•If the housing becomes dusty, wipe it with a soft dry dust cloth. Do not use any wax or polish sprays on
the housing.
•If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth slightly
dampened with a mild soap and water solution. Never use abrasive cloths or polishes as these will damage
the finish of your unit.
ON WATERPROOF PERFORMANCE OF THE THIS PRODUCT
1. The water resistant specifications of this product are equivalent to IPX4 in IEC 60529 “Degrees of
protection against ingress of water (IP Code)”, which specifies the degree of protection provided against
the entry of water. The product cannot be used in water.
2. Unless the unit is used correctly, water may get into the this product and cause fire, electrocution, or
malfunctions. Note the following cautions carefully and use the unit correctly.
IPX4: Protected against water splashing from any direction.
Liquids that the water resistant performance specifications apply to
Applicable: Fresh water, tap water
Not applicable: Liquids other than those above (examples: soapy water, detergent water,water with
bath agents, shampoo, hot spring water, pool water, seawater, etc.)
The water resistant performance is based on measurements performed under the conditions described
above. Note that malfunctions resulting from water immersion caused by customer misuse are not covered
by the warranty.
To maintain water resistant performance
Carefully note the precautions below to ensure proper use.
⚫Do not splash water forcibly into the sound output holes.
⚫Do not let the unit fall into the water, and do not use underwater.
⚫Do not allow the product to remain wet in a cold environment, as the water may freeze. To prevent
malfunction, make sure to wipe off any water after use.
⚫Do not place the product in water or use it in a humid place such as a bathroom.
⚫Do not drop the unit or expose it to mechanical shock. Doing so may deform or damage the product,
resulting in deterioration of water resistance performance.
⚫Use a soft dry cloth to wipe off any water that gets on the product. If water remains in the speaker output
holes, the speaker may become muffled or completely inaudible. If this happens, position the Speaker
holes facing downward, and shake several times to get the water out.
