AT&T 1856 - Corded Speakerphone Bedienungsanleitung

Quick start guide

1856

Speakerphone/

answering system with

caller ID/call waiting

VOLUME

During a call, press or to

adjust listening volume.

MUTE

Press to silence the microphone.

Press again to resume

conversation.

SPEAKER

Press to turn the speakerphone

on or off (begin or end a call).

Quick reference guide

CID

When the telephone is idle,

press to display caller ID

information.

While entering numbers, press

twice to insert a three-second

dialing pause.

DISPLAY DIAL

Press to dial the number

currently displayed.

FLASH

During a call, press to receive

an incoming call if call

waiting is activated.

TAS/SETUP

Press to hear setup options.

Press and hold to change

answering system options.

CID/SETUP

Press to customize the

telephone's operation.

PROG/MEM

Press to program a number.

M1/M2/M3

Press to dial a one-touch

number.

CLOCK RESET

Press to review. Press and hold

to set the clock.

REMOVE

Press to delete caller ID currently

displayed.

REDIAL

Press to redial last number

dialed.

DELETE

Press to delete a message

currently playing.

When phone is not in use,

press and hold to delete all

old messages.

REPEAT/MEMO

Press once to repeat a

message currently playing, and

press twice to listen to the

previous messages.

Press to record a memo or

change a menu setting.

ON/OFF

Press to turn answering system

on or off.

SKIP /ANNC

Press to skip a message

or change a menu setting.

Press and hold to record an

announcement.

PLAY/STOP

When the telephone is idle, if

you have new messages, press

to play. Press again to stop

message playback.

Press and hold to play all

messages (the oldest first).

CID

When the telephone is idle,

press to display caller ID

information.

While entering numbers, press

to delete the last number

entered.

Telephone base installation

NOTES:

1. Use only the power adapter supplied with this product or equivalent. To order a

replacement power adapter, visit our website at www.telephones.att.com,

or call 1 (800) 222-3111.In Canada, dial 1 (866) 288-4268.

2. Be sure to use an electrical outlet not controlled by a wall switch.

3. The power adapters are intended to be correctly oriented in a vertical or floor

mount position. The prongs are not designed to hold the plug in place if it is

plugged into a ceiling or under-the-table/cabinet outlet.

Install the telephone as shown below. Choose a location where the telephone

is not exposed to excessive heat, cold, dust or moisture.

If you subscribe to high-speed Internet service (DSL - digital subscriber line)

through your telephone lines, you must install a DSL filter between the

telephone base and the telephone wall jack. The filter prevents noise and

caller ID problems caused by DSL interference. Please contact your DSL

service provider for more information about DSL filters.

1. Plug one end of the telephone

line cord into the telephone

jack at the back of the

telephone.

2. The small end of the power

adapter has been plugged into

the power jack in the back of

the telephone at the factory.

Double check that it has been

plugged in firmly.

3. Route the cord through the

slot as shown to the right.

4. Plug the other end of the

telephone line cord into a

telephone jack.

5. Plug the large end of the

power adapter into an

electrical outlet not controlled

by a wall switch.

DSL filter (not included)

for DSL users.

Telephone line cord

Getting started

Installation options

Tabletop mount Wall mount

NOTE: The mounting bracket must be used for both tabletop use and wall

installation options.

Telephone outlet mounting

plate with mounting studs.

Wall mounting

The telephone base comes with the bracket mounted for tabletop use. If wall

mounting is desired, a telephone outlet wall mounting plate with mounting studs is

required. This mounting plate with studs may be available for purchase from many

hardware or consumer electronics retailers and may require professional installation.

1. Hold down the switch hook on the telephone base, then slide the handset tab

upwards to remove it from the slot. Rotate the handset tab 180 degrees. Push

the handset tab down into the grooves so it settles into position.

2. To remove the bracket, hold the telephone base in both hands, press the two

bracket tabs and lift the bracket away from slots and .

Installation options

3. Rotate the bracket to the wall installation position. Plug one end of the

telephone line cord into the jack of the telephone base. Place the telephone

line cord through one channel on the bracket. Bundle the telephone line cord

and place it inside the bracket. Place the other end of the telephone line cord

through the other channel on the bracket.

4. Insert the tabs of the bracket into slots and on the telephone base, then

press the other bracket tabs into slots and as shown below.

5. Plug the power adapter into an electrical outlet not controlled by a wall switch. Plug

the other end of the telephone line cord into a telephone wall jack. To mount the

telephone on the wall, position the mounting holes and over the telephone

outlet mounting studs. Press and slide the bracket down firmly so the telephone is

held securely on the telephone outlet mounting studs.

Tabletop installation

To return the bracket from the wall installation to tabletop position, follow the

directions below.

1. Remove the telephone base from the wall. Unplug the cords from the wall

jacks. Remove the bracket from the telephone base. Remove the telephone line

cord from the channels. Untie the bundled telephone line cord.

Place the bundled telephone

line cord inside the bracket.

Installation options

Tabletop installation

2. Hold down the switch hook on the telephone base, then slide the handset tab

upwards to remove it from the slot. Rotate the handset tab 180 degrees. Push

the handset tab down into the grooves so it settles into position.

3. Rotate the bracket to tabletop position, insert the bracket tabs into slots and

on the telephone base, then press the other bracket tabs into slots and .

4. Plug one end of the telephone line cord into the telephone base. Plug the

other end into the wall jack. Plug the small end of the power adapter into

the telephone base. Route the power adapter cord through the slot. Plug

the large end of the power adapter into an electrical outlet not controlled

by a wall switch.

AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to

Advanced American Telephones, San Antonio, TX 78219.

Printed in China. Issue 9 AT&T 03/10.

www.telephones.att.com

Andere Handbücher für 1856 - Corded Speakerphone

Inhaltsverzeichnis

Andere AT&T Telefon Handbücher

AT&T

AT&T E1828B Bedienungsanleitung

AT&T

AT&T 1477/1177 Bedienungsanleitung

AT&T

AT&T Definity ISDN 7505 Bedienungsanleitung

AT&T

AT&T EL51110 Bedienungsanleitung

AT&T

AT&T CL84107 Bedienungsanleitung

AT&T

AT&T CRL82112 Bedienungsanleitung

AT&T

AT&T TL80133 Bedienungsanleitung

AT&T

AT&T Trimline TR1909 Bedienungsanleitung

AT&T

AT&T Synapse SB67020 Bedienungsanleitung

AT&T

AT&T 272 Bedienungsanleitung

AT&T

AT&T Merlin II Release 3 Bedienungsanleitung

AT&T

AT&T CN5345 Bedienungsanleitung

AT&T

AT&T 929 Bedienungsanleitung

AT&T

AT&T TL92220 Bedienungsanleitung

AT&T

AT&T CL80107 Bedienungsanleitung

AT&T

AT&T 993 2-Line Bedienungsanleitung

AT&T

AT&T U-verse TV Bedienungsanleitung

AT&T

AT&T TRIMLINE 213 Bedienungsanleitung

AT&T

AT&T 1040 Bedienungsanleitung

AT&T

AT&T CL4939 Bedienungsanleitung

AT&T

AT&T 831 Series Bedienungsanleitung

AT&T

AT&T ML17939 Bedienungsanleitung

AT&T

AT&T Trimline TR1909 Bedienungsanleitung

AT&T

AT&T SB3014 Bedienungsanleitung

Beliebte Telefon Handbücher anderer Marken

GE 2-9480 Bedienungsanleitung

Geemarc

Geemarc PHOTOPHONE 155 Bedienungsanleitung

Interquartz

Interquartz Gemini IQ333 Bedienungsanleitung

SSS Siedle

SSS Siedle HT 840-0 Bedienungsanleitung

Motorola

Motorola TITANIUM Bedienungsanleitung

Panasonic

Panasonic ICX Bedienungsanleitung

LG H870DS Bedienungsanleitung

Samsung

Samsung GT-I9500 Bedienungsanleitung

Selta

Selta zenyth 600 Bedienungsanleitung

Doro

Doro AFTI 20 Bedienungsanleitung

UNIQCELL

UNIQCELL A1 Bedienungsanleitung

Jabra

Jabra SP5050 - Bluetooth hands-free Speakerphone Bedienungsanleitung

BT Decor 425 Bedienungsanleitung

NEC

NEC SV8500 Bedienungsanleitung

Teledex

Teledex PEARL Bedienungsanleitung

Ericsson

Ericsson Dialog 3213 Bedienungsanleitung

Yealink

Yealink VP530 Bedienungsanleitung

Axess Telecom

Axess Telecom ACW-1xP800 Bedienungsanleitung