BARRON Exitronix LED-90 Series Bedienungsanleitung

LED-90 SERIES

INSTALLATION INSTRUCTIONS

800.533.3948 •www.barronltg.com

10070145 Rev 1 - 03/14 1

SAVE THESE INSTRUCTIONS!

READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY

• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

• Installation and servicing of this equipment should be performed by qualified service personnel only.

• Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.

• Do not mount near gas or electrical heaters.

• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any

modification or use of non-original components will void the warranty and product liability.

• Do not use this equipment for other than intended use.

INSTALLATION INSTRUCTIONS

JUNCTION BOX / WALL CEILING MOUNT

1. Remove backplate by pushing through the two tabs at the bottom using a narrow screwdriver.

2. Feed fixture leads through backplate.

3. All Electical connections should be made inside junction box.

Make Electrical Connections as follows:

Note: Cap unused leads to prevent shorting.

4. Mount backplate to junction box using hardware provided with junction box.

5. Connect battery only after continuous AC power can be provided to the unit.

6. Align tabs and push housing directly onto backplate.

120V AC

White - Common

Black - 120V

Green - Ground

277V AC

White - Common

Orange - 277V

Green - Ground

Use Flexible Conduit Only.

LED-90 SERIES

INSTALLATION INSTRUCTIONS

800.533.3948 •www.barronltg.com

10070145 Rev 1 - 03/14 2

CONDUIT MOUNT

1. Remove backplate by pushing through the two tabs at the bottom using a

narrow screwdriver.

2. Mount backplate to wall surface using keyhole knockouts.

3. Use conduit entry knockouts on backplate and the unit’s housing to

secure conduit.

4. Route fixture leads through hole in conduit flange.

5. All Electrical connections should be made inside junction box.

Make Electrical Connection as follows:

Note: Cap unused leads to prevent shorting.

6. Connect battery only after continuous AC power can be provided to the

unit.

7. Align tabs and push housing directly onto backplate.

OPERATION

1. During and electrical power failure, the LED lamps will automatically

come on for a minimum of 90 minutes.

2. To test, depress the “TEST” switch. The emergency LED lamps will

illuminate. When the switch is releasedthe lamps will go off.

TESTING

The battery supplied with this unit requires no maintenance. However, it should be tested periodically and replaced when

it no longer operates the lamp heads for the duration of 30 seconds. The battery in this unit has a life expectancy of 4

years when used in a normal ambient temperature of 72°F.

Conduit Entry Keyhole Knockouts

Unit

Connector

Locking Tabs

Conduit Entry Knockout

CHARGER

BOARD

277V RED

120V BLACK

0V WHITE

YELLOW (+)

BLUE (-)

YELLOW (+)

BLUE (-)

LAMP

TEST

READY

RED

BLACK

BATTERY

WIRING DIAGRAM

NOTE: Unused input

lead must be properly

insulated with wire nut

or other approved

method.

120V AC

White - Common

Black - 120V

Green - Ground

277V AC

White - Common

Orange - 277V

Green - Ground

Inhaltsverzeichnis

Andere BARRON Beleuchtungsausrüstung Handbücher

BARRON

BARRON EXITRONIX LED-51 Series Bedienungsanleitung

BARRON

BARRON EXITRONIX EQUITY QMR Series Bedienungsanleitung

BARRON

BARRON Exitronix S900C Series Bedienungsanleitung

BARRON

BARRON Exitronix 900E Series Bedienungsanleitung

BARRON

BARRON EXITRONIX ILX Series Bedienungsanleitung

BARRON

BARRON Exitronix NFT Series Bedienungsanleitung

BARRON

BARRON GROWLITE GRM Bedienungsanleitung

BARRON

BARRON specialityLED RFX Bedienungsanleitung

BARRON

BARRON Exitronix CRL Series Bedienungsanleitung

BARRON

BARRON Exitronix VEX-8 NEMA Bedienungsanleitung

BARRON

BARRON Exitronix SCL Series Bedienungsanleitung

BARRON

BARRON TRACE-LITE WTA Series Bedienungsanleitung

BARRON

BARRON specialtyLED FTK Bedienungsanleitung

BARRON

BARRON EXITRONIX LL30 Series Bedienungsanleitung

BARRON

BARRON TRACE-LITE AXL2 Bedienungsanleitung

BARRON

BARRON Trace-Lite AXL2 Bedienungsanleitung

BARRON

BARRON Exitronix NY900C Series Bedienungsanleitung

BARRON

BARRON TL301 Bedienungsanleitung

BARRON

BARRON TRACE-LITE TL101 Bedienungsanleitung

BARRON

BARRON EXITRONIX SCL Series Bedienungsanleitung

BARRON

BARRON TRACE-LITE RHL-ACR Bedienungsanleitung

BARRON

BARRON EXITRONIX 400WX Series Bedienungsanleitung

BARRON

BARRON EXITRONIX VLED-90L Series Bedienungsanleitung

BARRON

BARRON Growlite GLE-GL Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung