BARRON TRACE-LITE AXL2 Bedienungsanleitung

AXL2 (80-280W)

INSTALLATION INSTRUCTIONS

800.533.3948 • www.barronltg.com

Mounting Preparation

Slip Fitter (fits up to 2 3/8” OD)

1. Separate the slip-fitter from the knuckle by removing the adjustment bolt with a hex wrench (provided by

others) (Fig. 1).

2. Feed wire leads from the AXL2 through the knuckle and attached the knuckle to the head (Fig. 2).

3. Feed wire leads through the slip-fitter and then attach the slip-fitter to the knuckle (Fig. 3).

4. Electrical connections should be made at this time (see Wiring section).

5. Install the slip-fitter on the pole and secure with screws.

IMPORTANT SAFEGUARDS

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

When using electrical equipment, basic safety precautions should always be followed including the following:

• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

• Installation and servicing of this equipment should be performed by qualified service personnel only.

• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.

• Do not mount near gas or electric heaters.

• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by

unauthorized personnel.

• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

• Any modification or use of non-original components will void the warranty and product liability.

• Do not use this equipment for other than intended use.

SAVE THESE INSTRUCTIONS!

Fig. 1 Fig. 2 Fig. 3

20070138 REV 1 P-5 - 2/19 1

Trunnion

1. Feed wire leads through slot in trunnion (Fig. 4).

2. Attach trunnion to the head (Fig. 5).

Yoke

1. Attach yoke to the head using a hex wrench (provided by others) (Fig 6).

INSTALLATION INSTRUCTIONS

800.533.3948 • www.barronltg.com

Fig. 4 Fig. 5

Fig. 6

20070138 REV 1 - 2/19

AXL2 (80-280W)

Surface/Pole Mounting

Slip-Fitter

1. Connect wires from AXL2 to supply (see Wiring section) and

position wires inside pole (Fig. 7)

2. Secure slip-fitter over pole and tighten.

3. To position, loosen the adjustment bolt using a hex wrench

(provided by others), position head as desired, then retighten

the bolt.

Notice: Adjustable angle is 0-90° (Fig. 7).

Arm

1. Disassemble the pole bracket from the arm.

2. If assembling to a round pole, remove and discard the adapter

gasket.

3. Using the pole bracket as a guide, drill holes in pole at desired

location.

4. Attach arm to pole with pole bracket inside pole.

5. Feed wire leads from the ALX2 through slot in arm.

6. Attach the AXL2 head to arm using adjustment bolt.

7. Adjust head to desired position and tighten adjustment bolt.

8. Wiring can be made inside the arm wiring compartment or inside

pole (see Wiring section).

9. Secure wiring cover to arm with gasket in between (Fig. 8)

Trunnion

1. Drill hole in mounting surface or rectangular pole.

2. Attach luminaire to mounting surface or retangular pole (Fig. 9).

3. Make supply connection in waterproof J-box or inside pole

(see Wiring section).

INSTALLATION INSTRUCTIONS

800.533.3948 • www.barronltg.com

Adjustment Bolt

Pole, round or rectangular

Slip Fitter

Pole

Bracket

Adapter

Gasket

Adjustment Bolt

Wiring Cover

Arm

Mounting surface

or rectangular pole

Fig. 7

Fig. 8

Fig. 9

20070138 REV 1 - 2/19

AXL2 (80-280W)

INSTALLATION INSTRUCTIONS

800.533.3948 • www.barronltg.com

Yoke

1. Drill hole in mounting surface or rectangular pole.

2. Attach AXL2 to mounting surface or rectangular pole

(Fig 12).

3. Make supply connection in waterproof J-box or inside pole

(see Wiring section).

Yoke Templates

Wiring

Make electrical connections as follows:

Black - Line

White - Neutral

Green/Yellow Green - Ground

If dimming is used:

Purple - Dim+

Gray - Dim-

Note: This fixture auto adjusts for voltages from 120-277V. Cap all

unused leads to prevent shorting.

IMPORTANT: Weatherproof your outdoor installation, be sure to seal

all holes in fixture housing. (Mounting, conduit, plugs, sensors and

photo-controls, etc.) with silicone sealant.

20070138 REV 1 - 2/19

Mounting surface

or rectangular pole

2.3"

1.2"

3.3" 0.5"

6-Φ0.5"

80-140W

2.3"

1.2"

3.3" 0.5"

6-Φ0.5"

240-280W

Φ0.8"

Φ0.79"

NEUTRAL

Fig. 12

LINE

NEUTRAL

AXL2 (80-280W)

Inhaltsverzeichnis

Andere BARRON Beleuchtungsausrüstung Handbücher

BARRON

BARRON CP-EMW Series Bedienungsanleitung

BARRON

BARRON Exitronix 900E Series Bedienungsanleitung

BARRON

BARRON Speciality LED FBTCJ-24V Bedienungsanleitung

BARRON

BARRON Exitronix 400U Series Bedienungsanleitung

BARRON

BARRON Exitronix TPXC Series Bedienungsanleitung

BARRON

BARRON specialtyLED FTK Bedienungsanleitung

BARRON

BARRON specialityLED RFX Bedienungsanleitung

BARRON

BARRON TRACE-LITE WTA Series Bedienungsanleitung

BARRON

BARRON EXITRONIX VLED-90L Series Bedienungsanleitung

BARRON

BARRON Trace-Lite E110 Bedienungsanleitung

BARRON

BARRON Exitronix VEX-8 NEMA Bedienungsanleitung

BARRON

BARRON EXITRONIX 82 Series Bedienungsanleitung

BARRON

BARRON EXITRONIX VLEDC Series Bedienungsanleitung

BARRON

BARRON Growlite GLE-GL Bedienungsanleitung

BARRON

BARRON Exitronix SCL Series Bedienungsanleitung

BARRON

BARRON EXITRONIX ILX Series Bedienungsanleitung

BARRON

BARRON GROWLITE GRM Bedienungsanleitung

BARRON

BARRON Growlite GLB-315-A-120/277 Bedienungsanleitung

BARRON

BARRON EXITRONIX SCL Series Bedienungsanleitung

BARRON

BARRON EXITRONIX CRL Series Bedienungsanleitung

BARRON

BARRON Exitronix LED-90 Series Bedienungsanleitung

BARRON

BARRON TL301 Bedienungsanleitung

BARRON

BARRON Exitronix CRL Series Bedienungsanleitung

BARRON

BARRON Trace-Lite AXL2 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung