Sound Active):

1. To operate as a stand alone unit via its internal chases and microphone, turn all dip switches off

(See page 6/gure 5).

2. Adjust the sensitivity knob on the rear of the unit so the unit will react to sound.

3. Turning the sensitivity knob in the clockwise direction will increase the sensitivity to sound. Turning

the knob in the counter clockwise direction will decrease the xture’s sensitivity to sound.

4. The American DJ® Rainbow 250™ will now react to the bass sound of music via the internal

microphone.

Master-Slave Operation (Sound Active):

1. This function will allow you to link up to 16 units together. The units will run as a synchronized light

show.

2. In Master-Slave operation one unit will act as the controlling unit and the others will react to the

controlling unit’s program. Any unit can act as a Master or as a Slave.

3. Daisy chain your units via the XLR connectors on the rear of the units.

4. Use standard XLR microphone cables to link your units together. Remember that the Male XLR

connector is the input and the Female XLR connector is the output.

5. The rst unit in the chain (master) will use the female XLR connector only - The last unit in the

chain will use the male XLR connector only.

6. Turn the master unit’s dip switch 10 to the on position. Be sure all other dip switches are set to the

off position (See page 6/gure 5).

7. Turn all dip switches to the off position on the slave units. Please see the chart on page 6 for all

slave dipswitch settings. Note only one xture may use the master units dip switch settings (See

page 6/gure 5)

8. After all the units’ dip switch settings have been set, plug the units in.

9. Adjust the sensitivity knob on the rear of the master unit to make them react to sound.

DMX Operation:

1. Operating through a DMX controller gives the user freedom to create his/her own programs

tailored to their own individual needs. This function also allows you to use your xtures as spots.

2. This operation will allow you to control each xture’s colors and dimmer with a standard DMX 512

Figure 2

controller such as the American DJ Show Designer™ or the American DJ® DMX Operator.™

3. The American DJ® Rainbow 250™ uses two DMX channel to operate; Channel 1 is the color and

channel 2 is dimmer.

4. To run your xture in DMX mode, plug in the xture via the XLR connections to any standard DMX

controller. - Follow the set-up specications that come with the controller.

5. Use the chart on page 6 (gure 4) to set the DMX values for up to 16 units to be controlled by a

DMX controller.

Lens Focusing:

1. To focus a American DJ® Rainbow 250 DMX,™ it is best to rst turn down the music sensitivity knob

to its minimum position. This will prevent the color wheel from changing during focusing.

2. Adjust the focus by manually turning the lens in and out (clockwise & counter-clockwise), until the

outer edge of the beam is a sharp clear image.

Lamp Replacement:

Caution!

Never open the unit when in use. Always disconnect the main power and allow the unit

ample time to cool before attempting to replace the lamp. Remember always replace with the same type

lamp and fuse.

1. Be sure to follow the proper procedures when handling halogen bulbs.

2. Lay the xture at on a stable surface.

3. Remove the three Phillips located on the top of the unit.

4. Remove the cover.

5. Remove and replace the bulb.

6. Reassemble.

Always be sure to replace with the exact same type lamp and fuse unless otherwise specied by autho-

rized American DJ® service representative.

Cleaning:

Due to fog residue, smoke, and dust, cleaning the internal and external optical lenses must be carried

out periodically to optimize light output.

1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.

2. Use a brush to wipe down the fan grill.

3. Clean the external optics with glass cleaner and a soft cloth every 20 days. If used heavily in clubs

with lots of fog, cleaning may be required more often.

4. Clean the internal optics with glass cleaner and a soft cloth every 30-60 days.

5. Always be sure to dry all parts completely before plugging the unit in.

REMEMBER: Cleaning frequency depends on the environment in which the xture operates (i.e.

smoke, fog residue, dust, dew).

Warranty: The American DJ® Rainbow 250 DMX”™ comes with a 1 year limited warranty. We

recommend lling out the warranty registration card that came with your xture to validate your war-

ranty. For service contact your American DJ® dealer.

DMX Traits:

Channel 1: Channel 2:

DMX Value: Color: DMX Value: Trait:

0-16 Blackout 0-39 Blackout

17-33 SLOW Strobe 40-55 Full Intensity

34-50 White 56-255 DIMMER

51-68 Red 255 Full Intensity

69-84 Blue

85-101 Yellow

102-118 Dark Orange

119-135 Green

136-152 Magenta

153-169 Light Orange

170-179 Light Green

180-255 Color Scroll

255 Fastest Color Scroll

Use your controller’s slider to adjust

the DMX value to reach your desired

setting

HALOGEN LAMP WARNING!

This fixture is fitted with halogen lamps

which are highly susceptible to dam-

age if improperly handled. Never

touch lamp with bare fingers as the

oil from your hands will shorten lamp

life. Also, never move fixture until

lamp has had ample time to cool.

Remember, lamps are not covered

under warranty conditions.

SPECIFICATIONS:

Model - Rainbow 250™

Weight: 16 Lbs

Dimensions: 12.75” x 11.75” x 8.5”

Fuse: 4 Amp

Voltage: 120v 60Hz

Bulb: ELC-3 24v/250w Long Life

Duty Cycle: Several Hours

Colors: 8 Colors plus white

• Fan Cooled

• Sound Active

• DMX 512

1 1098765432

Rainbow 250™ Universal DMX Settings for the rst 16 xtures

(If you will not be starting from channel one please follow standard DMX protoocol for binary addressing)

Rainbow 250™ Master/Slave Settings

Please note: You may connect up to 16 units together in master/slave mode. All off for the master and all

slave units will have dip switch one on)

Fixture 1 - Address 1

Slave 3 etc...,Slave 2Slave 1Master Unit

Fixture 16 - Address 31Fixture 12 - Address 23Fixture 8 - Address 15Fixture 4 - Address 7

Fixture 15 - Address 29Fixture 11 - Address 21Fixture 7 - Address 13Fixture 3 - Address 5

Fixture 14 - Address 27Fixture 10 - Address 19Fixture 6 - Address 11Fixture 2 - Address 3

Fixture 13 - Address 25Fixture 9 - Address 17Fixture 5 - Address 9

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere American DJ Beleuchtungsausrüstung Handbücher

American DJ

American DJ ELECTRA Bedienungsanleitung

American DJ

American DJ Dynasty Ray Montageanleitung

American DJ

American DJ Fusion FX Bar 3 Bedienungsanleitung

American DJ

American DJ Star Winder Bedienungsanleitung

American DJ

American DJ Rainbow-250 Bedienungsanleitung

American DJ

American DJ TRI PHASE Montageanleitung

American DJ

American DJ Galaxian 3D Bedienungsanleitung

American DJ

American DJ Eco UV Bar 50 IR Bedienungsanleitung

American DJ

American DJ RADD Bedienungsanleitung

American DJ

American DJ D-LIGHT SYNC PAK Bedienungsanleitung

American DJ

American DJ Mega Par Profile System Bedienungsanleitung

American DJ

American DJ Super Strobe MKII Bedienungsanleitung

American DJ

American DJ Revo III Bedienungsanleitung

American DJ

American DJ Emerald Sync Bedienungsanleitung

American DJ

American DJ Inno Pocket Spot Pearl Bedienungsanleitung

American DJ

American DJ Inno Scan LED Bedienungsanleitung

American DJ

American DJ FS-1000 Pro Followspo Bedienungsanleitung

American DJ

American DJ Dekker LED Bedienungsanleitung

American DJ

American DJ 64B LED PRO Bedienungsanleitung

American DJ

American DJ VioSCAN LED Bedienungsanleitung

American DJ

American DJ Sparkle LED 3W Bedienungsanleitung

American DJ

American DJ FREQ 16 Strobe Bedienungsanleitung

American DJ

American DJ Rampage Bedienungsanleitung

American DJ

American DJ Roto Balls Tri LED Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung