3
1 - INTRODUCTION
Key Description
This key performs two functions:
•When pressed by itself, it acts as the F1 function key, the function of which is defined by
parameter F1 Key Config (see RSi SX Parameter Configuration manual).
•When SHIFT is pressed at the same time as this key, the keypad enters Monitor Mode
(see page 7 for more information on this mode).
This key performs two functions:
•When pressed by itself, it acts as the F2 function key, the function of which is defined by
parameter F2 Key Config (see RSi SX Parameter Configuration manual).
•When SHIFT is pressed at the same time as this key, the keypad enters Operate Mode
(see page 6 for more information on this mode).
This key performs two functions:
•When pressed by itself, it acts as the F3 function key, the function of which is defined by
parameter F3 Key Config (see RSi SX Parameter Configuration manual).
•When SHIFT is pressed at the same time as this key, the keypad enters Parameter Mode
(see page 8 for more information on this mode).
This key performs two functions:
•When pressed by itself, it acts as the F4 function key, the function of which is defined by
parameter F4 Key Config (see RSi SX Parameter Configuration manual).
•When SHIFT is pressed at the same time as this key, the keypad enters Direct Parameter
Access Mode (see page 10 for more information on this mode).
When the keypad is in the Direct Parameter Access Mode, the numeric keypad allows you to
set the value of a parameter by keying in the value rather than by scrolling to the desired
value.
The function of this key, the up arrow key, is dependent on the mode of the keypad:
•In modes other than programming, the up arrow key moves the arrowhead from one menu
selection to the next selection.
•When programming the value of a parameter, it increases the value of the parameter. If the
key is held down, the rate of scrolling will increase. The rate of scrolling will increase still
further if the SHIFT key is pressed along with the up arrow key
The function of this key, the down arrow key, is dependent on the mode of the keypad:
•In modes other than programming, the down arrow key moves the arrowhead from one
menu selection to the previous selection.
•When programming the value of a parameter, it decreases the value of the parameter. If
the key is held down, the rate of scrolling will increase. The rate of scrolling will increase
still further if the SHIFT key is pressed along with the down arrow key.
The ESC key is used to discard any changes made and move up one level.
The ENT key is used to save the new value of a parameter. After saving the new value, the
display moves up one level.
This key causes the Menu Display to be shown, from which other keypad modes may be
selected. See page 11 for more information.
The REV key, if enabled by parameter Reverse Mode (see RSi SX Parameter Configuration
manual), commands the motor to begin running in the Reverse direction.
Table 1: Functions of the Keys on the Enhanced Keypad
ESC
MENU
MON
F1
OPR
F2
PAR
F3
DIR
F4
ENT
REV
