03/21/2016 - SPU001-QSG
Code: 140156
This Analog Way product has a 1 year warranty on parts and labor (except for the power supply, the frame head and
the baery that are under warranty only in case of “Dead On Arrival”). This warranty does not include faults resulng
from user negligence, special modicaons, electrical surges, abuse (drop/crush), and/or other unusual damage. In the
unlikely event of a malfuncon, please contact your local Analog Way oce for service.
Hot swap:
You may wish to replace defecve elements while the installaon is running.
To replace a defecve power supply unit while the LiveCore™ device is running, follow these steps (taking the usual
safety measures against ESD):
• Unplug the power cable from the mains,
• Unplug the power cable from the defecve Power Supply Unit and take it o,
• Fit the new Power Supply Unit,
• Plug the IEC power cable to the Power Supply Unit,
• Connect the power cable to the mains.
To replace the baery, put the LiveCore™ device in stand-by, replace the baery then turn on the LiveCore™ device.
The third step is to connect the Secure Power Unit to the
LiveCore™ through an RS232 cable. It will provide informaon
about the Secure Power Unit directly on the Web RCS
interface. Connect the ground between the Secure Power
Unit and the LiveCore™ device.
The last step is to power the Secure Power Unit. The LiveCore™
device is ready to run safely.
WARNING: In order to power the Secure Power Unit, plug IEC
cables rst in the Secure Power Unit then plug into the mains
power.
STEP #3 STEP #4
1
2
11
2
Take the usual precauons against ESD (electrostac discharge).
To ensure maximum life to the baeries used in the Secure Power Unit, some precauons of use are required.
1) In use on a Secure Power Unit:
The charging/discharging system in the Secure Power Unit automacally provides the best baery perfomance. No
acon is required.
2) Storage:
Like all baeries, when a lithium baery is not used, it is subject to a low self-discharge.
For storage periods longer than 6 months, you should monitor the level of charge and, if the baery is at 50% or less,
you must charge the baery using the "Forced charging" feature of your Secure Power Unit.
PRECAUTION OF USE AND STORAGE OF LITHIUM-ION BATTERIES
WARRANTY AND SERVICE
