The ANT-36000 is a Universal Decoder for RTSP ONVIF MPEG-TS RTP RTMP
streams with 3 video outputs (HDMI , 3G HD-SDI and scaled Composite) Supporting
ONVIF profile interrogation , quad view , single view, ONVIF PTZ control and up to
100 camera list switching automatically (timed) or via the API http commands
1.What’s in the Box
The ANT-36000 box contains
- ANT-36000 Decoder
-12 Volt Power converter (requires an IEC AC mains lead)
-UK/EU/USA or China IEC 110/240v AC Lead (depending on your location)
-Fixing kit
2. Setting up the ANT-36000
Connect the ANT-36000 to a laptop or PC using an Ethernet switch using standard
ethernet cables. Connect a laptop to the switch to configure the ANT-36000.
Connect an ONVIF camera or RTSP camera/source as a test unit to the switch.
Connect the ANT-36000 to a suitable display via HDMI or HD SDI (composite can be
used but it will reduce the image size to PAL or NTSC resolution)
Connect the ANT-36000 12 volt power input (or use PoE) and switch on.
The ANT-36000 will take approximately 2 minutes to boot up. You will see 4 LEDs.
On powering the Red power LED and LINK is ON, after boot Link goes out and then
you will see Status flash and Data may or may not be ON depending if the decoder
is decoding something . Once status is flashing as a minimum you are now ready to
setup the ANT-36000 Encoder
3. Configuring the ANT-36000
The ANT-36000 default IP address is 192.168.10.100
Open Chrome or Internet Explorer (chrome uses a player plugin and IE uses active
X ) other up to date browser to just view settings (No video) and browse to
192.168.10.100 (please ensure PC/Laptop is on same subnet range eg
192.168.10.xxx You will be asked to LOGIN: User : admin , password: 1234
