ARC LYCT-505 Bedienungsanleitung

Version 2.

pecification:

Function: 16 Channel wireless remote control

Group ON/OFF Function

Frequency: 433.92MHz

Battery: 3V CR2032 Lithium Cell Battery

verview:

Compact 16 channels hand held remote control with the ability to control your lighting system

wirelessly.

With 4 sets of ON/OFF button, 1 set of group ON/OFF function and a slide switch to select 4

channels.

Wireless Remote Control

LYCT-505

Version 2.

aring:

Hand held remote control can memorize unlimited receivers into the 16 channels.

Pairing using LEARNING MODE:

1. First choose the desired receiver(s) that you wish to control.

2. Press the ‘Learn’ button once (LED will flash), this will now enter learning mode.

3. On the remote control press the ‘ON’ button intended to be paired; the load will flash twice to

confirm that the remote control is now paired.

＊To pair two or more receivers as a group, during the learning mode press the ‘Group ON’button

instead.

NOTE: Learning mode lasts for 12 seconds; if no signal is given to the receiver then it will

automatically exit learning mode without pairing the device.

To exit learning mode manually, simply press the ‘Learn’ button again.

！If, during learning mode the load does not flash to confirm, this means that the receiver’s memory

is FULL and no further remote control may be paired unless one of the existing remote control is

first unpaired (see below).

nparing:

Removing single device:

1. With the receiver that you intent to un-pair press the ‘Learn’ button once (LED will flash), this

will now enter learning mode.

2. On the remote control press the ‘OFF’ button intended to be unpaired; the load will flash twice to

confirm that the remote control is now unpaired.

＊To un- paired receiver(s) from a group, during the learning mode press the ‘Group OFF’button

instead.

Version 2.

peration:

If you wish to use more than 4 memories, the I / II / III / IV slide switch at the bottom of the remote

control must be used. Each channel can store up to 4 memories.

Slide Switch.

Slide switch allows the remote control to transmit up to 16 commands.

By using the slide switch, the 4 ON/OFF buttons can each transmit 4 signals. i.e. ON/OFF button 1

transmits to receivers paired when slide switch at position I, ON/OFF button 1 transmits to receivers

paired when slide switch at position II etc..

ON/OFF Function:

Press the ‘ON’button on remote control, the lights will gradually illuminate.

Press the ‘OFF’button on remote control, the light will gradually turn OFF.

Group ON/OFF Function:

Press the ‘Group ON’button on remote control, the group of lights you first set up will gradually

illuminate.

Press the ‘Group OFF’button on remote control, the group of lights you first set up will gradually

turn OFF.

Dimming Function: (not available under ‘Group’button)

1. Make sure load is switched ON.

2. On the remote control press the ON button again, the loads will start to dim.

3. To stop at the desired brightness level, press the ON button again.

※Dimming level dims in cycle, during the cycle if no signal is given, after 4 cycles it will stop at

100% brightness.

！After setting a dim level using the remote control the light is then switched OFF, the next time that

the light is switched back ON again the load will return to the previous stipulated brightness.

Version 2.

attery Replacement:

3V CR2032 lithium battery is included.

When the battery voltage is low, the transmission range will be reduced accordingly.

Slide down battery cover and with a screw driver push out the battery.

Replace with a new battery then slide up the battery cover.

roubleshoot:

Problem: The LED on remote control does not light up.

Solution:Please check if the battery is inserted correctly or replace a new battery.

Problem:I cannot pair my remote control with the receiver.

Solution:The memory on receiver is full, please delete one or more memory and try pairing again.

Inhaltsverzeichnis

Andere ARC Fernbedienung Handbücher

ARC

ARC FLEX6EX Bedienungsanleitung

ARC

ARC TMT-918 Bedienungsanleitung

ARC

ARC Automate Installationshandbuch

ARC

ARC LYCT-820 Bedienungsanleitung

ARC

ARC FLEX Mini M Bedienungsanleitung

ARC

ARC Flex ECO 4S MRX Bedienungsanleitung

ARC

ARC AT401 Bedienungsanleitung

ARC

ARC FLEX ECO 8S Bedienungsanleitung

ARC

ARC FLEX4EX Bedienungsanleitung

ARC

ARC FLEX EPV Bedienungsanleitung

ARC

ARC ECO8S/X Bedienungsanleitung

ARC

ARC ECO4S/X Bedienungsanleitung

ARC

ARC MYCT-1702 Bedienungsanleitung

ARC

ARC Flex 2JX Bedienungsanleitung

ARC

ARC Flex ECO Series Bedienungsanleitung

ARC

ARC Flex Series Bedienungsanleitung

ARC

ARC FLEXEPH Bedienungsanleitung

ARC

ARC MJLT-2005 Bedienungsanleitung

ARC

ARC ARC FLEX Bedienungsanleitung

ARC

ARC Flex 2JB-HRX Bedienungsanleitung

ARC

ARC FLEX 8EX Bedienungsanleitung

ARC

ARC ECO Series Bedienungsanleitung

ARC

ARC MKFT-1704 Bedienungsanleitung

ARC

ARC MEBT-1706 Bedienungsanleitung

Beliebte Fernbedienung Handbücher anderer Marken

Panasonic

Panasonic EUR7622KB0 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beo4 Bedienungsanleitung

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Bedienungsanleitung

Multiplex

Multiplex PROFI TX 9 Bedienungsanleitung

One Remote

One Remote RMB4 Bedienungsanleitung

FUTABA

FUTABA 9ZAP - PART2 Bedienungsanleitung

HR Matic

HR Matic HR MULTI 3 Bedienungsanleitung

Yamaha

Yamaha ACC-GNRST-30-20 Bedienungsanleitung

EisSound

EisSound KBSOUND Bedienungsanleitung

Marantz

Marantz RC101 Bedienungsanleitung

Conrad

Conrad FS20 TC6 Bedienungsanleitung

Anritsu

Anritsu MP1777A Bedienungsanleitung

Niles

Niles WVC100 Fehlerbehebungshandbuch

RCA

RCA RCU1300 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BEO6 Bedienungsanleitung

GE 94901 Bedienungsanleitung

Onbon

Onbon YQ1-75 Bedienungsanleitung

FUTABA

FUTABA R7108SB Montageanleitung