Avaya C460 SMON Bedienungsanleitung
Avaya™ C460
Modular Multilayer Switch
Quick Start Guide 1
2
3
4
5
6
Run the Embedded Device
Manager (optional)
Configure the Switch
Install the Supervisor
Module and PSU
Position the Chassis
Unpack the Chassis
Important Information
Note:
Refer to “Important Information” before starting
the installation
Contact CentersIP Telephony Unified Communications Services
1
Important Information
Before installing or removing any components of a device, or carrying out any maintenance
work, you must read the safety information provided.
Notes, Cautions and Warnings
LText with the Lsymbol contains helpful information or hints or reference to material in
other documentation.
Caution: Take care. You could do something that may damage equipment or result in loss of
data.
Warning: This means danger. Failure to follow the instructions or warnings might result in
bodily injury. Ensure that you are qualified for this task and have read and understood all the
instructions
Safety Information
Warning: To avoid injury, Avaya recommends that two people lift or move the switch. A
fully loaded C460 switch weighs at least 100 lbs (45 kg).
Caution: The Avaya C460 switch and modules contain components sensitive to electrostatic
discharge. Do not touch the circuit boards unless instructed to do so.
Do not leave any slots open. Use the blanking plates supplied to cover empty slots.
Do not insert any objects into the C460 chassis other than specifically designed Avaya
products.
Warning: The fans are on whenever the power is on in the chassis, whether supervisor
modules are installed or not.
Keep your fingers and other objects clear of the fans when removing the Fan module. The
fans continue to turn briefly after you have removed the module.
1
Power Supplies
CAUTION: Risk of electric shock. Disconnection of one power supply cord disconnects one
power supply module only. To isolate unit completely from the mains disconnect all power
supply cords.
ACHTUNG: Gafahr des elektrischen Schocks. Entfernen des Netzsteckers eines Netzteils legt
nur dieses Netzteil spannungsfrei. Um alle Einheiten spannungsfrei zu machen. Sind die
Netzstecker aller Netxteile zu entfernen
ATTENTION: Risque d'électrocution. Le débranchement d'un câble d'alimentation ne
déconnecte qu'un seul module d'alimentation. Pour isoler complètement l'unité du secteur,
débranchez tous les câbles d'alimentation.
FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense.
Changes or modifications to this equipment not expressly approved by Avaya Inc. could void
the user’s authority to operate the equipment.
Warranty:
Avaya Inc. provides a limited warranty on this product. Refer to your sales agreement or other
applicable documentation to establish the terms of the limited warranty. In addition, Avaya’s
standard warranty language as well as information regarding support for this product, while
under warranty, is available through the following website: support.avaya.com.
LEvery effort was made to ensure that the information in this document was complete and
accurate at the time of printing. However, information is subject to change.
2
Unpack the Switch
Check the package contents for the following:
Equipment
• One C460 chassis with fan module.
•If you purchased an Avaya C460ML-CFG (Material code 700255003) or C460ML PWR CONFIG
(Material code 700281603) , then one Supervisor Module, PSU and the Fan Module are already
installed.
LEthernet connection cables are not supplied.
Documentation
• Avaya C460 Quick Start Guide (this document).
• Avaya C460 Release Notes.
• Avaya C460 Documentation and Utilities CD.
• Avaya Warranty and License Agreement.
CD Contents
User’s Guides
• Avaya C460 Installation and Maintenance Guide
• Avaya C460 Configuration Guide
• Avaya C460 Reference Guide
• Avaya™ MSNM C460 Manager User’s Guide
Auxiliary Files for the use with the Device Manager
• Java plug-in
•Helpfiles
Adobe Acrobat Reader
This application allows you to view and print the User’s Guides on this CD
LIf any items are missing or damaged, contact your supplier.
3
Position the Switch
Environmental Prerequisites
Warning: To avoid injury, Avaya recommends that two people lift or move the switch. A
fully loaded C460 switch weighs at least 100 lbs (45 kg).
You can position the Avaya C460 in free-standing mode on a suitable shelf or table, or mount it
in a standard 19-inch equipment rack in a wiring closet or equipment room.
When deciding where to position the chassis, ensure that:
• It is accessible and cables can be connected easily and according to the configuration rule.
• Cables are away from sources of electrical noise such as:
— radio transmitters
— broadcast amplifiers
— power lines
— fluorescent lighting fixtures.
• Water or moisture cannot enter the case of the chassis.
• There is a free flow of air around all sides the chassis.
• The vents on the sides of the case are not blocked.
• The table or shelf can hold the weight of the chassis with the PSUs and modules.
• The environmental conditions match the requirements listed in Table 1.
LRefer to the Avaya C460 Installation and Maintenance Guide for additional information.
Table 1 Environmental Requirements
Ambient temperature 23oto 122oF (-5oto 50oC)
Relative humidity 5% to 95%, non condensing
Minimum clearance for
ventilation
2" (5 cm) on each side
Weight support 50 lb. (23 kg) to 100 lbs (45 kg)
3
• The power source matches the specifications shown in Table 2.
Installing the C460 on a Table Top
LPlace the system on a surface that supports at least 100 lbs (45 kg).
1 Install the supplied rubber feet to the bottom of the switch, placing the feet in the square
recesses provided. See Figure 4.
Clean the surface of any oils or residue before applying the feet.
Figure 4 Table-Top Installation
2 Ensure that all the preinstalled components are firmly installed in the chassis. These include:
—Supervisormodules
— Power supply
—Fanmodule
Caution: Do not place other equipment on top of the C460.
Table 2 AC Power Requirements
Voltage 100 to 240 VAC, 50/60 Hz
Current for one MPS4603-AC 300 W PSU 3.9 A@100 VAC
1.5 A@240 VAC
Current for one MPS4610-AC 1000 W PSU 11.5 A@100 VAC
5.6 A@240 VAC
Table 3 Dimensions
Height 10U (17.5", 444.5 mm)
Width 17.4" (442 mm)
Depth 15" (375 mm)
Rubber feet
3
Rack Mounting (optional)
Warning: To avoid injury, Avaya recommends that two people lift or move the switch. A
fully loaded C460 switch weighs at least 100 lbs (45 kg).
You can mount the Avaya C460 in a standard 19" rack either in “front-mount” or “mid-mount”
positions with the brackets supplied with the chassis.
The brackets are symmetric: you can fix either bracket one either side.
Figure 5 shows the two mounting positions:
Figure 5 C460 Front-Mount and Mid-Mount Positions (side view)
LThe chassis height is 10U.
5.5”
(140 mm)
a
b
a
b
Front Front
Front-Mount Mid-Mount
Key
aRack
b C460 switch
3
C460 Rack mounting procedure:
1 Position the brackets as shown in Figure 6
Figure 6 Positioning the rack-mounting brackets
2 Firmly fix the brackets to the chassis with the screws provided. Use five screws for each
bracket.
3 Position the switch in the rack.
4 Fasten the switch in the rack with the screws provided.
LThe screw size is 8-32x¼
Caution: Do not place other equipment on top of the C460
33
C460
b
a
b
a
Key
a Front-mount position
b Mid-mount position
3
Cable Guide Installation
You can use the cable guide to tidy cables from the Supervisor and I/O modules. The cable guide
is symmetric: you can install the bracket on either side of the switch.
LAvaya recommends that you install the cable guide on the left side of the switch to allow
easier access to the fan module.
LYou need to install the rack mounting brackets before you can install the cable guides.
LInstall the switch in the rack before installing the cable guide.
• Secure the cable guide to the rack mounting bracket using the captive screws on the cable
holder. See Figure 7.
Figure 7 Installing the Cable Guide
abab
Leftsideofchassis
Right side of chassis
Key
aCableGuide
b Rack-mounting bracket
4
Install the Supervisor Module and PSU
Install the Supervisor Module
LIf you purchased an Avaya C460ML-CFG (Material code 700255003, PEC Code 4548-009),
then one Supervisor Module, PSU and the Fan Module are already installed.
Figure 8 shows the positions of the SPV Supervisor installed in the C460 chassis.
Figure 8 Location of the Avaya C460 Supervisor Modules
LYou can install Supervisor modules in the top two slots – 1 and 2 – only.
Caution: Do not leave any slots open. Use the blanking plates supplied to cover empty slots.
Caution: The Supervisor modules contain components that are sensitive to static discharge.
Handle the module by the edges only.
Use appropriate anti-static equipment when handling the modules.
Andere Handbücher für C460 SMON
2
Inhaltsverzeichnis
Andere Avaya Schalten Handbücher
Avaya
Avaya WLAN Security Switch 2300 Series Leitfaden
Avaya
Avaya Cajun P580 Montage- und Bedienungsanleitung
Avaya
Avaya WLAN 8100 Series Bedienungsanleitung
Avaya
Avaya P114F Bedienungsanleitung
Avaya
Avaya ERS 3500 Bedienungsanleitung
Avaya
Avaya P333R-LB Bedienungsanleitung
Avaya
Avaya C360 Manager Bedienungsanleitung
Avaya
Avaya 5600 Series Betriebsanleitung
Avaya
Avaya 5900 Series Bedienungsanleitung
Avaya
Avaya Ethernet Routing Switch 8300 Series Bedienungsanleitung
Avaya
Avaya Cajun P550R Anleitung zur Verwendung
Avaya
Avaya P334T-ML Bedienungsanleitung
Avaya
Avaya ERS 3500 Series Bedienungsanleitung
Avaya
Avaya Cajun P550R Bedienungsanleitung
Avaya
Avaya Cajun P550R Bedienungsanleitung
Avaya
Avaya Virtual Services Platform 7000 Series Bedienungsanleitung
Avaya
Avaya 5000 Series Betriebsanleitung
Avaya
Avaya VSP 7200 Series Bedienungsanleitung
Avaya
Avaya 4900 Series Bedienungsanleitung
Avaya
Avaya MX10 Bedienungsanleitung
