Argos Malibu 279/6288 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 40cm

Depth - 49cm

Height - 72.5cm

Malibu - 3 Drawer Filer

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 4 - 30/06/14

Important - Please read these instructions fully before starting assembly

279/6288

258/3422

ALR3069

Issue 2 - 18/03/13 - Argos code added for Oak - 617/3917

Issue 3 - 08/04/14 - New BQSP version.

Issue 4 - 30/06/14 - Changed File Base to 325 x 320mm.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 17kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 1, 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Tools required

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Electric drill

(only use when

drilling into walls)

Components - Panels

Please check you have all the panels listed below

1 2

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

5 6

14 15 File Bar (FBAR334)

(334mm long) x 2

Left Side (D2793A)

(706 x 444mm)

Top (D2792A)

(397 x 490mm)

Rail (D2796A)

(362 x 80mm) x 2

Back (X807)

(390 x 650mm)

Drawer Front (D2797A)

(358 x 156mm) x 2

Right Side (D2794A)

(706 x 444mm)

Drawer Back (W331-124)

(331 x 124mm) x 2

Left Drawer Side (W370-124LH)

(370 x 124mm) x 2

Right Drawer Side (W370-124RH)

(370 x 124mm) x 2

9Drawer Base (T342-367)

(342 x 367mm) x 2

File Side (W414)

(314 x 120mm) x 2

10 File Front (D2798A)

(358 x 300mm)

11 File Back (D2795A)

(338 x 253mm)

13 File Base (T320-320)

(325 x 320mm)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 6

Metal dowel (F901) x 10

Large locking

nut (F900) x 2

Small locking

nut (F3) x 8

Nail (F51) x 14

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

40mm Screw (F910) x 4

13mm Screw (F52) x 6

13mm Screw (F63) x 6

25mm Screw (F50) x 3

Handle (F631) x 3

Drawer runner (F1004) x 4

9mm Screw (F74) x 4

Knock-in Peg (F171GY) x 8

R Runner (F160) x 1

L Runner (F161) x 1

L Runner (F159) x 1

R Runner (F162) x 1

9mm Screw (F73) x 8

Wedge panel holder

(F248) x 2

15mm Screw (F116) x 2

Wedgefix (F639) x 4

Plastic Nail (F91) x 4

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

80%

x 2

Step 2

Prepare the 2 drawer

fronts

Screw 2 metal dowels

into each of the drawer

fronts .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and the right

drawer side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 3

Attach the drawer

sides to the drawer

fronts

Push the left drawer sides

. and right drawer sides

. onto the back of the

drawer fronts .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Assembly Instructions

Step 4

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

Step 6

6 7

Attach the handles

Attach a handle to

each of the drawer fronts

. using screw .

Note: Do not

overtighten the screw.

6 7

Step 7

Fit the wedgefixes

Turn the drawer

assemblies over and

slide 2 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

x 2

Assembly Instructions

Step 8

Step 9

Step 10

Prepare the file front

and the file back

Screw 2 metal dowels

into the holes shown on

the back of the file front

. .

Screw 2 metal dowels

into the holes shown on

the file back .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the file sides

Insert 2 small locking

nuts into the holes

shown on each of the file

sides .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Assemble the file

front and file sides

a: Push 2 file sides

onto the back of the file

front as shown.

b: Turn the 2 small

locking nuts on the

file sides clockwise

to secure them - more

than 1/2 a turn.

x 2

10 11

Small groove

Fit the file back

Push the file back

down onto the 2 file

sides and 2 file bars

. .

Turn the 2 locking nuts

on the file sides

clockwise to secure

them - more than 1/2 a

turn.

Note: Make sure that

the file base is

pushed into the groove

in the file back .

Assembly Instructions

Step 11

Fit the file base

Slide the file base

between the slots in the

2 file sides and push

it down onto the file front

. .

Fit the file bars

Push the 2 file bars

down into the holes on

the file front .

Step 12

Step 13

325mm

Assembly Instructions

Step 14

Step 16

R d

R c

Runners must be

pushed up against

the file front

Fit runners to the file

drawer

Turn the file drawer

assembly over.

Fit runner , marked

with ‘DR’, to the bottom

edge of the right file side

. , as shown, making

sure that it is pushed up

against the back of the

file front . Use a

bradawl to mark the

fixing positions, then

secure with 2 screws .

Fit runner , marked

‘DL’, to the bottom edge

of the left file side

using the same method.

Step 15

R d

R c

Attach the handle

Attach a handle to the

file front using screw

. .

10 C

Left side

Right side

Q Q

Secure the file base

Place the wedge panel

holders onto the file

base , pushing them

up against the back of

the file front .

Screw the wedge panel

holders into the 2

mark holes using screws

. .

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 17

Finished

front edge

Finished

front edge

Finished

front edge

Prepare the left side

a: Place 2 runners on

the left side as

shown. Slide back the

top of runner and use the

2nd hole from the front

to fit the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the left side .

c: Fit the runner to

the left side .

The 1st screw uses

the 2nd hole in from the

front of the runner .

The 2nd and 3rd screws

. use the holes that line

up with the other panel

holes.

Fit a screw into the

2nd hole in at the top of

the runner .

Insert a large locking

nut into the left side

. .

Note: The arrow on the

locking nuts must point

towards the hole in the

edge of the panel.

Tap a wooden dowel

into the left side .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

10mm

R a

Finished front edge

1st

screw

2nd

screw

3rd

screw

R a

Finished front edge

R a

Dieses Handbuch passt für folgende Modelle

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Amersham 706/1262 Bedienungsanleitung

Argos

Argos 906/3983 Bedienungsanleitung

Argos

Argos 935/5189 Bedienungsanleitung

Argos

Argos New Hallingford Bedienungsanleitung

Argos

Argos Vegas 600/6479 Bedienungsanleitung

Argos

Argos Misaki 632/4546 Bedienungsanleitung

Argos

Argos 719/1792 Bedienungsanleitung

Argos

Argos Puerto Rico 368/9277 Bedienungsanleitung

Argos

Argos 906/4638 Bedienungsanleitung

Argos

Argos Romantic Large 653/9441 Bedienungsanleitung

Argos

Argos HOME Mia 8459866 Bedienungsanleitung

Argos

Argos 408/5935 Bedienungsanleitung

Argos

Argos High Back Sofa Set 743/7377 Bedienungsanleitung

Argos

Argos 832/7149 D Bedienungsanleitung

Argos

Argos Lydiard Gloss 2008952 Bedienungsanleitung

Argos

Argos RETRO 213/3274 Bedienungsanleitung

Argos

Argos St-Oil Bedienungsanleitung

Argos

Argos 459/1591 Datenblatt

Argos

Argos Dalton 246/6422 Bedienungsanleitung

Argos

Argos 609/0117 Bedienungsanleitung

Argos

Argos Kids Sywell Bedienungsanleitung

Argos

Argos 1838800 Bedienungsanleitung

Argos

Argos Contempo 227/6887 Bedienungsanleitung

Argos

Argos Wow Raye 322/5837 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung