Flex Mini Instruction Manual
November 2015
Page 9 of 17
PB3 PB4
PB4
2.1.4 Remote Pairing
Enter transmitter Function Setting Mode by moving the function
dipswitch located inside the battery compartment to “on” position.
Reinsert the two batteries and press PB1 to power up the transmitter.
At this point the Status LED will display a series of red, green and
orange blinks showing the current software version. Then press and
hold PB3 and PB4 at the same time for up to 1 second to go into the
Remote Pairing Mode (Status LED orange and then off).
Transmitter-to-Transmitter Pairing:
→
Output data – original transmitter Receiving data – new transmitter
(Press and hold PB3) (Press and hold PB4)
After entering the Remote Pairing Mode, output data (original transmitter) by press and hold PB3
and receive data (new transmitter) by press and hold PB4 both at the same time. When the
Status LED on the new transmitter (receiving data end) turns to constant green while the buttons
are still pressed down the pairing is completed. Exit transmitter Function Setting Mode by taking
out the batteries and move the function dipswitch on both transmitters back to “off” position.
Receiver-to-Transmitter Pairing:
→
Output data - receiver Receiving data – transmitter
(Press and hold the Pairing button) (Press and hold PB4)
JP1 Open Method: After entering the Remote Pairing Mode, output receiver data by press and
hold the Pairing button located on the receiver cover and receive data by press and hold PB4 on
the transmitter, both at the same time. When the transmitter Status LED turns to constant green
while both buttons are still pressed down the pairing is completed. Exit transmitter Function
Setting Mode by taking out the batteries and move the function dipswitch back to “off” position.
JP1 Short Method (press Pairing button not required): After entering the Remote Pairing
Mode, press PB1 on the transmitter one time and then press and hold PB3 for up to 6 seconds.
The Status LED blinks green when PB3 is pressed. Let go of PB3 when green blinks are no
longer shown on the Status LED; the pairing is completed. Exit transmitter Function Setting Mode
by taking out the batteries and move the function dipswitch back to “off” position. Make sure the
RX-to-TX pairing process is executed within a distance of 10 meters from one another and no
other active receivers nearby.
Note: when transmitter keypad is set to type 1 while performing RX-to-TX remote pairing the receiver must be reset (turn
off and back on) or execute the RX-to-TX remote pairing 1 minute after receiver inactivity.
