02
6" Finishing Palm Sander - 3/32" Stroke
325/325P
INTENDED USE OF THE TOOL
This sander is designed for sanding metal, plastic and painted surfaces to strip paint for fine finishes.
Do not use this tool outside of the designed intent. Never modify the tool for any other purpose or use.
BEFORE USE
Before use, check the parts diagram and part number listing on page 5 to make sure all parts are
included. If any parts are missing or damaged, please call your distributor.
SPECIFICATIONS:
Pad Size: 6"
Free Speed: 10,000rpm
Overall Length: 7" (17.78cm)
Net Weight: 1.5lbs. (.68kg)
Spindle Thread Size: 5/16" x 24
PRODUCT INFORMATION
Air Inlet Thread NPT: 1/4" (6mm)
Air Hose I.D. Size: 3/8" (10mm)
Avg. Air Consumption: 5.5cfm
Air Pressure: 90psi
CAUTION: TO HELP PREVENT PERSONAL INJURY.
• Use of this product can expose you to chemicals such as phthalates which are known to the State of
California to cause cancer, and birth defects or othe reproductive harm. For more information go to
www.P65Warnings.ca.gov/product.
Always wear ANSI approved safety equipment, safety glasses and clothing when using this product.
Study, understand, and follow all instructions provided with this product. Failure to read and follow
all warnings and operating instructions may result in damages and serious injury or death.
• Always wear ANSI approved goggles when using this product. (Users and Bystanders).
• Never use this tool for any application other than for which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the tool, modification of the tool, or use of the tool with
accessories not designed for it could result in serious injury or death.
• Always select the correct accessories of the correct size and design for the job that you are
attempting to perform.
• Always work in a clean, safe, well-lit, organized and adequately equipped area.
• Do not begin repairs without assurance that vehicle is in secure position, and will not move during repair.
• Users of this tool should review the chemical composition of the work surface and any products used in
conjunction with this tool for any such chemicals prior to engaging in any activity that creates dust
and/or microscopic particles.
• Users should obtain the Material Safety Data Sheets for all identified chemicals, either from the manu-
facturer or their employer, and proceed to study, understand, and follow all instructions and warnings
for exposure to such chemicals.
• Some examples of these chemicals are: lead from lead based paints; crystalline silica from bricks,
cement and other masonry products; and arsenic and chromium from chemically treated lumber. A
listing of the chemicals can be obtained at www.oehha.ca.gov under Propoisition 65.
• In order to reduce their exposure to such chemicals, users should always:
- work in well-ventilated areas.
WARNING
- wear appropriate safety equipment and clothes that are
specifically designed to filter out microscopic particles.
• Sealed Bearings for Extended Life
• 3/32" (2.5mm) stroke finish
• Super lightweight (1.5lbs.) and compact for
minimum operator fatigue
• Built-in speed regulator
• Low noise and vibration design
• Accessories: #4606 - 6" PU Velcro Backing Pad
#4608 - 6" PSA Backing Pad
