Atlantic TidalWave A-05 Bedienungsanleitung

Operating Manual

Includes Pumps:

A-05

A-21

A-31

A-315

1-877-80-PONDS

www.atlanticwatergardens.com

A-SERIES PUMPS

Introduction

Thank you for selecting the Tidal Wave A-05/A-21/A-31/A-315 series

pumps. Before using this pump please take a moment to review this

manual.

To avoid an accident

do not use the pump

in any way other than

as described in this

manual. Please note

the manufacturer

cannot be responsible

for accidents arising

because the product

was not used as

prescribed. After

reading this manual

keep it as a reference

in case questions

arise during use.

Recommended Operating Range

Best Efciency Point

HEIGHT IN FEET

GALLONS PER MINUTE

50’

45’

40’

35’

30’

25’

20’

15’

10’

5’

50 100 150 200 250 300

A05

A21

A31

A315

Performance

*Operating pumps outside of the recommended range may cause bearing damage and premature failure.

@5’ @10’ @15’ @20’ @25’ @30’ @35’ @40’ @45’ @50’ @60’

A-05 (gph) 3165 2838 2500 2154 1875 1452 933 318 0@42’

(gpm) 53 47 42 36 31 24 16 5

A-21 (gph) 5811 5324 4824 4335 3771 3141 2400 1530 540 0@47’

(gpm) 97 89 80 72 63 52 40 26 9

A-31 (gph) 9300 8148 6828 5535 4119 2535 625 0@37’

(gpm) 158 136 114 92 68 42 13

A-315 (gph) 12000 11040 10440 9780 9000 8280 7560 6780 5580 4920 2280

(gpm) 200 184 174 163 150 138 126 113 98 82 38

Prior to Operation and Installation

• Whenthepumpisdelivered,rstperformthefollowingchecks.

• Checkforanydamagetopumpandpowercablethatmayhave

occurred during the shipment.

• Checkthemodelnumbertomakesureitistheproductthatwas

ordered and verify the voltage and frequency are correct.

Caution

• DONOToperatethisproductunderanyconditionotherthanthosefor

which it is specied. Failure to observe this precaution can lead to elec-

 tricalshock,electricalleakage,re,waterleakageorotherproblems.

• Thepumpisa100/120volt60Hzpump,pleaseonlyusewithapower

 supplyvoltagewithin100-120volt60Hz.

• DONOTapplyanypaintoverthestainlesssteelmotorbody.Reduced

 coolingabilitywillresultinoverheat,overload,introduceundesirable

 performancereductions,periodicautoshut-offandpumpmalfunction.

• Neverplaceyourhandoranyobjectinorneartheinletopeningwhile

 thisequipmentisoperating.Ifpumpinletisclogged,alwaysturnoff

 thepowersupply,fuseboxorcircuitbreakerandwaituntilthemotoris

completely stopped before attempting to remove any clogged material.

• PleasemakesurethatthepowerplugandtheACoutletreceptacleis

protected and away from water or pump discharge hose to prevent

accidental electric shock or short circuit.

• Alwaysoperatethepumpcompletelysubmergedinwater.

• Avoiddryoperation,whichwillnotonlylowerperformancebutcan

 causethepumptooverheat/malfunction,leadingtoelectricalleakage,

shock or premature failure.

• CAUTION:

THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A

GROUND CIRCUIT INTERRUPTER.

• ATTENTION:

CETTE POMPE DOIT ETRE BRANCHEE A UNE DERIVATION

PROTEGEE PAR UN DISJONCTEUR DIFFERENTIEL.

• CAUTION:

THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

Before You Start

• Checkthemodelnameplatetomakesureonceagainthattheproduct

is of the correct voltage and frequency rating.

• Thesettingonthecircuitbreakerorotheroverloadprotectorshould

be made in accord with the rated currency of the pump.

• Turnoffthepowersupplyorcircuitbreakerbeforeinsertingthepower

 supplyplugtoavoidelectricalshock,shorting,orunexpectedstarting

 ofthepump,whichcouldleadtoinjury.

• Neveroperatethepumpwhileitissuspendedinair.Therecoilmay

 resultininjuryorothermajoraccident.

Electrical Safety

• Electricalwiringshouldbeinstalledbyaqualiedelectricianinaccor-

dance with all applicable safety regulations. Incorrect wiring can lead

 toapumpmalfunction,electricalshockorre.

• Pumpsshouldoperateonadesignated,110voltcircuitratedat

15 Amps (minimum).

• Pumpmustbeprotectedbyagroundfaultcircuitinterrupter(GFCI).

• Pumpmustbepluggedintoastandard,properlygrounded,three

pronged outlet.

• Donotcuttheelectricalcable.Ifacablewithcutinsulationorother

 damageissubmergedinwater,thereisdangerofwaterseepinginto

the pump motor and causing a short. This may result in damage to the

 pump,electricalshockorre.Altering the electrical cable in any way

will void the warranty.

• Nevermoveorhandlethepumpbypullingontheelectricalcable.

 Makesuretheelectricalcabledoesnotbecomeexcessivelybentor

 twisted,doesnotrubagainstastructureinawaythatmightdamageit,

and does not come in contact with heated surfaces.

Operation

• Incaseofapoweroutage,turnoffthepowertothepumptoavoid

 havingitstartunexpectedlywhenthepowerisrestored.

• Paycarefulattentiontothewaterlevelwhilethepumpisoperating.

 Dryoperationmaycausethepumptomalfunction.Pumpmustalways

operate while fully submersed.

• Incaseofveryexcessivevibration,unusualnoiseorodor,turnoffthe

 powerimmediatelyandconsultwithyournearestdealer.Continuingto

operate the pump under abnormal conditions may result in electrical

 leakage,electricalshockorre.

Motor Protection System

• Thepumphasabuilt-inmotorprotectionsystem.Thefollowingreasons

may cause the pump to stop automatically regardless of water level.

Motor overheating

  Excessivecurrent

  Changeinvoltagepolarity

Open-phase operation or operation under constraint

• Repeatingcyclesofstoppingandrestartingwilldamagethewater

 pump.Donotcontinueoperationatlowlift,lowwaterlevel,orwhile

 theinletiscloggedwithdebris.Notonlywillperformancesuffer,but

 alsosuchconditionsmaycausenoise,heavyvibration,andpumpfailure.

Maintenance and Inspection

• Regularmaintenanceandinspectionsareanecessityforcontinued

 efcientfunctioning.Ifanyabnormalconditionsarenoticed,refertothe

section on Troubleshooting and take corrective measures immediately.

• Duringorafterthewarrantyperiod,thecustomerisNOTto

disassemble the pump for any reason.

Monthly Inspection

•Checkforanydropinperformance.Reducedperformanceisusually

caused by debris blocking the intake screen.

• Detachthepowercablefromthereceptacleandturnoffthepower

supply (circuit breaker).

• Disconnectthepumpdischargeandremovethepumpfromthewater.

• Removeanyaccumulateddebrisfromthesurfaceofthepump,inlet

screen and impeller.

• Makesureallnutsandboltsarefastenedsecurely.

• Donotdisassemblethepumpforanyreason.Disassemblywillvoid

the pump warranty. Refer operating and maintenance problems to a

qualied technician.

Winterizing

• Undernocircumstancesshouldthepumpbeleftinfrozenwater.

• Whenthepumpisoutofuseforanextendedperiod,washitanddry

 itthoroughly,thenstoreitindoors.

Note: Always run a test operation before putting the pump back into

operation. When the pump is left installed in water it should be run at

regular intervals (about once per week).

Warranty

All Tidal Wave Pumps carry a two year limited warranty. This limited

warrantyisextendedsolelytotheoriginalpurchasercommencingfromthe

date of original purchase receipt and is void if any of the following apply:

• Thepumphasbeenrunwhilenotfullysubmersedcausingthethermal

protection to trip. Skimmers using inadequate vertical ltration may

create “run dry” conditions.

• Thepumpwasnotrunonadedicatedcircuit.

• Thecordhasbeencutoraltered.

• Thepumphasbeenmisusedorabused.

• Serialnumbertaghasbeenremoved.

• Thepumphasbeenfullyorpartiallydisassembled.

Warranty Claims

• Incaseofwarrantyclaims,pumpshouldbereturnedtoplaceof

purchase accompanied by original receipt.

Description

1Handle

2Cable

3EpoxyCable

Base

4UpperCover

5Autocut

6Bearing (upper)

7Shaft

8Stator

9Rotor

10 Bearing (lower)

11 MotorCase

12 Bearing Bracket

13 Lubricant

14 Mechanical Seal

15 Seal Bracket

16 Lip Seal

17 Impeller

18 Flange

19 Casing

20 Strainer

A-05 A-21 A-31 A-315

A9” 10” 11” 15”

B7.5” 8.5” 9” 13”

C6.25” 7” 7” 8.5”

D15” 17” 18” 23”

Problem Possible Cause Possible Solution

Pump does

not start

Power is off Turn power on

Power failure Checkpowersupplyor

contact local power company

Voltage drop/

Overload

Check/ReplacetheGFI(Ground

Fault Interrupter)

Power cord is not

connected Connectpowercord

Pump stops after

starting

Pump is

overheating

Submerge pump/Raise water level/

Allow pump to cool

Power/Current

overload

Checklength/sizeofpowercable.

CheckorreplaceGFI

Impeller is blocked Remove debris from the

impeller chamber

Diminished

ow rate or

no water ow

Air lock Restart/Cleanairvalve

Obstruction in pump

or piping Clearobstruction

Piping is too long Reduce length of pipe

1-877-80-PONDS

www.atlanticwatergardens.com

Troubleshooting Guide

Always turn off power before inspecting the pump. Failure to observe this

precaution can result in a serious accident.

Beforeorderingrepairs,carefullyreadthroughthisinstructionbooklet.If

theproblempersists,contactyourdealer.

Andere Handbücher für TidalWave A-05

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Atlantic Wasserpumpe Handbücher

Atlantic

Atlantic Typhoon TA-2200 Bedienungsanleitung

Atlantic

Atlantic TA1800 Bedienungsanleitung

Atlantic

Atlantic TidalWave TT1500 Bedienungsanleitung

Atlantic

Atlantic A Series Bedienungsanleitung

Atlantic

Atlantic TIDAlWAVE SH Series Bedienungsanleitung

Atlantic

Atlantic TidalWave A-05 Bedienungsanleitung

Atlantic

Atlantic MD550 Bedienungsanleitung

Atlantic

Atlantic TidalWave FP100 Series Bedienungsanleitung

Atlantic

Atlantic TidalWave L-305 Bedienungsanleitung

Atlantic

Atlantic MD250 Bedienungsanleitung

Atlantic

Atlantic PAF-20SV Bedienungsanleitung

Atlantic

Atlantic FP100-73816 Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

moyno

moyno 2000 CC Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung