Operating Instructions
1. Loudspeaker 4. Inductive sensing areas 7. ON/OFF switch
2. Working Indicators (Blue) 5. Micro USB charging port 8.
Micro USB charging cable (1.2m)
3. Charging Indicator (Red) 6. AUX (line in) port 9. Right angle audio cable (0.18m)
FIGURE:
Charge your amplier
MAKE SURE THAT YOUR AMPLIFIER IS FULLY CHARGED BEFORE USING IT. A full charge is approximate-
ly 2 to 2.5 hours and plays continuously 4 hours then.
1. Connect to a USB charging cable or use an additional USB to DC adapter (not included) to charge.
2. When the Red Charging indicator turns on, the device is charging.
3. The Red Charging indicator goes off when the device is fully charged.
Broadcast music from your amplier, just Place-n-Play
1. Switch to turn “ON” the amplifier. The BLUE working indicators remain.
2. Turn on the music on your mobile phone, and place it on the inductive area.
3. Start listening to the music.
4. When the battery is low, the BLUE indicators blink continueously and the amplifier turns off automatically in
two minutes. Please charge your amplifier immediately.
5. Please switch to turn OFF the amplifier if you don’t use it for a long time to prolong the battery life.
Connect to other music equipment
Connect to other portable media players to the AUX line-in port on the amplifier using the supplied
cable.
PLEASE NOTE:
This product works perfect with speaker-placement at either side of the diagonal of the mobile
phones. The audio amplification effect of the mobiel phones may be affected or failed for the speaker
position is not in the inductive sensing area.
This product is an inductive audio amplifier, any signal interference sound from the phone will be
amplified. It’s not the product defective. Please re-adjust the phone's reception angle or strengthen
signal receiving in order to achieve a better audio amplification effect.
Troubleshooting
Q: Can not turn on the amplifier
A: Please use the Micro USB charging cable for charging, and then turn on the amplifer again.
Q: Can’t hear sound from the amplifer
A: Check whether your device is properly placed in the sensing area.
5 6 7
DC 5V
AUX ON/OFF
1 2 3
4
8 9
