AUSTRALIAN MONITOR ACM120P Bedienungsanleitung

120W Power Amplifier

ACM120P Description

The ACM120P is a 120 watt power amplifier with outputs for 4 and 8 ohms, 70 and 100 volt

line. It may be desk or rack mounted. The ACM120P features a flat screwdriver accessible gain

control on the rear panel. This amplifier features a status LED.

Inputs and Outputs

The ACM120P features a balanced line level XLR input with a parallel output to feed additional

power amplifiers. The unit has industry standard 3 pin XLR microphone sockets. The ACM120P

features 100 volt, 70 volt, 8 and 4 ohm isolated transformer outputs via a rear panel barrier strip.

Protection

Internal current limiting protects the amplifier from both overload and overdrive conditions.

Should the amplifier be overdriven, a current limiter will protect the unit, and in a worst case

scenario the amplifier will shut down until the problem is resolved. Once the problem is fixed

(shorted speaker line, or overdriven input), the amplifier will automatically reset and continue

operation. The ACM120P features generous heatsinking.

Australian Monitor Installation Series amplifiers feature a protection network that provides

greater stability and performance. Our amplifiers are recognised

worldwide for their reliability and this is due to the extensive levels of

current limiting which protect the amplifiers from both overload and

overdrive conditions.

Engineered and Distributed By AUDIO TELEX COMMUNICATIONS PTY LTD (ABN 78 001 345 482),

149 Beaconsfield Street, Silverwater, Sydney, NSW, 2128 Australia

NSW Tel: (02) 9647 1411 Fax: (02) 9648 3698 VIC Tel: (03) 9890 7477 Fax: (03) 9890 7977 QLD Tel: (07) 3852 1312 Fax: (07) 3252 1237

WA Tel: (08) 9228 4222 Fax: (08) 9228 4233 TAS Tel: (03) 6228 6373 Fax: (03) 6278 1063 SA Tel: (08) 8352 4444 Fax: (08) 8352 4488

Export Enquiries: [email protected] Website: www.australianmonitor.com.au

Power Output 120 Watts RMS

Maximum Load 80 Ohms @ 100 Volts

Power Bandwidth 60Hz - 15kHz < 0.5% THD

Frequency Response 60Hz - 15kHz (± 3dB)

Total Harmonic Distortion 0.5% @ 1kHz rated power

Signal To Noise Ratio -80dB

Input Sensitivity 700mV

Outputs 100V, 70V, 4 Ohm, 8 Ohm

Controls One gain control on rear of the unit via flathead screwdriver control

Indicators Power “on” LED

Power Source AC 240V - 60Hz, 110V - 50Hz (special) 3 pin IEC connector

Power Consumption 300 Watts

Protection Current Limiter protection, plus AC and DC fuses

Dimensions/Weight 88mm H x 480mm W x 280mm D (Chassis Dimensions only). 12kg

Rack Mounting Standard

ARCHITECTURAL AND ENGINEERING SPECIFICATIONS

The 120 watt power amplifier shall be designed to run 100 and 70 volt line audio systems. The unit shall

also feature a 4 and 8 ohm output. The amplifier may be desk or rack mounted.

The amplifier must be capable of delivering 120 watts into an 80 ohm inductive load with less than 0.5%

distortion measured at 1kHz and with system hum and noise of -80dB or better. Internal current limit-

ing shall protect the amplifier from both overload and overdrive conditions.

The amplifier shall be an Australian Monitor Installation Series model ACM120P.

Inhaltsverzeichnis

Andere AUSTRALIAN MONITOR Verstärker Handbücher

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMIS480P Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR Synergy SY400 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMIS AMC60 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMD2100P Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMIS480P Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR Digipage JR Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR PA800 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR ACM250P Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMIS604 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AM1600 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMC+250 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR IC30 Series Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR DCM120 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMC120 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR OPAL Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR HS250P Kurzanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR KMA750 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMIS604 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMH3600 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR HS60 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR Synergy SY400 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR Synergy SY400 Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR AMIS120 Series Bedienungsanleitung

AUSTRALIAN MONITOR

AUSTRALIAN MONITOR SY400V SY800V Bedienungsanleitung

Beliebte Verstärker Handbücher anderer Marken

ASTRO

ASTRO HVO V40 P Bedienungsanleitung

Marantz

Marantz SUPERSCOPE BLA-545 Montageanleitung

NAD

NAD CI980 Bedienungsanleitung

Technics

Technics SE-CH770 Bedienungsanleitung

Harman Kardon

Harman Kardon HK6300 Bedienungsanleitung

NAD

NAD T975 Bedienungsanleitung

McIntosh

McIntosh MA6850 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Bedienungsanleitung

Viatron

Viatron Autrix Bedienungsanleitung

GME

GME GA9800 Bedienungsanleitung

Atlas

Atlas CP700 Bedienungsanleitung

Roland

Roland KC-1000 Bedienungsanleitung

Pyle

Pyle PFMRA350BW Bedienungsanleitung

Advantage

Advantage S-250 Bedienungsanleitung

IRT Electronics

IRT Electronics DVA-3007 Bedienungsanleitung

Dimavery

Dimavery BA-100 Series Bedienungsanleitung

Sony

Sony XM-S400D Bedienungsanleitung

Schertler

Schertler ROY X Bedienungsanleitung