3
Instructions for Use MED-440
We recommend doing a massage,
focusing on the following images:
neck and shoulder massage
lower back massage
thighs and shins massage
massage of the buttocks
foot massage
Methodical recommendation for effective massage
The massage effect on the body is a complex physiological process in which mechanical, humoral and
neuro-reflex factors are involved. As a result, occurs not only mechanical kneading of the muscles, but
the improvement of lymph and blood circulation, increases the outflow of excess interstitial fluid and
decreases the swelling. Biologically active substances (histamine, acetylcholine) enter the blood, that
leads to an improvement in well-being and an increase in tone and vitality. Properly done massage
allows you to achieve health on several levels: mental, emotional and mental. B.Well massager combines
a gentle effect on reflexogenic zones or acupuncture points and a deep kneading effect that allows you
to effectively deal with stress and fatigue, relieve muscle tension, improve blood flow, reduce heaviness
and swelling. This methodological recommendation was developed by B.Well specialists in order to achieve
maximum massage efficiency. We suggest using MED-440 functions in the following sequence:
1. Warm-up stage:
Take a comfortable position, turn on the massager. The massage heads will rotate at the fastest (III) speed
with heat. Massage for 2 minutes. Then turn off the heat and massage for another 2 minutes. Thus, the
body will be prepared for the main (active) phase of the massage. The muscles will be warmed up, nutrients
and oxygen will begin to flow to them, which increases physical endurance. Every minute the massager
changes the direction of movement of the massage heads – this is done to get as close as possible to
manual massage. The total warm-up time is 4 minutes.
2. Active phase of massage:
When your body is prepared, the stage of a deeper relieve of the muscles and acupuncture zones begins.
Switch to the slowest (I) speed. Massage for 2 minutes. Muscles are worked out deeper, reaching trigger zones.
Turn on the heating mode to activate the nerve endings. Massage for 2 more minutes. Switch to medium (II)
speed. Massage for 2 minutes. During this time, humoral factors are actively connected to relax and work out
the problem areas. Turn off the heat and massage for 1 more minute. Further increase the pressure on the
acupuncture points by stretching the sleeves. Because of a specially built spring mechanism, your acupuncture
zones will receive enough pressure to improve the tone and energy of the whole body. The total massage time in the active phase is 7 minutes.
3. Relaxing-final stage:
Return to the fastest (III) speed to complete the massage. Massage for 2 minutes. Then turn on the heating. This will allow the muscles to relax and
return to their original state. Close your eyes, spend the last 2 minutes of the session with recovery and relaxation. The total time of the final stage
until the massager is completely turned off is 4 minutes.
7. CONTRAINDICATIONS AND PRECAUTIONS
ATTENTION!
If the following symptoms apply to you, please consult a specialist before using the massager
In the case of pregnancy or recent birth, physical injury, heart or pacemaker disease, diabetes or other sensitivity disorders, phlebitis and/
or thrombosis, joint dysfunction, inflammation or injury, osteoporosis, high temperature, vertebral or spinal deformities, increased risk of
clotting, pins/screws/artificial joints or other medical devices implanted in the body
Precautions:
1. Use the device only for the intended purpose specified in this manual. 7. Do not use damaged power cord or plug.
2. Do not use the device under the blanket or under the cushion. This can lead to fire. 8. Do not spray essential oil, paint or pesticides.
3. Do not sit on massage heads. 9. Do not use in wet places such as bathrooms.
4. Do not fall asleep during the procedure. 10. Do not leave the massager under direct sunlight.
5. Avoid water hitting the massager, power plug, power cord. 11. Do not open the case and do not replace the internal parts.
Immediately disconnect the device from the power supply if it was in the water. 12. Do not place near fire and combustible materials.
6. Disconnect the power cord if you do not use a massager. 13. Keep out of reach of children.
8. CLEANING AND STORAGE
ATTENTION!
Before you start cleaning, you must disconnect the device from the power and wait for the complete cooling.
If the product is contaminated, wipe it with a soft, slightly damp cloth on the outside or use a dry cloth;
Store the massager in a dry, cool place, do not expose directly to sunlight;
Do not use sprays, gasoline, solvents to clean the massager;
9. TROUBLESHOOTING AND SOLUTIONS
NOTE,
in the event of a malfunction, it is necessaryto disconnect the massager from electricity and let it cool for 60 minutes.
Possible problems Cause, troubleshooting
Does not turn on
Make sure the massager is plugged in
Connect the appliance to a different power socket
Turn off the device, repeat the procedure after 10 minutes.
Sudden stop during massage session Power turned off accidentally
The product has a 15 minute automatic timer, the time limit has been reached.
