Audioplex S-VHS QUICK CONNECT Bedienungsanleitung
S-VHS QUICK CONNECT
SPECIFICATIONS
WARRANTY
Front Connector: S-VHS Connector
Rear Quick Connector Types: RCA Connector
F (COAX) Connector
Screw Down Connector
Your S-VHS Quick Connect speeds the job of transitioning S-VHS video runs with the option of three termination
styles: RCA, F (COAX) or Screw Down Connectors. These termination options eliminate the need to solder
Luminance and Chromanance conductors to the plate.
Your AUDIOPLEX TECHNOLOGY S-VHS Connector is covered by a LIFETIME warranty against
defects in workmanship and materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or by accident is not considered to be a defect, and not covered by this
warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused by abuse or by
modification or service by any unauthorized person or agency.
The product must be properly installed and operated according to instructions for this warranty to
apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The product must be returned
expenses prepaid, with written authorization from the company. The product must be shipped with the proof
of purchase and in the original carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to
state.
TECHNOLOGY
INSTALLATION MANUAL
1999 - 4/22/99
Wire Recommendations:
RCA Cables: F (COAX) Cable: Video Compatible
Communication Cable:
High quality, video compatible,
thoroughly shielded and appropriately
UL and CSA rated for in-wall use.
If using RG-6, a solid copper center
conductor is recommended. DO NOT
USE copper clad steel wire (CCS) as
this will result in higher than expected
signal loss.
High quality, video compatible,
thoroughly shielded and appropriately
UL and CSA rated for in-wall use. DO
NOT USE speaker wire, Zip cable, etc.
Building Ground Lead: (A metal box is recommended to enhance shielding)
Video hum bars due to equipment plugged into different AC circuit runs
may be alleviated by tying one of the S-VHS plates to building ground.
On only ONE of the S-VHS plates, cut the electrical traces (two traces)
indicated by the "<" mark on the PC board. Tie the GREEN lead wire to the
metal electrical box that the S-VHS plate is mounted on in one location only.
Because of the wide variety of building wiring situations, experimentation
may be necessary to eliminate any interference.
MADE IN USA
To p
G + G G + G
<
<
Cut traces at arrows
Green
lead wire
Andere Audioplex Sender Handbücher
Beliebte Sender Handbücher anderer Marken
Dejero
Dejero EnGo 3x Bedienungsanleitung
Rosemount
Rosemount 4600 Bedienungsanleitung
Speaka Professional
Speaka Professional 2342740 Bedienungsanleitung
trubomat
trubomat GAB 1000 Bedienungsanleitung
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Bedienungsanleitung
Rondish
Rondish UT-11 Bedienungsanleitung
