Arrow COMMANDER SERIES Bedienungsanleitung

www.arrowsheds.com

01AG

NOTE: These instructions are to be used to add a rear door to an existing Arrow

Commander™ or Mountaineer™ Shed. If you are assembling a Commander™

or Mountaineer™ Shed as well as a Door Kit, use the manual included in the

main carton (C1GA).

Follow all safety precautions in the Commander™/Mountaineer™Series

Assembly Manual.

Two to three people are required for assembly.

Note: It may be helpful to refer to the primary Commander™/Mountaineer™ Series Assembly Manual you used when you ﬁ rst assembled your

building. If you have misplaced your original Commander™/Mountaineer™ Series Assembly Manual, it is available online at www.arrowsheds.com

or you may request an additional copy from customer service: 1-800-851-1085.

COMMANDER™SERIES

Gloves must be worn

at all times to reduce

risk of injury!

719670514

* See Inside for Detailed Safety Information.

MOUNTAINEER

™SERIES

(Door Kit)

Owner’s Manual

& Assembly Guide

BEFORE YOU BEGIN...

Safety precautions MUST be followed at all times throughout the construction of your building!

•Care must be taken when handling various pieces of your building since

many contain sharp edges. Please wear work gloves, eye protection and long

sleeves when assembling or performing any maintenance on your building.

•Practice caution with the tools being used in the assembly. Be especially

familiar with the operation of all power tools.

•Keep children and pets away from the worksite during construction. Do not

allow children to help with assembly.

•Do NOT attempt to assemble this kit on a windy day. The large panels can

catch the wind like a “sail”, causing them to be whipped around making

construction difﬁ cult and unsafe.

•At least two people must work together to assemble this kit. This will make

assembly faster and easier.

•You must securely anchor once assembled in the same manner as your

existing Commander™/ Mountaineer™ Shed.

•NEVER concentrate your weight on the roof of the building. When using a

step ladder make sure that it is fully open and on even ground before climbing

on it.

02J

Below is a list of things you will need for installation.

• Work Gloves

• Safety Glasses

• Step Ladder

• No. 2 Phillips Screwdriver (Magnetic Tip Preferred)

• Utility Knife or Scissors

• Pliers

• Carpenter’s Level

• Tape Measure

• Power Drill (Cordless, Variable Speed)

• Nut Driver or Wrench

• Square

• String (for squaring the frame)

• Awl (to align holes)

WHAT YOU NEED

RECOMMENDED TIME SAVERS

HARDWARE LIST...

03AG

11/32 Hex.

Key Part Part Qty.

No. No. Description List

1 65103 Hex Nut (#8-32) 122

2 65106 Square Nut (#10-32) 20

3 65923 Small Bolt (#8-32 x 3/8) (10 mm) 86

4 65943 Large Bolt (#10-32 x 7/16) (11 mm) 14

5 65004 Small Screw (#8AB x 5/16) (8 mm) 112

6 66611 Large Screw (#10AB x 1/2) (13 mm) 133

7 66625 Long Bolt (#10-32 x 3/4) (19 mm) 2

8 66783 Flat Head Screw (#8-32 x 1/2) (13 mm) 36

9 66646 Washer Sheet 4

10 66609 Hinge 6

11 66778 Lock Eyelet 1

12 66781 Spring Latch 1

13 67293 Weather Stripping 1

14 10651 Latch Plate 3

15 66779 Slide Bolt 1

16 66780 Cane Bolt 2

17 66782 Door Handle 2

#2 Phillips

10 12

#2 Phillips

LNB

#2 Phillips

#10-32

16 17

Various fasteners are used throughout the

construction of your kit. In each step you will

see the abbreviations listed below used in the

illustrations to help you identify which fastener

to use. The fasteners used in each step are shown actual size at

the top of each page. If you are unsure which fastener to

use, hold it up to the picture and use the one that matches.

SB - Small Bolt

SS - Small Screw

LB - Large Bolt

LS - Large Screw

FS - Flat Head Screw

LNB - Long Bolt

At the top of each page you will see

one or more Part Cues like the one

to the right. These Part Cues are

designed to help you quickly identify

the parts needed for each step.

10629

Rear Frame

Part No.

Quantity Needed

End View

Part Name

QTY 18

Hardware Views by Key No.

Key

No.

Part

No.

Part

Description

Qty.

List

110618 Front Wall Panel 2

210622 Right Door Jamb 1

380037 Left Door Jamb 1

410627 Front Wall Channel 6

510628 Front Wall Diagonal 4

610638 Long Fascia 1

710639 Short Fascia 1

810640 Wall Post 2

910652 Wall Post (Hinge) 2

10 10673 Front Frame 2

11 10623 Door Panel (Hinge) 2

12 10624 Right Door Panel 1

13 80051 Left Door Panel 1

14 10635 Horizontal Door Brace 4

15 10678 Vertical Door Brace (Latch) 2

16 10637 Vertical Door Brace (Hinge) 2

17 10647 Top Door Trim 2

18 10648 Door Astragal 2

19 10626 Door Diagonal Brace 8

20 10636 Vertical Door Brace 4

21 10675 Cane Bolt Bracket 2

22 69835 Edge Trim (Green) 2

1918

20 2221

PARTS LIST...

04AG

Selected End Views by Key No.

Confirm that all hardware

and parts are present before

attempting to assemble your kit.

For missing or damaged parts,

contact Customer Service. Do not

return to store.

Part Numbers

Part Number

1. Each part has an identifying part number on it.

2. Part Numbers are referenced in each step.

3. Unpainted parts have a stamped in number and painted

parts have a number that is inked on.

Remove inked on numbers with soap and water after assembly.

Customer Service:

1-800-851-1085 or

[email protected]

UnpaintedPainted

Painted

Unpainted

ASSEMBLY BY KEY NO.

05AG

Left Door

19 19

Right Door

Door Kit

1 8

Step 1: Disassemble Rear Wall

Remove the rear Roof Trim Caps and Roof Trim

from both sides of building.

Remove Peak Cap and four (4) Bolts and Nuts from

rear Ridge Cap.

Remove the last full-size Roof Panel and End Roof

Panel from both sides of building.

Remove the rear Ridge Cap by removing two (2)

Bolts and Nuts towards middle of building.

06AG

IMPORTANT: Take care in

removing parts from building.

They will be reused later.

Remove Parts:

• Roof Trim Cap (2)

• Roof Trim (2)

• Peak Cap (1)

• Roof Panel (2)

• End Roof Panel (2)

• Ridge Cap (1)

don’t focus weight

on roof

Remove four (4) Bolts

at end of Ridge Cap.

Remove Roof Trim Remove last

two (2) bolts.

Step 1: Continued

Install Edge Trim to top edge of Gables.

Remove Roof Beam Brace.

Remove two (2) side and main Roof Beams.

Remove Gable Brace, Track Supports, and Gables.

07AG

Edge Trim MUST

cover Gable edge.

Remove Parts:

• Roof Beam Brace (1)

• Roof Beam (4)

• Gable (2)

• Track Support (2)

• Gable Brace (1)

Install Edge Trim to cover

Gable Edge BEFORE doing

ANY work with Gables.

Failure to do so could result

in injury.

Edge Trim

69835

IMPORTANT: Take care in

removing parts from building.

They will be reused later.

69835

You will need for this page:

Step 1: Continued

Remove last Wall Panel from both sides of the building. Remove top,

middle, and bottom Screws on Adjacent Wall Panel as shown.

Remove Side Wall Channel.

08AG

Remove Parts:

• Wall Panel (2)

• Side Wall Channel (2)

Remove

IMPORTANT: Take care in

removing parts from building.

They will be reused later.

Step 1: Continued

Remove rear wall from building.

Remove Anchor Bolts from rear wall.

Remove rear Corner Panels.

09AG

IMPORTANT: TWO (2) PEOPLE SHOULD BE SUPPORTING

THE REAR WALL AS IT IS UNFASTENED!

Remove Parts:

• Corner Panel (2)

IMPORTANT: Take care in

removing parts from building.

They will be reused later.

Step 2: New Rear Wall Assembly

10AG

You will need for this page:

(QTY: 24)

(QTY: 34)

Insert Front Wall Diagonals into the Front

Wall Assembly as shown and secure with

Large Screws.

10640

Wall Post

210652

Wall Post

(Hinge)

210627

Front Wall

Channel

610628

Front Wall

Diagonal

Left Front Wall Assembly

10640

10652

10627

10628

10673

10639

Fascia pieces should ﬁ t inside Front Frame as shown.

10673

10638

10639

10673

Front Frame

10638

Long Fascia

110639

Short Fascia

Lay out the parts and position them as

shown. Double check that holes align as

shown. If holes do not align, the Wall Post

(Hinge) is most likely upside-down.

Insert the Front Wall Channels into the

Wall Post and Wall Post (Hinge) as shown

and secure with Small Bolts and Nuts.

Assemble two (2) Front Frames together

with the Long and Short Fascias as shown

below and secure using Large Screws.

Right Front Wall Assembly

Door Header Assembly

SB SB

LS SB

SNAP

10627

Part 10627 Front Wall Channel may be joined in

pairs. Bend to separate.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Arrow Außenlagerung Handbücher

Arrow

Arrow EH108-A Gebrauchs- und Pflegehandbuch

Arrow

Arrow LM109 Gebrauchs- und Pflegehandbuch

Arrow

Arrow ED108 Gebrauchs- und Pflegehandbuch

Arrow

Arrow HM101267-A1 Gebrauchs- und Pflegehandbuch

Arrow

Arrow EZ8772HVCR Bedienungsanleitung

Arrow

Arrow ES1014 Gebrauchs- und Pflegehandbuch

Arrow

Arrow PS43 Series Gebrauchsanweisung

Arrow

Arrow EN108-A Gebrauchs- und Pflegehandbuch

Arrow

Arrow HM10867 Gebrauchs- und Pflegehandbuch

Arrow

Arrow VD1012-D1 Gebrauchs- und Pflegehandbuch

Arrow

Arrow FDN54 Gebrauchs- und Pflegehandbuch

Arrow

Arrow CPH101507 Gebrauchsanweisung

Arrow

Arrow CL72-A Gebrauchs- und Pflegehandbuch

Arrow

Arrow VD108-A Gebrauchs- und Pflegehandbuch

Arrow

Arrow LW108FB Gebrauchs- und Pflegehandbuch

Arrow

Arrow SCG1012CC Series Gebrauchsanweisung

Arrow

Arrow CM1014-A1 Gebrauchs- und Pflegehandbuch

Arrow

Arrow VT1210-A Gebrauchs- und Pflegehandbuch

Arrow

Arrow CLG108CC Gebrauchsanweisung

Arrow

Arrow CPHC202007 Gebrauchsanweisung

Arrow

Arrow CLG1014CC Bedienungsanleitung

Arrow

Arrow ES109 Gebrauchs- und Pflegehandbuch

Arrow

Arrow ED65 Gebrauchs- und Pflegehandbuch

Arrow

Arrow SpaceMaker PS53EU Series Gebrauchsanweisung

Beliebte Außenlagerung Handbücher anderer Marken

USP

USP DURAMAX 10 Ft x 8 Ft StoreMax Plus Bedienungsanleitung

TYGO

TYGO Nyland Bedienungsanleitung

Duratuf

Duratuf GL105 Bedienungsanleitung

Viking

Viking SD5300SS Technisches Handbuch

USP

USP DURAMAX Apex Pro 10.5 Ft x 8 Ft 40116 Bedienungsanleitung

ModuLaro

ModuLaro Lojo WC202200 Bedienungsanleitung

Lifetime

Lifetime 6418 Bedienungsanleitung

rollaway container

rollaway container ARPCA24 Bedienungsanleitung

Duratuf

Duratuf Havelock Bedienungsanleitung

X-METAL

X-METAL 4065 Bedienungsanleitung

Outdoor Life Products

Outdoor Life Products FP2030 F Bedienungsanleitung

Royalcraft

Royalcraft Faro 295L Storage Box Bedienungsanleitung

Riverlea

Riverlea Duratuf KIWI KS3 Bedienungsanleitung

OLT

OLT GS84D-FJ-Plywood Bedienungsanleitung

Rubbermaid

Rubbermaid 5L45 Bedienungsanleitung

garofalo

garofalo TUSCANY EVO Bedienungsanleitung

Duratuf

Duratuf Kiwi MK1 Bedienungsanleitung

Eden

Eden CA2988 Bedienungsanleitung