Arbor Technology Rigid-750 Bedienungsanleitung

Rigid-750 / Rigid-752

Intel® CoreTM i5-520M

Box PC

User’s Manual

Version 1.1

P/N: 4016075200110P 2014.11

This page is intentionally left blank.

- I -

Index

Chapter 1 - General Information..............................................1

1.1 Introduction................................................................2

1.2 Packing List................................................................2

1.3 The Installation Paths of CD Driver..........................4

1.4 Specications ............................................................4

1.5 Power Information .....................................................6

1.6 Dimensions ................................................................6

1.7 Locating Controls and Connectors..........................7

1.8 Connecting Peripherals ............................................9

1.8.1 VGA/DVI/DisplayPort Video Outputs.....................9

1.8.2 Serial Ports (COM1 ~4).........................................10

1.8.3 LAN Ports .............................................................. 11

1.8.4 USB Ports ..............................................................12

1.8.5 Keyboard and Mouse ...........................................13

1.8.6 Expansion PCIe Slots...........................................13

1.8.7 Audio Line-out/Mic-in ...........................................14

1.8.8 DC Power Input and Power ON/OFF Button.......15

Chapter 2 - The Engine of Rigid-750/Rigid-752....................17

2.1 Board Layout............................................................18

2.2 Jumpers and Connectors .......................................19

2.2.1 Jumpers & Connectors List.................................19

2.2.2 Jumper Setting......................................................20

SW1, 2, 4 (RS-232/RS-485 Function Select Jumper for

COM3, COM4)................................................................20

SW1 Setting................................................................... 20

SW2 Setting................................................................... 21

2.2.3 Pin Assignments for Connectors ........................21

PWRIN1 (Power Input)..................................................21

SW4 Setting................................................................... 21

CN1 (COM1 ~ COM4) ....................................................22

CBL-7100-COM (COM Converter Cable) (Optional) ... 23

VGA1 (CRT Display Connector)................................... 25

DP1 (DisplayPort Connector).......................................25

LAN1/2 (LAN Ports).......................................................26

USB1/2 (USB Ports) ......................................................26

- II -

Index

AUDIO1 (Audio Jacks)..................................................26

MC1 (PCIe Mini-card socket)........................................27

CPUF1/2 (Fan Connector) ............................................28

KBM1 (Keyboard & Mouse)..........................................28

CF1 (CFast Slot)............................................................28

DVI1 (DVI).......................................................................30

JSPI1 (System BIOS Enable/ Disable Pin Header,

factory use only) ...........................................................30

DIO1 (Digital I/O Port) ...................................................31

LPT1 (Parallel Port).......................................................31

SATA1/2 (Serial ATA Connectors)................................32

PWR1/2 (HDD/SSD Power Connectors) ......................32

Chapter 3 - Installation and Maintenance.............................33

3.1 CPU and Memory Module Installation ...................34

3.1.1 Removing Top Cover............................................34

3.1.2 Installing CPU .......................................................35

3.1.3 Installing Memory Module....................................36

3.1.4 Installing Memory Module with Thermal Pad.....37

3.1.5 Installing HSUPA 3.75G Module ..........................42

3.2 How to Access CFast/SIM Card..............................45

3.3 Hard Disk Drive and PCIe Card Installation ..........47

3.3.1 Removing Bottom Cover......................................47

3.3.2 Installing Hard Disk Drive ....................................47

3.3.3 Installing PCIe Card..............................................51

3.4 Wall Mounting ..........................................................52

3.5 Grounding the Box PC ............................................53

3.6 Wiring the DC-Input Power Source........................54

Chapter 4 - BIOS.....................................................................55

4.1 BIOS Main Setup......................................................56

4.2 Advanced Settings ..................................................57

4.2.1 ACPI Settings .......................................................59

4.2.2 CPU Conguration...............................................60

4.2.3 SATA Conguration .............................................62

4.2.4 Intel® IGD SWSCI OpRegion Conguration......63

4.2.5 USB Conguration...............................................64

4.2.6 Super IO Conguration .......................................65

- III -

4.2.7 PC Health Status..................................................66

4.2.8 Second Super IO Conguration .........................67

4.2.9 Platform Thermal Conguration.........................68

4.3 Chipset Settings ......................................................69

4.3.1 North Bridge.........................................................70

4.3.2 South Bridge Conguration................................71

4.4 Boot Settings ...........................................................72

4.5 Security.....................................................................74

4.6 Save & Exit ...............................................................76

Appendix .................................................................................79

Appendix A: I/O Port Address Map ..............................80

Appendix B: Interrupt Request Lines (IRQ) ................82

Appendix C: Memory Mapping.....................................83

Appendix D: Digital I/O Setting.....................................85

Appendix E: Watchdog Timer (WDT) Setting..............87

Index

- IV -

This page is intentionally left blank.

- i -

The information in this document is subject to change without prior notice in

order to improve the reliability, design and function. It does not represent a

commitment on the part of the manufacturer.

Under no circumstances will the manufacturer be liable for any direct, indirect,

special, incidental, or consequential damages arising from the use or inability

to use the product or documentation, even if advised of the possibility of such

damages.

This document contains proprietary information protected by copyright. All

rights are reserved. No part of this document may be reproduced by any me-

chanical, electronic, or other means in any form without prior written permis-

sion of the manufacturer.

Declaration of Conformity

The CE symbol on your product indicates that it is in compliance with the di-

rectives of the Union European (EU). A Certicate of Compliance is available

by contacting Technical Support.

This product has passed the CE test for environmental specications when

shielded cables are used for external wiring. We recommend the use of

shielded cables. This kind of cable is available from ARBOR. Please contact

your local supplier for ordering information.

Warning

This is a class A product. In a domestic environment this product may cause

radio interference in which case the user may be required to take adequate

measures.

FCC Class A

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference

that may cause undesired operation.

NOTE:

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment gen-

erates, uses, and can radiate radio frequency energy and, if not installed and

- ii -

used in accordance with the instruction manual, may cause harmful interfer-

ence to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

RoHS

ARBOR Technology Corp. certies that all components in its products are in

compliance and conform to the European Union’s Restriction of Use of Haz-

ardous Substances in Electrical and Electronic Equipment (RoHS) Directive

2002/95/EC.

The above mentioned directive was published on 2/13/2003. The main pur-

pose of the directive is to prohibit the use of lead, mercury, cadmium, hexava-

lent chromium, polybrominated biphenyls (PBB), and polybrominated diphe-

nyl ethers (PBDE) in electrical and electronic products. Member states of the

EU are to enforce by 7/1/2006.

ARBOR Technology Corp. hereby states that the listed products do not con-

tain unintentional additions of lead, mercury, hex chrome, PBB or PBDB that

exceed a maximum concentration value of 0.1% by weight or for cadmium

exceed 0.01% by weight, per homogenous material. Homogenous material

is dened as a substance or mixture of substances with uniform composition

(such as solders, resins, plating, etc.). Lead-free solder is used for all termina-

tions (Sn(96-96.5%), Ag(3.0-3.5%) and Cu(0.5%)).

SVHC / REACH

To minimize the environmental impact and take more responsibility to the

earth we live, Arbor hereby conrms all products comply with the restriction of

SVHC (Substances of Very High Concern) in (EC) 1907/2006 (REACH --Reg-

istration, Evaluation, Authorization, and Restriction of Chemicals) regulated

by the European Union.

All substances listed in SVHC < 0.1 % by weight (1000 ppm)

- iii -

Important Safety Instructions

Read these safety instructions carefully

1. Read all cautions and warnings on the equipment.

2. Place this equipment on a reliable surface when installing. Dropping it or

letting it fall may cause damage

3. Make sure the correct voltage is connected to the equipment.

4. For pluggable equipment, the socket outlet should be near the equipment

and should be easily accessible.

5. Keep this equipment away from humidity.

6. The openings on the enclosure are for air convection and protect the equipment

from overheating. DO NOT COVER THE OPENINGS.

7. Position the power cord so that people cannot step on it. Do not place

anything over the power cord.

8. Never pour any liquid into opening. This may cause re or electrical

shock.

9. Never open the equipment. For safety reasons, the equipment should be

opened only by qualied service personnel.

10. If one of the following situations arises, get the equipment checked by

service personnel:

a. The power cord or plug is damaged.

b. Liquid has penetrated into the equipment.

c. The equipment has been exposed to moisture.

d. The equipment does not work well, or you cannot get it to work according

to the user’s manual.

e. The equipment has been dropped or damaged.

f. The equipment has obvious signs of breakage.

11. Keep this User’s Manual for later reference.

- iv -

Warning

The Box PC and its components contain very delicately Integrated Circuits

(IC). To protect the Box PC and its components against damage caused by

static electricity, you should always follow the precautions below when han-

dling it:

1. Disconnect your Box PC from the power source when you want to work on

the inside.

2. Use a grounded wrist strap when handling computer components.

3. Place components on a grounded antistatic pad or on the bag that came

with the Box PC, whenever components are separated from the system.

Replacing the Lithium Battery

Incorrect replacement of the lithium battery may lead to a risk of explosion.

The lithium battery must be replaced with an identical battery or a battery type

recommended by the manufacturer.

Do not throw lithium batteries into the trashcan. It must be disposed of in

accordance with local regulations concerning special waste.

Technical Support

If you have any technical difculties, please consult the user’s manual rst

at: ftp://ftp.arbor.com.tw/pub/manual

Please do not hesitate to call or e-mail our customer service when you still can-

not nd out the answer.

http://www.arbor.com.tw

E-mail:info@arbor.com.tw

About This User’s Manual

This User’s Manual is intended for experienced users and integrators with

hardware knowledge of personal computers. If you are not sure about any

description in this User’s Manual, please consult your vendor before further

handling.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Arbor Technology Desktop Handbücher

Arbor Technology

Arbor Technology IEC-3300 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-810 Series Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Arbor Technology

Arbor Technology ARES-1230 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7900 Bedienungsanleitung

Arbor Technology

Arbor Technology BPC-500-5820 Bedienungsanleitung

Arbor Technology

Arbor Technology Rigid-770 Series Bedienungsanleitung

Arbor Technology

Arbor Technology ARTS-2870 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-3130 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-9107 Series Bedienungsanleitung

Arbor Technology

Arbor Technology M1858 Bedienungsanleitung

Arbor Technology

Arbor Technology LYNC-817 Series Bedienungsanleitung

Arbor Technology

Arbor Technology Arpex-1610 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7500 Series Bedienungsanleitung

Arbor Technology

Arbor Technology Rigid-314 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-791 Series Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-3130 Bedienungsanleitung

Arbor Technology

Arbor Technology ARES-1983H Series Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

HP m9060n - Pavilion - Elite Technisches Datenblatt

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

HP Presario SV7000 - Desktop PC Bedienungsanleitung

HP ProDesk 400 G5 Handbuch

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

HP Z1 Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung