Audiovox LCMR6CT Bedienungsanleitung

Rearview Mirror with 4.5" Color LCD with

Navigation and 2 Camera inputs/Compass

and Outside Temperature

Model: LCMR6CT

Owner’s Manual

Features:

Rearview Mirror with 4.5” LCD

Rearview Camera Input

Interior View Camera Input

Navigation Display Input

NTSC /PAL Compatible Camera Input

Compass Display

Outside Temperature Display

This product must be installed and used only in accordance with these instructions. Any

alteration of this product that enables it to be used in ways other than those stated in this

manual could distract the driver and result in an accident or injury. AUDIOVOX

ELECTRONICS CORP. DISCLAIMS ANY LIABILITY THAT MAY

RESULT FROM A FAILURE TO INSTALL AND OPERATE AS

INDICATED IN THESE MANUALS.

Warning: Backing up vehicle

Do not back up vehicle while watching the mirror/monitor screen. Always look in the

direction of vehicle motion. Use the mirror/monitor as an aid in safety confirmation. The

distance looks different in the monitor. The actual distance is shorter than it looks in the

monitor. The range of image is limited. Beware of blind spots.

Cautions!

The product is intended to assist in safe driving and to allow the driver to have a broader

rearview during reversing. You, as the driver, are solely responsible for the safe operation

of your vehicle and the safety of your passengers according to the country and their local

traffic regulations. . Do not use any features of this system to the extent it distracts you

from safe driving. Your first priority while driving should always be the safe operation of

your vehicle. Audiovox Electronics Corp. cannot accept any responsibility whatsoever for

accidents resulting from failure to observe these precautions or safety instructions.

TABLE OF CONTENTS

Cautions! -------------------------------------------------------1

Functions -------------------------------------------------------3

Operation -------------------------------------------------------4

Maintenance ----------------------------------------------------6

Congratulations on your purchase of this Rearview Mirror / Monitor

with Outside Temperature and Compass display. This system has

been designed to bring years of trouble free operation for Rear

Observation and Vehicle Navigation Systems.

Figure 1

I. Functions

Figure1 shows the function controls of the rear view mirror.

A: 4.5" LCD Panel

B: Rearview Mirror Glass

C: “+”Button (optional Navigation System required)

Incrementally increase volume level of the navigation voice command when

pressed.

Note: Will only operate when the Navigation System remote control is

removed from the cradle.

D: “CAM” Button

- If you have installed an optional interior view camera, pressing the CAM

button will display the image from the interior view camera on the LCD

panel.

- If you do not have an interior view camera installed, but have installed a

back up camera, then pressing the CAM button will display the image

from the back up camera on the LCD panel.

- Either image will be displayed for as long as the CAM button is held on.

As soon as the button is released, the LCD will automatically switch back

to the original setting.

E: “MAP” Button (optional Navigation System required)

Each time the “MAP” button is pressed, the navigation display will toggle

between Map, Icon only and split screen while in navigation mode.

Note:Will only operate when the Navigation System remote control is

removed from the cradle.

F: “-” Button (optional Navigation System required)

Incrementally decrease volume level of the navigation voice command when

pressed.

Note: Will only operate when the Navigation System remote control is

removed from the cradle.

G: Internal Speaker (optional Navigation System required)

H: LCD Brightness Control

I: Internal Infra-RED Receiver for use with Navigation System Remote Control.

J: Power LED (Red when Power is on)

K: Display Timer Slide Control Switch: (optional Navigation System required)

Refer to # 3 below for detailed operation notes.

L: “ T/C ” Button

The temperature/compass button switches between Fahrenheit and Celsius settings and

also turns the display on or off.

M: Internal Speaker Switch: Use to turn the internal Speaker on/off.

N: Calibration Switch: Used to calibrate the compass display.

II. Operation

The Mirror/monitor is automatically activated every time the Ignition key

is turned on. The mirror/monitor turns off every time the Ignition is

turned to the off position.

1. Rear Observation Camera (optional)

A. If a rear observation camera has been installed, the monitor will

automatically display the rear observation camera image whenever

the vehicle is shifted into reverse gear. The rear observation camera

image turns off automatically any time the gear selector is moved out

of the reverse position.

B. If you do not have an optional interior view camera installed,

pressing the “CAM” button at any time will display the image from

the rear observation camera onto the LCD for as long as the “CAM”

button is held.

2. Interior View Camera (optional)

If an interior view camera has been installed, pressing the “CAM” button

at any time will display the image from the interior view camera onto the

LCD for as long as the “CAM” button is held.

3. “TC” Button

The temperature/compass button switches between Fahrenheit and

Celsius settings and also turns the display on or off. Press once to turn on

the continuous temperature (F)/compass display. Press again to switch the

temperature display to Celsius. Next press will turn off the

temperature/Compass display

4. Navigation Image (optional Navigation System required)

The Navigation Image is the default mode, and will only be overridden

when the vehicle gear selector is moved into reverse, or if the CAM

button on the mirror is pressed.

Some operators may find that leaving the Navigation Image on the LCD

monitor at all times becomes a distraction while operating their motor

vehicle. For the convenience of those operators, a ‘Display Timer Slide

Control Switch’ has been added to the mirror.

A. When the Slide Control Switch is moved to the far right end position,

the Navigation image will remain on at all times.

B. When the Slide Control Switch is moved to the far left end position,

the Navigation image will remain off at all times.

C. Positioning the Slide Control Switch anywhere in the center area will

automatically enable an internal timer. The timer is adjustable

between 10 Seconds (further left) to 3 minutes (further right).

D. When the Navigation System is in guidance mode, every time a turn-

by-turn voice guidance command is received, the Navigation image

will automatically turn on and remain on for the pre-selected time set

by the Slide Switch. After the pre-set time has expired, the

Navigation display will turn off and remain off until the next voice

command is received.

HINT 1: When entering a new address into the Navigation Address Book, it

will be easier to move the Slide Control Switch all the way to the right to keep

the LCD display on until the address has been completed.

HINT 2:When in Timed Display Mode, you can press the “+” or “-“ button on

the mirror to turn the Navigation image on for the full extent of the pre-set

time.

5. LCD Monitor Brightness Control

The brightness adjustment control is on the bottom right of the rearview

mirror.

Rotating the wheel to the right will decrease the brightness of the

monitor.

Rotating the wheel to the left will increase the brightness of the monitor.

6. Disabling the internal speaker

Remove the L-Cover at the left end of the mirror using a Mini

screwdriver (see Figure2), to gain access to the small switch inside.

To disable the internal speaker, set the switch to the off position (See

Figure3). Set the switch to the ON position to enable the internal speaker

(see Figure3).

ure3

ure2

7. How to Calibrate the Compass Direction

A. Ensure the Compass Sensor has been securely mounted.

B. Press the Calibration Switch to the “IN” position.

C. Drive the vehicle in one or more complete circles.

WARNING: Calibration must have 10 seconds at least.

D. Press the Calibration Switch again, returning the switch to the

“OUT” position. Now the mirror will display the compass direction

accurately.

NOTE: Calibration may provide more accurate heading information. If the

heading information on the display seems inaccurate, calibrating may correct

this condition. Times when re-calibration may be important include:

i. First time use of the system.

ii. Any time the compass sensor has been re-positioned.

iii. A change in residence of more than 200 miles.

iv. The heading display is not accurate.

III. Maintenance

Though your Rearview mirror requires little care, you can still maintain

its condition and performance by following the procedures below.

Keep your system away from excessive moisture, extreme heat or cold,

and magnetic fields.

Keep liquids away from the display and mirror.

To avoid damage, do not place external devices or other objects on the

top of the mirror.

Occasionally wipe the rearview camera lens with a soft, damp cloth.

Occasionally clean the surface of the mirror with a soft cloth moistened

with water or window cleaner.

128-7736

Andere Handbücher für LCMR6CT

Inhaltsverzeichnis

Andere Audiovox GPS Handbücher

Audiovox

Audiovox NPC5000 Bedienungsanleitung

Audiovox

Audiovox GMR-GPS Bedienungsanleitung

Audiovox

Audiovox PG300 Bedienungsanleitung

Audiovox

Audiovox NPD5500 - Navigation System - in-dash Bedienungsanleitung

Audiovox

Audiovox NPD5500 - Navigation System - in-dash Bedienungsanleitung

Audiovox

Audiovox ECCO 128-8854 Bedienungsanleitung

Audiovox

Audiovox Advent ADVUV630 Stücklistenhandbuch

Audiovox

Audiovox VME 9725 NAV Bedienungsanleitung

Audiovox

Audiovox NPC5400 - Navigation System Bedienungsanleitung

Audiovox

Audiovox LCM580NAV Bedienungsanleitung

Audiovox

Audiovox NAV3000 Bedienungsanleitung

Audiovox

Audiovox PG300 Bedienungsanleitung

Audiovox

Audiovox NVXM1000 Bedienungsanleitung

Audiovox

Audiovox SDB45 Bedienungsanleitung

Audiovox

Audiovox NVX216 Bedienungsanleitung

Audiovox

Audiovox GMR-GPS Bedienungsanleitung

Audiovox

Audiovox LCM580NAV Bedienungsanleitung

Audiovox

Audiovox NAV 103 - Bedienungsanleitung

Audiovox

Audiovox NVX235W - Touch&Go - Automotive GPS Receiver Bedienungsanleitung

Audiovox

Audiovox LCMR4N Bedienungsanleitung

Audiovox

Audiovox NVX225 Bedienungsanleitung

Audiovox

Audiovox SDB Bedienungsanleitung

Audiovox

Audiovox NVX430 Bedienungsanleitung

Audiovox

Audiovox NVX226 Bedienungsanleitung

Beliebte GPS Handbücher anderer Marken

Hama

Hama 53118 Bedienungsanleitung

Garmin

Garmin SOUNDER 125 Bedienungsanleitung

Garmin

Garmin DEZL 580 Bedienungsanleitung

Jigabot

Jigabot EX Bedienungsanleitung

Pointer

Pointer Cellocator CelloTrack XT LTE Installationsanleitung

Queclink

Queclink GV55LITE Bedienungsanleitung

Voxson

Voxson Voxtrack GPS500 Gebrauchsanweisung

Garmin

Garmin ECHOMAP PLUS Bedienungsanleitung

Starcom Systems

Starcom Systems Kylos Compact Bedienungsanleitung

Garmin

Garmin 15 H Series Bedienungsanleitung

Cobra

Cobra Marine MC 600Ci Bedienungsanleitung

Cellocator

Cellocator CelloTrack T Bedienungsanleitung

Enfora

Enfora Mini-MT GSM2228UG001 Bedienungsanleitung

Magellan

Magellan eXplorist 100 Bedienungsanleitung

Garmin

Garmin DEZL OTR500 Bedienungsanleitung

LTE

LTE G50B Bedienungsanleitung

SkyGolf

SkyGolf SkyCaddie SG1 Bedienungsanleitung

Garmin

Garmin GPSMAP 78 series Bedienungsanleitung