Page 2 of 2
26685050
REV. A
Installing a Coin Blockout requires removal of the Coin Mech. The following procedure
is applicable for any position (side or center) of the Coin Mech. Follow the step by step
instructions to install this kit.
1. Power off and unplug the jukebox. Open the front or currency module door to gain
access to the back of the Coin Mech.
2. Disconnect the wiring to the Coin mech.
3. Referring to Figure 1, remove the four screws fastening the Coin Mech to the door and
remove the Coin Mech.
4. Place the kit supplied Coin Mech Blockout in place of the just removed Coin Mech on
the front of the jukebox door/ currency module and using the kit supplied #8-32 X 3/8
screws, fasten the blockout in place.
