10 En
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent, or similarly qualied persons.
• The appliance must be disconnected from its power source during servicing,
cleaning or when not in use. Do not use chemicals to clean the appliance.
• Always operate the unit from a grounded power outlet of equal voltage,
frequency and rating as indicated on the product identication plate.
• Do not operate with wet hands. Keep the unit away from sources or water,
moisture, or any other liquids.
• Do not leave the unit running unattended. Do not unplug or tilt the unit while
it is in operation.
• Do not unplug by pulling on the power cord.
• Do not use an extension cord.
• Do not put objects on the unit, climb or sit on the unit.
• Do not insert ngers or other objects into the air outlet.
• Do not operate the unit if it is dropped, damaged or showing signs of product
malfunction.
• The unit must be installed in accordance with national wiring regulations.
• Do not use means to accelerate the defrosting process.
• The appliance must be stored in a manner to prevent mechanical damage.
• Do not piece or burn, even after use.
• Compliance with national gas regulations must be observed.
• Do not place in direct sunlight or near objects that may cause mechanical
vibration or shock.
• Position the unit on an even / at surface, away from excessive dust, and always
maintain the unit to ensure that excessive dust does not accumulate anywhere
on the unit.
Failure to abide by any of these warnings could result in a re, explosion,
electric shock, injury, death, and property damage.
Servicing Safety Precautions
Please carefully follow this guidance when undertaking any servicing on
this appliance. Any servicing must be carried out by a suitably qualied and
registered individual.
Prior to beginning work, safety checks are necessary to ensure that the risk of
ignition is minimized. For repair to the refrigerating system, all of the following
precautions must be complied with prior to conducting work.
Work Procedure
Work must be undertaken under a controlled procedure to minimize the risk of a
ammable gas or vapour being present while the work is being performed.
General Work Area
All maintenance staff and others working in the local area must be instructed on
the nature of work being carried out. Work in conned spaces must be avoided.
The area around the workspace must be sectioned off. Ensure that the conditions
within the area have been made safe by control of ammable material.
Checking for Presence of Refrigerant
The area must be checked with an appropriate refrigerant detector prior to
and during work, to ensure the technician is aware of potentially ammable
atmospheres. Ensure that the leak detection equipment being used is suitable for
use with ammable refrigerants, e.g. no sparking, adequately sealed or intrinsically
safe.
