AWID UA-612 Montageanleitung

UA-612 Installation Sheet Version 2 Page 1 of 2

Installation Sheet (Wiegand Interface)

UA-612 UHF Card Reader

These Instructions are for AWID’s Model UA-612 reader, using compatible UHF cards supplied by AWID.

Parts List

(a) 1 Installation Sheet UA-612

(b) 1 UA-612 Reader

Preparation

Reader Location: Select the reader’s mounting location. The UA-612 Reader may be screwed to a single-gang

utility box like a cover plate, or to a wall or other surface. On a metal surface, read range is reduced about 20%.

If the reader is exposed directly to rain or snow, use a polycarbonate housing for protection.

DC Power Supply: Separate – independent from any other device. Dedicated – only this reader connected to

the power supply. Do not draw the reader’s power from the system’s controller. Nominal 12 volts DC (supply

between 7.5 V and 15 V to the reader). Current capacity, 1 ampere or more. Linear -rated. Regulated DC out.

Cable to Controller and Power Supply: 5 to 7 conductors from reader to the system (2 for DC power, 3 for

Wiegand data, and 2 for control lines if used). 18 gauge (22 gauge for data and control lines if they are in

separate cable from power). Overall 100% shield for both power and data. 500 feet maximum length.

If cable is pulled through metal conduit, the conduit must be earth-grounded.

Procedure

1. Connector – Cut off the white 10-pin connector from the end of the reader’s cable. Discard the connector.

2. Open the Reader – Snap open the reader’s front cover by inserting a wide screwdriver blade in the slot

at the bottom edge of the cover. Twist the blade gently. Do not remove screws inside the cover.

(continued)

UA-612 Installation Sheet Version 2 Page 2 of 2

3. Wire Connections – Connect the reader’s wires to the cable(s) for power and data and control.

a. First, connect black to DC negative on the power supply. Then …

b. Connect black also to Data-Common on the panel. If there is no Data-Common terminal, use Ground.

c. Connect green to Data-0 and white to Data-1.

d. If control lines are used, connect brown to LED (or LED-Green) and yellow to Buzzer.

e. Connect the drain wire to the shields of power and data cables.

f. At the end of the cables near the panel and power supply, connect the cables’ shields to earth-ground.

g. Last, connect red to DC positive on the power supply.

4. Physical Mounting – Feed the reader’s cable through the utility box or the wall’s cable opening. Fasten the

reader to the utility box or the wall, with screws through the holes inside the open read er. Use the supplied

screws for mounting on a utility box. A tamper alarm NC pushbutton switch may be inserted in the 0.110

inch hole through the base of the reader. Tamper alarm occurs when the UA-612 reader’s cover is removed.

5. Reader Test – When power is applied to the UA-612, the LED is lighted steady-red for standby, and the

beeper sounds. With every presentation of an AWID UHF card to the reader, the LED changes color

momentarily, and the beeper sounds briefly. Read range is up to 6 inches.

6. System Test – Wire the reader to the system’s controller. Program the code for the AWID UHF card into

the host system, with full priority, all doors groups, and all time zones. Present the card to the reader. The

LED changes to green for a few seconds, indicating Access Granted.

Interface

● Wiegand Interface Wires – Green for Data-0, white for Data-1, and black for Data-Common.

● Codes in Cards – UA-612 reads AWID’s UHF cards, programmed with codes of 26 bits to 50 bits.

● RS-232 Serial Interface – Contact AWID’s Technical Support for the RS-232 Technical Reference.

Operating Conditions

● Indoor and Outdoor – If exposed to rain or snow, install UA-612 in an IP64-rated polycarbonate housing.

● Temperature & Humidity – -31 F to 150 F degrees (-35 C to 65 C). 0% to 95% R.H. non-condensing.

● Transmitting Frequency – 902.6 to 927.4 MHz, frequency-hopping. Channels separated by 200 kHz.

● Voltage Connections – Apply power only to UA-612’s black and red wires – never to the other wires.

● Output Testing – To test UA-612 operation, clip the LR-KIT’s Test Unit to black, orange and red wires.

Support

● Technical Support – Call 408-825-1100, option 1. E-mail [email protected].

Inhaltsverzeichnis

Andere AWID Kartenleser Handbücher

AWID

AWID MPR-5005 Bedienungsanleitung

AWID

AWID SR-2400 Montageanleitung

AWID

AWID LR-2200 Bedienungsanleitung

AWID

AWID SENTINEL-PROX LR-911 Bedienungsanleitung

AWID

AWID SENTINEL-PROX SC-2300 Bedienungsanleitung

AWID

AWID SP-6820 Montageanleitung

AWID

AWID MM-6800 Montageanleitung

AWID

AWID Sentinel-Prox MR-1824HiLo Montageanleitung

AWID

AWID SR-2400 Montageanleitung

AWID

AWID LR-3200 Montageanleitung

AWID

AWID KP-6840 Montageanleitung

AWID

AWID SENTINEL-PROX LR-911 Bedienungsanleitung

AWID

AWID SR-2400 Montageanleitung

AWID

AWID SENTINEL-PROX LR-2000 Bedienungsanleitung

AWID

AWID MR-1824HiLo Montageanleitung

AWID

AWID XK-3640 Montageanleitung

AWID

AWID Sentinel-Prox DC-1023 Montageanleitung

AWID

AWID MPR-3014WF-QB Bedienungsanleitung

AWID

AWID uAxcess XJ-1023 Bedienungsanleitung

AWID

AWID SENTINEL-PROX DK-1025 Bedienungsanleitung

AWID

AWID SENTINEL-PROX MR-1824 Montageanleitung

AWID

AWID LR-3000 Bedienungsanleitung

AWID

AWID Sentinel-Sense ADB-512 Bedienungsanleitung

AWID

AWID XR-3600 Montageanleitung

Beliebte Kartenleser Handbücher anderer Marken

Lindy

Lindy 43185 Bedienungsanleitung

Lindy

Lindy 43185 Bedienungsanleitung

ViziT

ViziT RD-4F Bedienungsanleitung

Jinmuyu Electronics

Jinmuyu Electronics MR811 Series Bedienungsanleitung

AVID ID

AVID ID AVID1043 Bedienungsanleitung

Conrad

Conrad PCMCIA Bedienungsanleitung

Rosslare

Rosslare DR-6255 Bedienungsanleitung

Lindy

Lindy 51541 Bedienungsanleitung

Diapro T?bbi Ürünler

Diapro T?bbi Ürünler Across System Bedienungsanleitung

Johnson Controls

Johnson Controls Kantech tyco ioSmart Bedienungsanleitung

ACS

ACS ACR122L Bedienungsanleitung

Secukey

Secukey S2-MF Bedienungsanleitung

Elecom

Elecom MR-SMC07 series Bedienungsanleitung

Alien

Alien ALR-9800 Bedienungsanleitung

ACS

ACS ACR310 Bedienungsanleitung

Datamars

Datamars R-IN1300 MID Bedienungsanleitung

Alarm Lock

Alarm Lock AL-PRE2 Bedienungsanleitung

xpr

xpr B100PROX-AH Benutzerhandbuch