Argos Asha Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

If you need help or have damaged or missing parts, please visit www.argos-support.co.uk

or email: Help@ClickSpares.co.uk (quoting your original order number)

Alternatively, call the Spares Helpline on: 0370 112 1928.

For any other queries please contact the Customer Helpline on: 0345 640 2020

Important - Please read these instructions fully before starting assembly

IMPORTANT !

KEEP THESE ASSEMBLY INSTRUCTIONS

FOR FUTURE REFERENCE

WARNING!

NOT SUITABLE FOR CHILDREN

UNDER 4 YEARS OF AGE .

This product conforms to

BS 8509: 2008+A1: 2011

Asha - Cabin Bed

ALR3216

411/9454

427/8632

Width - 195.5cm

Depth - 96cm

Height - 42cm

Issue 2 - 29/09/15

Issue 2 - 29/09/15 - Wrong cat codes replaced with 411/9454 and 427/8632

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• The recommended mattress size is 900mm x 1900mm.

• Minimum mattress height of 200mm to be used.

• WARNING! Do not place this child’s bed near heat

sources, windows and other furniture.

• WARNING! Do not use this child’s bed if any part is

broken, torn or missing.

• WARNING! Not suitable for children under 4 years old.

• WARNING! Children are likely to play, bounce, jump and

climb on beds, therefore the child’s bed should not be

placed too close to other furniture or windows, blinds or

cords, curtain pulls or other strings or cords and should

be placed either tight to any wall or have a gap of

300mm between the wall and the side of the bed.

• This unit is not designed to be dismantled for storage or

transportation.

IMPORTANT!

On a regular basis please

check that the screws and

fittings have not become

loose as this could present

a potential choke hazard.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 47kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

If you need help or have damaged or missing parts, please visit www.argos-support.co.uk

or email: Help@ClickSpares.co.uk (quoting your original order number)

Alternatively, call the Spares Helpline on: 0370 112 1928.

For any other queries please contact the Customer Helpline on: 0345 640 2020

80%

x 2 1End Panel (D3112)

(95.6 x 41.8cm) x 2

Door (D3115)

(33.5 x 31.1cm) x 2

Lower Middle Plinth (D3118)

(63 x 7.8cm) x 2

Middle Matress Base (D3117)

(64.5 x 95.2cm)

Side Rail (D3116)

(96 x 4.5cm) x 4

Back Brace (D3113)

(63 x 20cm) x 3

Divider (D3114)

(35.6 x 94.8cm) x 2

LH Side Plinth (D3119)

(63 x 7.8cm) x 2

RH Side Plinth (D3123)

(63 x 7.8cm) x 2

End Mattress Base (D3120)

(63.75 x 95.2cm) x 2

Bed Base (X788-630)

(78.8 x 63cm) x 3

3 4

Please check you have all the fittings listed below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Components - Fittings

If you need help or have damaged or missing parts, please visit www.argos-support.co.uk

or email: Help@ClickSpares.co.uk (quoting your original order number)

Alternatively, call the Spares Helpline on: 0370 112 1928.

For any other queries please contact the Customer Helpline on: 0345 640 2020

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

A B

D E F

H J

Large locking

nut (F900) x 28

Metal dowel (F901) x 4 Wooden dowel (F22) x 10

Large wooden dowel (F40) x 12

Double metal dowel (F566) x 12

Allen Key (F36) x 1

50mm Screw (F49) x 12

Shelf support (F121) x 2

13mm Screw (F63) x 8

Mini block (F25) x 4

13mm Screw (F79) x 24

Hinge plate

(F523) x 4 Hinge (F522) x 4

Handle (F273) x 2

Tools required

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Bracket (F945) x 12

18mm Screw (F411) x 4

Finished

top edge

Finished

top edge

Assembly Instructions

Step 1

Step 2

x 2

Prepare the 2 end

panels

Screw 2 metal dowels

into each od the 2 end

panels .

Note: Tighten the metal

dowels up fully against

the panels.

80% x 3

90% x 1

Prepare 1 of the back

brace panels

Insert 4 large locking

nuts into a back

brace .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Tap a wooden dowel

into the back brace .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Step 3

10mm

42mm

Fit the back brace to

an end panel

Push the back brace

onto a end panel .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the back brace .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

42mm

Top

edge

Top

edge

Assembly Instructions

Step 4

Prepare the 2 left

plinths

Insert a large locking

nut into each of the 2

left plinths .

Tap a wooden dowel

into each of the 2 left

plinths .

Step 5

Finished

front edge

Finished

front edge

5x 2

x 2

Prepare the 2 right

plinths

Insert a large locking

nut into each of the 2

right plinths .

Tap a wooden dowel

into each of the 2 right

plinths .

Prepare 1 of the

divider panels

Fit 2 hinge plates

onto a divider ,

making sure that the slot

is facing towards the

finished front edge.

Gently tap 2 mini blocks

. into the divider ,

orientated as shown. O

Step 6L

Note: The right plinths

have identification marks.

Finished

front edge

The right plinth

will have an

Identification mark

Finished

top edge

Assembly Instructions

Step 7

Fit a right plinth and a

left plinth

Attach a right plinth

to the end panel

using 1 screw and

tighten it using the allen

key .

Attach a left plinth to

the end panel using 1

screw and tighten it

using the allen key .

Finished

front edge

Note: Support the left

plinth and the back brace

until the divider has been

fitted in the next step.

Step 8

Fit the divider

Tap 3 large wooden

dowels through the

divider and into the

left plinth , the right

plinth and the back

brace until they

‘’bottom out’’.

Step 9

Fit the double metal

dowels

Tap 4 double metal

dowels through the

divider and into the

left plinth , the right

plinth and the back

brace until they

‘’bottom out’’.

Assembly Instructions

Step 10

Secure the divider

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the left plinth , the

right plinth and the

back brace .

Step 11

Prepare 1 of the back

brace panels

Insert 4 large locking

nuts into a back

brace .

42mm

Top

edge

x 2

Step 12

Prepare the 2 middle

plinths

Insert 2 large locking

nuts into each of the

2 middle plinths .

Finished

front edge

Assembly Instructions

Step 13

Step 15

Step 14

Fit the middle plinths

and the back brace

Push both of the middle

plinths and the back

brace onto the

divider .

Prepare the other

divider panel

Fit 2 hinge plates

onto the divider ,

making sure that the slot

is facing towards the

finished front edge.

Gently tap 2 mini blocks

. into the divider ,

orientated as shown.

Secure the divider

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the 2 middle plinths

and the back brace .

Note: Support the middle

plinth and the back brace

until the divider has been

fitted in the next step.

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Jenson 930/7450 Bedienungsanleitung

Argos

Argos Beech Effect TV Bench 609/0162 Bedienungsanleitung

Argos

Argos SASHA 609/5600 Bedienungsanleitung

Argos

Argos Medium Pink Velvet Ottoman 419/8688 Bedienungsanleitung

Argos

Argos Adele 257/6549 Bedienungsanleitung

Argos

Argos Jonas 887/3710 Bedienungsanleitung

Argos

Argos Zest 245/7558 Bedienungsanleitung

Argos

Argos Canterbury 4 DR 6 DRW ROBE Bedienungsanleitung

Argos

Argos Tolga 483/8364 Bedienungsanleitung

Argos

Argos Home 2FT6 Josie 404/9373 Bedienungsanleitung

Argos

Argos New Penton 258/7129 Bedienungsanleitung

Argos

Argos 402/8583 Bedienungsanleitung

Argos

Argos York 161/6297 Bedienungsanleitung

Argos

Argos Alfie Bedienungsanleitung

Argos

Argos Valencia 633/7777 Bedienungsanleitung

Argos

Argos HOME New Pagnell 622/1168 Bedienungsanleitung

Argos

Argos Hygena Genoa 481/2380D Bedienungsanleitung

Argos

Argos 603/4135 Bedienungsanleitung

Argos

Argos Adele 247/9866 Bedienungsanleitung

Argos

Argos New Sywell 5 Drawer Chest Bedienungsanleitung

Argos

Argos Scandinavia Bedienungsanleitung

Argos

Argos Mia 8573429 Bedienungsanleitung

Argos

Argos 473/8639 Bedienungsanleitung

Argos

Argos Aubrey 549/6516 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung