•This item is intended for home use only. Do not use this item in a commercial setting.
•This item is not intended for and should be kept out of children.
•This item contains small parts which pose a choking hazard to small children and animals.
•Be aware that some parts are heavy and have sharp edges.
•If any parts are missing, broken, damaged, or worn, stop using this product until repairs are made and/or factory replacement parts are installed.
•Do not use this item in a way inconsistent with the manufacturer’s instructions as this could void the product warranty.
•This item is designed to be mounted on an existing surface.
•Reconfirm that all bolts, screws, and knobs are secure every 90 days.
•Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled.
•Assemble only as specified by the following instructions.
•This item is intended for installation into a loadbearing surface; wall studs, anchors, or support beams.
•Do not mount this item onto a vehicle.
•Do not overburden or exceed this item’s weight capacity.
•Do not place heavy or overburdened storage bins on the top. Store heavy items on the bottom of the peg boards only.
•Do not rest heavy items on this item.
•Do not overtighten this item’s screws as this may damage the item’s structural integrity.
•Do not attempt to mount this item on a non-loadbearing surface. Locate a stud or cleat to mount this item.
•Small Bins / 2.2lbs. (each)
•Medium Bins / 3.3lbs. (each)
•Large Bins / 5lbs. (each)
•Overall Bin Capacity / 110lbs
•Additional Tool Wight Capacity / 28lbs
WARNING
Please retain these instructions for future reference.
NOTICE
PRODUCT ASSEMBLY
Before installation, please complete the following for maximum product eectiveness:
- Locate existing wall studs and ensure there are no intersecting wires or water pipes.
- Mark the areas to drive your screws using a level to ensure optimum placement.
- Use a power drill to drive pilot holes into the wall stud. This will make inserting the mounting screws easier.
- Use at least 12 screws to mount this item for maximum stability. Use more if necessary.
1. Locate two part A pegboards and orient them so that the storage bin slots are facing upwards. Attach the two boards with your chosen mounting screws
to your designated area.
NOTE: It is recommended to check each screw is driven just enough to secure the pegboard. DO NOT overtighten the screws.
2. Insert four part C large storage bins into their designated spaces.
NOTE: Place these storage bins into the lower slots of the pegboard only.
3. Insert the sixteen part D small storage bins, and eight part B medium storage bins into your desired space.
4. Insert the remaining part E, F, G, and H tool storage accessories into your desired location on the part A pegboards.
NOTE: Arrange the storage accessories to match your preferred tool layout.
E
DSMALL STORAGE BIN
(16 PCS)
WRENCH
RACK
(2 PCS)
PEGBOARD PANEL
(2 PCS)
A
LARGE STORAGE BIN
(4 PCS)
C
FLARGE HAND
TOOL SHELF GSMALL HAND
TOOL SHELF
HHANGING PEG
(10 PCS)
BMEDIUM STORAGE BIN
(8 PCS)
WEIGHT CAPACITY
This item does not include any mounting hardware. Please use appropriately sized screws (at least 3-inches long) depending on the wall material.
Use longer screws for softer wall materials.
Wall Mounted Pegboard Organizer SKY4457
