BESAFE IZi Kid ISOfix Bedienungsanleitung

ECE R44/04

semi-universal 0-18 kg

CR 44 04200

Complies with revised

standard:

Tested and Approved

ECE R44/04

www.besafe.eu

0+/1 0-18 6m-4y

User manual GB

Vital information

Vital information 2

Preparing to install 4

Before installation 6

Installation in the car 8

Waring: potential misuse 11

Sitting positions 12

Car seat protection 12

Removing the iZi Kid ISOx 13

After an accident 15

Guarantee 15

Removing and retting the cover 16

Important advice 18

Point of sale information 20

Thank you for choosing Besafe iZi Kid ISOﬁx.

Contents

iZi Kid ISOfix can only be installed rearward facing. The car must be equipped -

with ISOfix anchorage points.

iZi Kid ISOfix is not allowed to mount in front passenger seat with an activated -

airbag.

The floor support must always be used. -

The harness must always be used when the child is in the seat. -

For children under 1 year and/or under 10 kg weight, we recommend that the -

most reclined sitting position is used.

We recommend that this seat is used only for children who can sit upright, so not -

younger than 6 months.

It is important that you read this user manual BEFORE

installing your iZi Kid ISOx. Incorrect installation could

endanger your child.

AIRBAG

BeSafe recommends that child seats are not bought or sold

second-hand.

Second-hand car seats

DO NOT use on a passenger seat tted with

activated frontal airbag.

Important:

BeSafe iZi Kid ISOx is only possible to mount in cars with

ISOx anchorage points, see the instruction manual of the

car for more information.

Under the fabric cover we use EPS foam. Do not push or

pull too hard against the foam, since you might damage

the foam.

1. Internal harness

2. Harness adjustment

3. Front brace

4. Switch for ISOx connectors

5. Lever for sleeping positions

6. Ratchet for front brace

7. ISOx connectors

Crucial parts

Preparing to install

8. Release button for ISOx connectors

7. ISOx installation connectors

9. Plastic caps for the ISOx connectors

10. Indicator for correct installation

11. Belt height adjuster

12. Floor support

13. Lockingbolt for oor support

14. Belt loop for the oor support

15. ISOx anchorage (car)

7. ISOx connector

16. ISOx insertion clips

Too high Too low Correct

Click!

Height adjustment of harness system

Height can be adjusted by releasing

the height adjustment device on the back of

the iZi Kid ISOx, place it in the correct position

and clicking it in. Twist and pull the shoulder

belts on the front side of the seat until the belts

are adjusted into the correct position. Check

the webbing has not become twisted.

Position of the shoulder strap:

Check that the shoulder strap slots are

levelled with your child’s shoulders.

You must adjust the shoulder belt of the harness to the

correct position for your child before installing the seat, as it

cannot be adjusted in the car. The harness must be fastened

and adjusted correctly at all times. Children should be

encouraged to remain within the harness system.

Lay the shoulder straps over the sides of the iZi

Kid ISOx, before your child is seated. Then place

the straps over the shoulders of your child and

close the buckle; Click!

Position the pads on the shoulder straps over the

child’s shoulders. Place one hand on the front of

the car seat and pull the harness adjustment strap

towards you. Continue pulling until the harness is

a comfortable but rm t.

Tighten the belts by pulling them towards

you and in this way straighten them out

inside the construction.

Pull out the shoulder belts while pressing the

button on the harness adjustment mechanism.

Before installation

When mounting in the back

seat, push the front seat as

far forward as possible.

When mounting in the front

seat, adjust the backrest in

a upright position.

!DO NOT use on a passenger seat tted with activated

frontal airbags.

Find the ISOx anchorage

points in the car (15).

AIRBAG

If your car is not epuipped

with ISOx insertion clips (16),

insert these to make installation

easier.

You can nd the ISOx insertion

(16) clips under the base of your

iZi Kid ISOx.

Clip the insertion clips into the

anchorage points.

Remove the plastic

caps (9) from the ISOx

connectors (7) by pressing

down the ISOx release

Use the ratchet (6) to adjust

the front brace to the inmost

position. The ratchet (6)

is used to adjust the front

brace in both directions.

Switch the knobs on the

ratchet to change direction.

The oor support (12) must

go through the belt loop

(14). The belt loop must

also be led into the hook

on the oor support.

Do not fasten the locking

bolt (13) yet.

Assemble the oor support

before you install the iZi Kid

ISOx in your car.

Important: The belt loop

must be led into this hook

Installation in the car

1Place the seat into the car by

racing the seat with the front

brace rst.

BeSafe iZi Kid ISOx is installed the same way in the front and

back seat.

Push the oor support down

to the oor. The oor support

(12) must go through the belt

loop (14) and the belt loop

must be led into the hook

on the oor support. See

explanation in the chapter

“BEFORE INSTALLATION”.

Turn the seat into the right

position (with the front brace

against the backrest).

!The BeSafe iZi Kid ISOx can ONLY be installed rearward

facing in cars with ISOx anchorage points.

!The BeSafe iZi Kid ISOx must not be used in the front

passenger seat without deactivating the airbag.

Click the ISOx connectors in

the ISOx anchorages.

Pull both ISOx connectors (7)

as far out as possible.

The switch (4) then goes into

the lowest position and locks

the connectors (7).

Make sure that the two indica-

tors (10) are green, both in the

hole and on the inside of the

release gear.

Adjust the oor support (12)

so that it is in contact with the

oor of the vehicle.

Lock the oor support with the

lockingbolt (13).

13 12

Click

Adjust the front brace

outwards with the ratchet

(6). Continue tightening until

the brace is pressed well into

the backrest of the car seat.

Make sure all ISOx indicators are green before you drive.

Make sure the oor support is fully pushed down and

locked.

DO NOT use on a passenger seat tted with

activated frontal airbags.

If possible, push the front seat backwards so that it is in

contact with the child seat. If it is not possible to obtain

contact with the child seat, push the backrest of the front seat

forward so that the distance between child seat and backrest

is minimum 25 cm.

Correct installation

AIRBAG

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere BESAFE Autositz Handbücher

BESAFE

BESAFE iZi Flex S FIX Bedienungsanleitung

BESAFE

BESAFE iZi Turn B i-Size Bedienungsanleitung

BESAFE

BESAFE iZi flex flx i-Size Bedienungsanleitung

BESAFE

BESAFE PAD+ Bedienungsanleitung

BESAFE

BESAFE iZi Combi Bedienungsanleitung

BESAFE

BESAFE iZi Go Modular Bedienungsanleitung

BESAFE

BESAFE iZi Combi x2 Bedienungsanleitung

BESAFE

BESAFE iZi Combi X1 Isofix Bedienungsanleitung

BESAFE

BESAFE iZi Plus Bedienungsanleitung

BESAFE

BESAFE IZI UP Bedienungsanleitung

BESAFE

BESAFE IZI UP Bedienungsanleitung

BESAFE

BESAFE 1-2-3 Bedienungsanleitung

BESAFE

BESAFE IZI UP Bedienungsanleitung

BESAFE

BESAFE iZi Modular i-Size Bedienungsanleitung

BESAFE

BESAFE IZI Turn i-Size Bedienungsanleitung

BESAFE

BESAFE iZi Modular Base Bedienungsanleitung

BESAFE

BESAFE iZi Kid i-Size Bedienungsanleitung

BESAFE

BESAFE iZi Kid Bedienungsanleitung

BESAFE

BESAFE iZi Go Modular i-Size Bedienungsanleitung

BESAFE

BESAFE iZi Comfort Bedienungsanleitung

BESAFE

BESAFE Stretch Bedienungsanleitung

BESAFE

BESAFE iZi Turn B Bedienungsanleitung

BESAFE

BESAFE IZI COMFORT ISOFIX Bedienungsanleitung

BESAFE

BESAFE iZi Kid i-Size Bedienungsanleitung

Beliebte Autositz Handbücher anderer Marken

Britax

Britax PARKWAY SGL Bedienungsanleitung

JANE

JANE nurse cruiser Bedienungsanleitung

Digicom

Digicom Tippy Pad Bedienungsanleitung

Giordani

Giordani orion 012 Bedienungsanleitung

BRIO

BRIO ZENTO Bedienungsanleitung

Combi

Combi Zeus Turn 8815 Series Bedienungsanleitung

Graco

Graco Car Booster Seat Bedienungsanleitung

Coccolle

Coccolle Atira Bedienungsanleitung

hifold

hifold HF01-GL Bedienungsanleitung

CYBEX

CYBEX SOLUTION X2-FIX Bedienungsanleitung

kiwy

kiwy SLF 123 Bedienungsanleitung

Safety 1st

Safety 1st Summit ISO 30 Bedienungsanleitung

Safety 1st

Safety 1st Grand 2-IN-1 Bedienungsanleitung

Graco

Graco NAUTILUS Bedienungsanleitung

Britax

Britax Multi-Tech BB0-702-00 Bedienungsanleitung

Grammer

Grammer MSG45/421 Betriebsanleitung

Nuna

Nuna REBL PLUS Bedienungsanleitung

Graco

Graco Child Restraint Bedienungsanleitung

BESAFE iZi Kid ISOfix Bedienungsanleitung

Beliebte Autositz Handbücher anderer Marken