ASUSTOR AS6704T Bedienungsanleitung
Network Card Installation Guide
For ASUSTOR AS6704T/AS6706T NAS
Ver. 4.0.0116
ASUSTOR NAS Network Card Installation Guide
Page 2 of 10
Table of Contents
1. Installation Guide .............................................................................................................3
1.1. Parts and Tools Needed...............................................................................................4
1.2. Removing the Cover....................................................................................................4
1.3. Installing a Network Card.................................................................................................5
1.4. Replacing the Cover....................................................................................................8
2. Appendix ..................................................................................................................... 10
2.1. Troubleshooting ....................................................................................................... 10
2.2. Contact ASUSTOR Technical Support............................................................................ 10
ASUSTOR NAS Network Card Installation Guide
Page 3 of 10
1.
I
In
ns
st
ta
al
ll
la
at
ti
io
on
n
G
Gu
ui
id
de
e
1. To add a 10-Gigabit Ethernet card, install ASUSTOR NAS PCIe Mode Switcher from App Central.
2. Select 10G NIC and press apply.
ASUSTOR NAS Network Card Installation Guide
Page 4 of 10
3. Click OK
4. After confirmation, your NAS will shut down. After shutting down, you will now be able to install the
10-Gigabit Ethernet card after disconnecting your NAS from mains electricity.
1.1.Parts and Tools Needed
Phillips head screwdriver
1.2. Removing the Cover
Disconnect all cables and devices connected to the NAS including the power cord.
AS6704T
AS6706T
Note. The PCIe socket inside your NAS does not support hot swap functionality. Please shut down and unplug
your NAS before changing between PCIe devices.
Use a screwdriver to loosen the three screws found on the rear of the NAS as shown in the illustration.
AS6704T
AS6706T
ASUSTOR NAS Network Card Installation Guide
Page 5 of 10
Grip the cover from both sides with two hands and then gently push it back to remove it from the
chassis.
1.3. Installing a Network Card
1. To remove the M.2 card, undo the screws as shown below.
AS6704T
AS6706T
2. Gently pull the M.2 card from the PCIe slot as shown below.
AS6704T
AS6706T
ASUSTOR NAS Network Card Installation Guide
Page 6 of 10
3. Undo the two screws that hold the bracket for the M.2 card in place.
AS6704T
AS6706T
4. Lift the bracket out of the NAS.
AS6704T
AS6706T
5. Remove both screws in the rear of the NAS and placeholder bracket.
AS6704T
AS6706T
ASUSTOR NAS Network Card Installation Guide
Page 7 of 10
6. Unscrew and remove full-height bracket from AS-T10G2 NIC. Installation of the AS-T10G2 requires use of the
included bracket designed for the Lockerstor Gen2 series of NAS devices.
7. Attach NAS-specific bracket to the AS-T10G2 and fasten screws.
8. Gently insert the network card into the PCIe slot of your NAS.
AS6704T
AS6706T
ASUSTOR NAS Network Card Installation Guide
Page 8 of 10
9. Fasten the network card to the NAS with screws.
AS6704T
AS6706T
10. Follow these instructions in reverse order to reinstall the M.2 card.
1.4. Replacing the Cover
Replace the cover and tighten the three screws that were removed previously.
AS6704T
AS6706T
ASUSTOR NAS Network Card Installation Guide
Page 9 of 10
Reconnect all cables including the power cord and then start up the NAS.
AS6704T
AS6706T
ASUSTOR NAS Network Card Installation Guide
Page 10 of 10
2.
A
Ap
pp
pe
en
nd
di
ix
x
2.1. Troubleshooting
Q: After installing network card my NAS won’t start. What’s wrong?
A: Please follow the steps below to resolve this issue:
1. Check if the LED indicators, system buzzer, and LCD display panel are operating normally.
2. If your NAS is unable to recognize the network card or cannot be started up properly, please check that
you have used network card that is compatible with the system. Also, please reinstall the network card in
order to confirm that it has been installed properly.
3. If your NAS still does not operate normally, please remove the newly installed network card, and then
restart the NAS to see if it is able to operate normally.
4. If the previous steps have not solved your problem, please contact your local dealer or ASUSTOR
customer service.
2.2. Contact ASUSTOR Technical Support
Contact us:
1. Email: support@asustor.com
2. Online Support Form: https://www.asustor.com/service/online_support
3. ASUSTOR Online Community: https://forum.asustor.com/
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere ASUSTOR Netzwerkkarte Handbücher
Beliebte Netzwerkkarte Handbücher anderer Marken
FirstComm
FirstComm OBiWiFi5G Bedienungsanleitung
Sun Microsystems
Sun Microsystems Interface Adapter Bedienungsanleitung
TRENDnet
TRENDnet TU2-ETG Bedienungsanleitung
YASKAWA
YASKAWA SI-EN3 Bedienungsanleitung
Paradyne
Paradyne BitStorm 2600 IP DSLAM Bedienungsanleitung
Belkin
Belkin F5D7050 Bedienungsanleitung
3Com
3Com EtherLink 3C509B Bedienungsanleitung
TRENDnet
TRENDnet TEG-PCITX Bedienungsanleitung
Cisco
Cisco MC16E Bedienungsanleitung
Delta Electronics
Delta Electronics Braking Modules VFDB Series Bedienungsanleitung
TwinMOS
TwinMOS Booming Bedienungsanleitung
Dialogic
Dialogic Media Board DM/V1200BTEPEQ Bedienungsanleitung
Buffalo
Buffalo AirStation WLI-PCM-L11GP Bedienungsanleitung
National Instruments
National Instruments NI 9234 Bedienungsanleitung
Hama
Hama 49276 Bedienungsanleitung
Linksys
Linksys WCF54G - Wireless-G Compact Flash Card Bedienungsanleitung
Compaq
Compaq Wireless LAN 100 Bedienungsanleitung
Bose
Bose PowerMatch Dante Bedienungsanleitung