Argos 608/0811 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 100cm

Depth - 59cm

Height - 89.5cm

Athina - 1000 Base Unit

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 3 - 01/02/12

Important - Please read these instructions fully before starting assembly

608/0811

608/0938

608/0873

608/2981

608/0990

ALR2458

25/03/11: Added Argos Code 608/2981

01/02/12:

Rail changed to D0325A.

Plinth changed to D0326A.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 42kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• Parts of the assembly will be

easier with 2 people.

Glue Safety - Take care when using glue, please follow the advice below

Skin contact: Remove contami-

nation by washing with soap and

water. This procedure should be

followed prior to aeting and

drinking.

Eye contact: Rinse immediately

with clean water for 15 minutes

and seek medical advice.

If swallowed: Seek medical

advice immediately.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

brackets supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

80%

x 2

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Door (D0317A)

(716 x 497mm) x 2

Base (D0323A)

(970 X 499mm)

Shelf (D0324A)

(969 X 427mm)

Top (D0339A)

(1000 x 590mm)

Back (X740)

(980 x 533mm)

4 5

6 7

Left Side (D0315B)

(870 X 570mm)

Right Side (D0316B)

(870 x 570mm)

Rail (D0325A)

(970 x 60mm) x 2

Plinth (D0326A)

(970 x 150mm)

Munting (D0327A)

(689 x 59mm)

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 14

Metal dowel (F901) x 10

Shelf support (F110) x 4

E F

G H I

Rule Scissors Hammer Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Nail (F51) x 14

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Door Buffer (F137) x 4

Electric drill

Large locking

nut (F900) x 10

Bracket (F945) x 4

25mm Screw (F50) x 4

13mm Screw (F79) x 1

13mm Screw (F63) x 813mm Screw (F79) x 6

Hinge Plate

(F853) x 4 Hinge (F852) x 4

MHandle (F847a ) x 2

aMHandle Screw (F847b) x 4

b N

40mm Screw (F910) x 2

Front

edge

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

Front

edge

Step 2

Prepare the left side

a: Fit 2 hinge plates

onto the left side ,

making sure that the slot

is facing towards the

front edge.

b: Screw 5 metal

dowels into the holes

shown on the left side

. .

Note: Tighten metal

dowels up fully against

the panels.

Fit 2 brackets to the

left side

Fit a bracket to the

left side , 100mm in

from the back edge, see

diagram.

Fit another bracket to

the left side , 100mm

down from the top edge,

see diagram.

Secure each bracket

using screw .

Note: The brackets must

be flush with the edges

of the panel.

100mm

Assembly Instructions

Step 3

Step 4

Front

edge

Prepare the right side

a: Fit 2 hinge plates

onto the right side ,

making sure that the slot

is facing towards the

front edge.

b: Screw 5 metal

dowels into the holes

shown on the right side

. .

Note: Tighten metal

dowels up fully against

the panels.

100mm

Fit 2 brackets to the

right side

Fit a bracket to the

right side , 100mm

down from the back

edge, see diagram.

Fit another bracket to

the right side ,

100mm down from the

top edge, see diagram.

Secure each bracket

using screw .

Note: The brackets must

be flush with the edges

of the panel.

Front

edge

Assembly Instructions

Prepare the base

Insert 4 large locking

nuts into the base

as shown.

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Tap 6 wooden dowels

into the base as

shown.

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Step 5

Step 6

Fit the base to the

right side

Push the base onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

10mm

Finished

front edge

Assembly Instructions

Step 7

Step 8

Fit a rail to the right

side

Push one of the rails

onto the right side as

shown.

Use a screwdriver to

tighten the large locking

nut .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Prepare the 2 rails

and munting

Insert 2 large locking

nuts and 2 wooden

dowels into each of

the 2 rails .

Tap 2 wooden dowels

into the munting .

Assembly Instructions

Step 9

Prepare the plinth

Insert 2 large locking

nuts and 2 wooden

dowels into the plinth

. .

Fit the munting

Fit the munting to the

rail and base and

secure using 2 screws

. .

6 4

Step 10

Polystyrene

block

Assembly Instructions

Use 2nd hole in from front of

Runner F1004 to fit 1st F73 then

fit other F73 to match other hole.

Rebated Edge

F73

COVERED EDGE

Use 2nd hole in from front of

Runner F1004 to fit 1st F73 then

fit other F73 to match other hole.

F1004

When you insert F900,

make sure the arrow is

pointing towards the hole

in the edge of the panel.

F900

F73

F1004

COVERED EDGE

Step 11

Step 12

Step 7

Fit the top

Note: To make it easier

to fit the top panel, place

polystyrene blocks from

the packaging

underneath the side

panels to raise the

assembly.

Position the top onto the

unit, making sure that

the back edge of the top

is flush with the back

edge of the sides.

Secure the top using

screw through the 2

brackets fitted at the top

edge of the side panels.

F100mm

100mm

500mm

Fit the rail and plinth

Push the rail and

plinth onto the right

side as shown.

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the 2 panels, as shown.

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Note: Support the rail

. until the left side has

been fitted in the next

stage.

Fit the left side

Push the left side

onto the assembly.

Use a screwdriver to

tighten the 5 large

locking nuts fitted to

the base , rails

and plinth .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 033 3560 Series Bedienungsanleitung

Argos

Argos Savannah 602/5326 Bedienungsanleitung

Argos

Argos Wow Pine Kitchen Trolley 424/6963 Bedienungsanleitung

Argos

Argos Belle HOME 879/0240 Bedienungsanleitung

Argos

Argos Malibu 428/3445 Bedienungsanleitung

Argos

Argos 331/9846 Datenblatt

Argos

Argos Retro Pedestal 343/7395 Bedienungsanleitung

Argos

Argos 600/3575 Bedienungsanleitung

Argos

Argos 389/6039 Bedienungsanleitung

Argos

Argos Adele 257/6549 Bedienungsanleitung

Argos

Argos Matrix Glass Nest Table Bedienungsanleitung

Argos

Argos Aurelie 557/4861 Datenblatt

Argos

Argos Double Metal Futon 656/0898 Bedienungsanleitung

Argos

Argos Lavendon 275473 Bedienungsanleitung

Argos

Argos 8146643 Bedienungsanleitung

Argos

Argos Mia 2573968 Bedienungsanleitung

Argos

Argos Wide Media Unit Installationsanleitung

Argos

Argos Modular Bedienungsanleitung

Argos

Argos 346/0348 Bedienungsanleitung

Argos

Argos Le Marais 393/0782 Bedienungsanleitung

Argos

Argos Malibu 621/3310 Bedienungsanleitung

Argos

Argos Aruba 614/3837 Bedienungsanleitung

Argos

Argos 617/2516 Bedienungsanleitung

Argos

Argos Chicago Dining Set Bench Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung