Audio Note CDT Two/II Technisches Handbuch

CDT Two/II

CD TRANSPORT

OWNER’S INFORMATION

! IMPORTANT SAFETY INFORMATION !

HUMIDITY: DO NOT STORE OR OPERATE THIS UNIT IN AREAS OF HIGH HUMIDITY, OR IN CLOSE

PROXIMITY TO WATER/DAMPINESS. DO NOT EXPOSE THE UNIT TO LIQUID.

EARTHING: THIS PRODUCT MUST BE EARTHED – ENSURE THAT THE MAINS SUPPLY CABLE IS

EARTHED.

SHOCK: INTERNAL OPERATING VOLTAGES ARE LETHAL! DO NOT REMOVE THE TOP COVER. DO

NOT ATTEMPT TO REPLACE THE FUSE WITHOUT DISCONNECTING THE UNIT FROM THE MAINS

SUPPLY.

SAFETY COMPONENTS: INTERNAL FUSES AND OTHER SAFETY COMPONENTS ARE LOCATED

INSIDE THIS UNIT IN ACCORDANCE WITH BS 00 5 REQUIREMENTS.

IN THE EVENT OF SAFETY COMPONENT FAILURE, THEY MUST BE REPLACED WITH THE SAME

PART TYPES ONLY. SUCH REPLACEMENT MUST BE CARRIED OUT BY A QUALIFIED SERVICE

TECHNICIAN.

PRECAUTION

Never touch the power cord with wet hands.

Always pull the power cord out by the plug, not by the cord.

Never expose the system to rain, moisture, excessive heat and magnetism.

Never let an inexperienced person repair or reassemble the unit.

Never put anything, especially metal, into the unit.

Never place excessive weight on the unit.

Always remove compact disc and CD clamp out of the unit before carrying or

transportation.

POWER REQUIREMENTS

Power requirements for electrical equipment differ from area to area. Please ensure

that your unit meets the power requirements in your area. The power requirement for your

transport is marked on the serial number plate on the rear panel.

If you are in doubt, please contact your dealer before plugging the unit into the mains

supply!

CE DECLARATION OF CONFORMITY

We declare under our sole responsibility that this product is in conformity with the following

standards or standardized documents:

BS EN 00 5 in accordance with the regulations 73/23/EEC, 89/33 /EEC (from 1

January 1997).

CE 94

Peter Qvortrup

Director

Audio Note (UK) Limited

25 Montefiore Road,

Hove,

East Sussex

BN3 1RD

United Kingdom

Tel: +44 (0)1273 220 511

Fax: +44 (0)1273 731 498

CLASS 1 LASER PRODUCT

This product contains a low power laser device. To ensure continued safety, do not

remove any covers or attempt to gain access to the inside of the product. Refer servicing to

qualified personnel.

Make Your Contribution to Protect the Environment

Used batteries with the ISO symbol for recycling, as well as small accumulators

(rechargeable batteries), mini-batteries (cells) and starter batteries should not be thrown into

the dustbin. Please leave them at an appropriate depot.

This equipment conforms to No. 2/499/EEC, 87/308/EEC standard.

TABLE OF CONTENTS

1 PRECAUTIONS

3 UNPACKING & INSTALLATION

4 OPERATIONS

PROGRAMMING

7 TROUBLESHOOTING GUIDE

SPECIFICATIONS

GENERAL

Congratulations

on your purchase of the Audio Note CDT Two/II CD Transport.

Audio Note is highly critical of the digital medium as presented by compact disc; we

sincerely hope that you too will find this transport breaks free from the 'digital mould' that we

are all so accustomed to, and so open a new window on your CD collection.

Please read over this manual carefully in order to obtain the best possible performance

and longevity from your transport.

UNPACKING & INSTALLATION

Please take care when unpacking the CDT Two/II. We recommend that you store the

packing materials in case the unit requires shipping at a later date.

Next, select a suitable location for the unit, for example, a dry and dust-free area which

is not exposed to direct sunlight.

Connections:

The transport's sonic performance will start to improve as the internal parts 'bed' in.

The transport requires about two hundred hours of operation before the bedding in process is

complete.

Connectors on the back of CDT Two/II unit provide a digital output for connection to

your DAC via your digital interconnect with RCA or XLR connectors. Your dealer can advise on

suitable type and quality of cable eg: - Audio Note AN-V is an excellent choice.

Power connector: An IEC power connector is available for connection to the local supply.

Simply connect this to a convenient power point using the supplied cable.

IMPORTANT INFORMATION

Compact disc transports have built-in error compensation circuits to correct minor

manufacturing defects on a disc. In some cases, defects on the disc, which are too large for

the error compensation circuits to handle, may cause the CD player to skip some tracks during

playback. If this problem occurs, play a new disc, normal playback of the new disc indicates

that the previous disc is damaged in some way. However, if the problem continues, it is best to

have the unit serviced.

LOADING THE DISC

Please open the sliding disc cover on the top of CDT Two/II. Put the disc on the spindle

and secure it with the supplied disc clamp. Close the disc cover.

OPERATIONS

VIA BUTTONS LOCATED ON THE FRONT PANEL

PLAY/PAUSE Press this button to play a disc.

Pressing this button again will pause playback.

Press the button again to resume playback.

STOP Press this button to stop playback.

SKIP (   ) Press these buttons to go to the previous or the next track.

DISPLAY Press this button to change the intensity of display or to turn it on/off.

VIA REMOTE CONTROL

The batteries for the remote control handset for the CDT Two/II are

not included. Please purchase them (high quality AA bateries is

recommended) and fit into the handset before operating the remote

control. Please ensure that the batteries are inserted correctly.

PLAY/PAUSE ( ►

▐▐

) - Press this button to play a disc. Pressing

this button again will pause playback. Press the button again to

resume playback.

STOP (

■

) - Press this button to stop playback.

SKIP (   ) - Press these buttons to go to the previous or the

next track.

SEARCH (   ) - Press these buttons to cue or review a track.

To reverse (review) a track, hold down the SEARCH - button. To cue

(fast forward) a track, hold down the SEARCH + button.

MEMORY - Use the Memory button for programming and reviewing

programs.

PROGRAMMING

You may select a number of tracks and store them in the memory in the desired

sequence. The transport will then play back only your selection of tracks in the selected

order.

1 Press the MEMORY button. 'MEMORY' will appear on the display.

2 Press the CD SKIP or numbered buttons - To select the desired track to be stored.

3 Press the MEMORY button - The track is now stored in the memory.

Repeat steps 2 and 3 to complete programming.

4 Press PLAY to listen to the programmed tracks.

5 Press STOP once to stop playback.

Press STOP second time to clear programming.

A maximum of 32 tracks may be stored.

A particular track in your selection may be replaced with a new one if the original

selection was made in error. Simply store the new track in the program number to be

replaced.

NOTE: Programming may not be made during playback.

TIME button. Press this button to see the elapsing or remaining time of the CD.

(Play mode only.) Press the TIME button and select the desired TIME DISPLAY for CD

playback.

Each time this button is pressed, selection is as follows:

"EACH REMAIN" the elapsed playing time for the current track.

"TOTAL" the total elapsed playing time.

"TOTAL REMAIN" the remaining playing time for the current track.

REPEAT button. Press this button to listen to the music repeatedly. First press to

repeat the entire disc. Second press to repeat displayed flashing track.

RANDOM button. Press this button for random order playback.

NUMBERED buttons. A particular track may be selected for playback by using these

buttons. Example:

To play track ' 3', press the button ' 3' once.

To play track '14', press the button “1” and "4".

To play track '20', press the button "2" and "0".

DISPLAY button. Press this button to change the intensity of display or to turn it

on/off.

Press the DISPLAY button once to reduce the intensity of the display. Press the

DISPLAY button twice to turn the display off. To turn the display on, please DISPLAY

button once again.

Supplied remote control handset can operate Audio Note preamplifier:

VOL + Press this button to turn the volume up.

VOL - Press this button to turn the volume down.

INPUT + - Press one of these buttons to change the input.

MUTE Press this button to mute the sound.

TROUBLESHOOTING GUIDE

Refer to the relevant sections in the manual for remedy suggestions.

SYMPTOM CHECK POINT

No sound from the CD player. CD is not selected on the amplifier.

Playback does not start. The disc cover is not fully closed.

The disc is dirty.

The disc is upside down.

The player is in the PAUSE mode.

Moisture condensation has caused the unit to

operate incorrectly.

" NO DISC" appears. There is no disc loaded or the disc is loaded

incorrectly.

The disc clamp is not in place.

Playback does not start from The player is in the PROGRAM or RANDOM mode.

the first track. Press the STOP (

■

) button to cancel the

program mode or RANDOM button to cancel

random mode.

SPECIFICATIONS

Optical pick-up: 3 beam laser

Semi-conductor laser: 780 nm

Power source: AC 100-120V/220-240V 50/ 0 Hz

Fuse: 240V - 500 mA Anti-surge

120V - 500 mA Anti-surge

Dimension (incl. connectors): 300 (W) x 142 (H) x 428 (D) mm

Weight: 7.5kg

Power consumption: 35W

Inhaltsverzeichnis

Andere Audio Note CD-Player Handbücher

Audio Note

Audio Note CD 3.1x/II Technisches Handbuch

Audio Note

Audio Note CD3.1x Technisches Handbuch

Audio Note

Audio Note CD 2.1x/II Technisches Handbuch

Audio Note

Audio Note CDT - Two Technisches Handbuch

Audio Note

Audio Note CD 1.1x Technisches Handbuch

Audio Note

Audio Note CDT Zero/II Technisches Handbuch

Audio Note

Audio Note CDT ZERO Transport Technisches Handbuch

Audio Note

Audio Note CD 2.1x/II Technisches Handbuch

Audio Note

Audio Note CD 4.1x Technisches Handbuch

Audio Note

Audio Note CDT Zero/II Technisches Handbuch

Audio Note

Audio Note CD Zero Technisches Handbuch

Audio Note

Audio Note CD 4.1x Technisches Handbuch

Audio Note

Audio Note CDT One/II Technisches Handbuch

Audio Note

Audio Note CDT Six Technisches Handbuch

Audio Note

Audio Note CDT One/II Technisches Handbuch

Audio Note

Audio Note CD2.1x Technisches Handbuch

Audio Note

Audio Note CDT Five Technisches Handbuch

Audio Note

Audio Note CDT-Six / Force Bedienungsanleitung

Audio Note

Audio Note CDT Three Bedienungsanleitung

Audio Note

Audio Note AN-CD1 Technisches Handbuch

Audio Note

Audio Note CD Zero Technisches Handbuch

Audio Note

Audio Note CD 1.1x Technisches Handbuch

Beliebte CD-Player Handbücher anderer Marken

RCA

RCA RP-7923 Bedienungsanleitung

Pioneer

Pioneer DEH-P3550MP XM Bedienungsanleitung

Philips

Philips AZ1207 Bedienungsanleitung

Philips

Philips CD582 Bedienungsanleitung

Philips

Philips AZ 6821 Bedienungsanleitung

Lasonic

Lasonic MSU-2020 Bedienungsanleitung

THOMSON

THOMSON RCD150 Bedienungsanleitung

Denon

Denon DCD-1420 Bedienungsanleitung

Panasonic

Panasonic SJ-MR100 Bedienungsanleitung

Onkyo

Onkyo DX-7210 Bedienungsanleitung

Sony

Sony MZ-R3 Bedienungsanleitung

Denon

Denon DVM-4800 Bedienungsanleitung

JBL

JBL MR-32 Bedienungsanleitung

RCA

RCA RCD152 Bedienungsanleitung

Technics

Technics SL-PS770A Bedienungsanleitung

Clarion

Clarion compact disc Bedienungsanleitung

Sony

Sony MZ-M10 Bedienungsanleitung

Philips

Philips Expanium AZ 1538 Bedienungsanleitung