a low center of gravity. This improves stability.
a gross weight within the limits approved by ATV manufacturer.
no dangerous projections to injure the operator or bystanders;
no forward projections which stop head protection being worn;
controls which are easy to work and which do not create a hazard to the operator;
Instructions for Mounted and Trailed Equipment
Take note of the manufacturer′s instructions on:
Operating on slopes;
Where to place loads so as to give fore/aft and lateral stability;
The risks of using equipment with negative drawbar nose weight, i.e. loss of traction;
The maximum operating speed;
The effect that equipment carried on front and/or rear racks will take on longitudinal and
lateral stability;
Securing loads;
The use of ballast, if any, to improve stability;
The need to select and use safe routes.
Using an ATV
Read the manufacturer’s instruction book and take note of the safety advice given;
Choose an ATV with enough power for the work you want it to do. four-wheel drive will give
better traction and mobility and may provide a margin of safety;
Choose a safe route;
Be aware that increased speed greatly increases the risk of instability and risk of and
overturn;
Training
Train everyone who has to use an ATV whether with mounted or trailed equipment or as a solo
machine. The training should emphasize the factors affecting stability, the need for care and
concentration, and how to recognize the conditions which may affect the safety of operation, it is
important for trainees to familiarize themselves with the handing and control of the machine on level
open ground before tackling rough hill terrain.
Suitable training courses are run by bodies such as ATB Land base and the forestry Authority.
Helmets
Wear head protection which protects the head and neck. Helmets are suitable. Some users find
open faced helmets more suitable than full face helmets.
1. DO NOT－Operate the mower without all the correct guards fitted.
2. DO NOT－Alter engine settings unless stated by Engine manufacturer.
3. DO NOT－Touch any moving or rotating parts, during working conditions
