Ariens Compact 24 LE Bedienungsanleitung

Quick Start Guide

Compact 24 LE (920014 s/n 35000 - 74999)

•Step 1: Unfold Handlebars

•Step 2: Install Discharge Chute

•Step 3: Install Discharge Chute Crank

•Step 4: Install Remote Deflector Cable

•Step 5: Check Function of Dual Handle Interlock

•Step 6: Check Tire Pressure

•Step 7: Check Auger Gearcase Oil

•Step 8: Check Engine Crankcase Oil

•Step 9: Fill Engine Fuel Tank

•Step 10: Starting the Engine

•Step 11: Stopping the Engine

READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.

IMPORTANT: READ OPERATOR’S MANUAL AND ENGINE MANUAL

THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES

BEFORE OPERATING.

Step One:

Unfold Handlebar

1. Remove the lower and loosen the upper hardware on the

handlebar assembly.

2. Loosen the hardware on the shift rod.

3. Put the speed selector lever in the sixth forward position.

4. Rotate the handlebar into operating position.

NOTE: Be careful not to damage cable spring hooks when rotating

handlebar upward.

5. Install and tighten the hardware on the handlebar assembly

and shift rod.

6. Check tension on auger and traction clutch cables.

IMPORTANT: Cables should not be slack nor under tension.Adjust

as necessary.

Step Two:

Install Discharge Chute

1. Grease underside of discharge chute ring (if not already

greased).

2. Remove mounting hardware from the bottom of the chute

pedestal mount.

3. Install discharge chute over opening in the auger housing

and secure pedestal to auger housing with hardware

removed above.

Step Three:

Install Discharge Chute Crank

1. Slide Chute Crank through the opening in the control panel.

NOTE: Be careful not to damage nylon bushing when attaching

crank to the dash.

2. Connect the chute crank to the pinion gear on discharge

chute with hairpin.

Step Four: Install Remote

Deflector Cable

1. Slide cable through clip on top of discharge chute pedestal.

2. Bend clip closed around cable.

3. Using the wire hook attached to the deflector cable, hook

cable to discharge chute crank.

4. Pull rubber seal cap away from snap fitting.

5. Install snap fitting into cable bracket’s mounting hole located

under the dash.

6. Position rubber seal cap over the top of snap fitting.

7. Move deflector control lever to rear most position.

8. Attach cable eye to pin on bottom of deflector control lever.

NOTE: Hold down chute deflector cap, if needed, for more cable

slack.

9. Secure cable eye to control lever with washer and hairpin.

10. Test controls to be sure deflector works properly.

NOTE: If deflector does not follow full range of travel See Remote

Discharge Deflector Control Adjustment (920014) in Owners

Manual.

Step Four: Install Remote

Deflector Cable Cont.

Step Five:

Check Function of Dual Handle Interlock

Without the engine

running, press down

(engage) both clutch

levers. Release

attachment clutch lever.

Attachment clutch should

remain engaged until

traction clutch lever is

released, then both

clutches must disengage.

If they do not, contact your

dealer for repairs.

Step Six:

Check Tire Pressure

Check tire pressure and

adjust to the pressure

listed on tire sidewall.

Check oil level in auger

gearcase

(see Check Auger

Gearcase in Owners

Manual).

Step Seven:

Check Auger Gearcase Oil

IMPORTANT: The engine

is shipped with oil

in crankcase. Refer to

Engine Manual for

detailed instructions.

Step Eight:

Check Engine Crankcase Oil

Andere Handbücher für Compact 24 LE

Inhaltsverzeichnis

Andere Ariens Schneefräse Handbücher

Ariens

Ariens 926310-ST9526DLE Betriebsanleitung

Ariens

Ariens 921011 Betriebsanleitung

Ariens

Ariens Hydro Pro Track 32 Bedienungsanleitung

Ariens

Ariens 932308 Bedienungsanleitung

Ariens

Ariens 921023 - Deluxe Track 28 Betriebsanleitung

Ariens

Ariens Sno-Thro Pro 28 926038 Betriebsanleitung

Ariens

Ariens 924054 Bedienungsanleitung

Ariens

Ariens AMP 24 Sno-Thro Bedienungsanleitung

Ariens

Ariens 916003 - AMP 24 Bedienungsanleitung

Ariens

Ariens 924000 Bedienungsanleitung

Ariens

Ariens Sno-Thro 932001 Bedienungsanleitung

Ariens

Ariens PLUS 937 Series Bedienungsanleitung

Ariens

Ariens Sno-Thro ST8526LE Bedienungsanleitung

Ariens

Ariens Compact 24 Bedienungsanleitung

Ariens

Ariens Power Brush 36 Bedienungsanleitung

Ariens

Ariens Sno-Thro Compact Series Bedienungsanleitung

Ariens

Ariens 932105 8526 932506 8526 Betriebsanleitung

Ariens

Ariens SNO-THRO 924318-ST824 Betriebsanleitung

Ariens

Ariens Sno-Thro 938017 Betriebsanleitung

Ariens

Ariens Sno-Thro 926 Series Referenzhandbuch

Ariens

Ariens Sno-Thro 926 Series Bedienungsanleitung

Ariens

Ariens 938030-SS21 Bedienungsanleitung

Ariens

Ariens Professional Sno-Thro Series Bedienungsanleitung

Ariens

Ariens Sno-Thro Compact Series Bedienungsanleitung

Beliebte Schneefräse Handbücher anderer Marken

Murray

Murray 624504X4A Bedienungsanleitung

Blizzard

Blizzard POWER PLOW 8100PP Bedienungsanleitung

Craftsman

Craftsman 486.24837 Bedienungsanleitung

Yard-Man

Yard-Man E2B5 Bedienungsanleitung

ST ST 526 A Bedienungsanleitung

MTD

MTD 3AA Bedienungsanleitung

Toro

Toro Power TRX 1428 OHXE Bedienungsanleitung

Ryobi

Ryobi RYAC800 Bedienungsanleitung

Poulan Pro

Poulan Pro 416829 Bedienungsanleitung

Poulan Pro

Poulan Pro 437986 Bedienungsanleitung

MTD

MTD 319-180-00 Bedienungsanleitung

Brute

Brute 1695565 Bedienungsanleitung

Egholm

Egholm City Ranger 2250 Bedienungsanleitung

Poulan Pro

Poulan Pro 420915 Bedienungsanleitung

GreenWorks

GreenWorks SNF402 Bedienungsanleitung

LOFTNESS

LOFTNESS 601D1 Bedienungsanleitung

LOFTNESS

LOFTNESS 1082I Bedienungsanleitung

LOFTNESS

LOFTNESS 481EL Bedienungsanleitung