Billion BiPAC 7300G RA Bedienungsanleitung

BiPAC 7300(G) RA

(802.11g) ADSL2+ Firewall Router

uick Start Guide

Billion BiPAC 7300(G) RA (802.11g) ADSL2+ Firewall Router

Package Contents

BiPAC 7300(G) RA (802.11g) ADSL2+ Firewall Router

CD-ROM containing the on-line manual

RJ-11 ADSL/telephone cable

Ethernet (RJ-45) cable

AC-DC power adapter (12VDC, 1A)

This uick Start Guide

Splitter/ Micro-filter (Optional)

One 2dBi detachable antenna (7300G RA)

Attention

PLEASE READ THE UICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS UICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE USER’S MANUAL ON

THE CD-ROM.



Do not use the

router

in high humidity or high temperatures.

 Do not use the same power source for the router as other

equipment.

 Do not open or repair the case yourself. If the router is too hot,

turn off the power immediately and have it repaired at a qualified

service center.



Avoid using this

product

and all

accessories

outdoors.



Place the router on a stable surface.

 Only use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

Warning

uick Start Guide

Hardware Overview

BiPAC 7300G RA

The Front LEDs

The Rear Ports

Connect the supplied

power adapter to this

jack.

Connect the supplied

RJ-11 cable to this port

when connecting to the

ADSL/telephone

network.

Press reset button for 5

seconds to reset the

device or restore to

factory default settings.

Power

ON/OFF

switch.

Connect a UTP Ethernet

cable cable(RJ-45)to one of

the four LAN ports when

connectiong to a PC or an

office/home network of

10Mbps or 100Mbps.

Lit when

the

system is ready.

Lit

stead

y when there

is a PPPoA / PPPoE

connection.

Lit when successfully

connected to an ADSL

DSLAM

connection.

Connect the

fixed

antenna.

Lit when power is ON

Lit when connected to an

Ethernet device. Green for

100Mbps; Orange for 10Mbps.

Blinking when date is

Transmitted/Received.

Lit Green when the

wireless connection

is established.

Flashes when

sending/receiving

date.

Billion BiPAC 7300(G) RA (802.11g) ADSL2+ Firewall Router

BiPAC 7300 RA

The Front LEDs

The Rear Ports

Lit when

the

system is ready.

Connect a UTP Ethernet

cable(RJ-45) to one of the four

LAN ports when connectiong to

a PC or an Office/home network

of 10Mbps or 100MBps.

Lit

stead

y when

there is a PPPoA /

PPPoE

connection.

Lit when successfully

connected to an ADSL

DSLAM

connection.

Connect the supplied

RJ-11 cable to this

port when connecting

to the ADSL/telephone

network.

Lit when connected

to an Ethernet device.

Green for 100Mbps;

Orange for 10Mbps.

Blinking when data is

Transmitted/Received.

Lit when power is ON

Press it to reset

the device or

restore to factory

default settings.

Connect the

supplied power

adapter to this

jack.

uick Start Guide

Hardware Connection

BiPAC 7300G RA

BiPAC 7300 RA

Billion BiPAC 7300(G) RA (802.11g) ADSL2+ Firewall Router

Hardware Installation BiPAC 7300(G) RA

1. Power Connection

Plug the supplied power adapter to the wall jack and the other side to the router.

Please note that the plug type may differ according to different countries.

2. LAN Connection

Connect the supplied RJ-45 Ethernet ca le to one of the Ethernet ports, and the

other side to the PC’s Ethernet interface.

3. ADSL Connection

Connect the supplied RJ-11 phone ca le to the router’s ADSL port, and the

other side to the phone jack on the wall.

uick Start Guide

4. Splitter/ Micro-filter Connection

Splitter / Micro-filter are important for ADSL installation. High-frequency signals

are directed to the ADSL modem, and low-frequency signals are directed to the

telephone or other analog voice-channel device to prevent inter-modulation

distortion and also to get good speed and sta le ADSL sync rate.

a) Splitter connection

If the installation has only a single telephone and a single ADSL modem, then a

splitter can e employed.

) Micro-filter connection

If the installation has several telephones or other analog devices, then an

internal micro-filter can e employed at each analog device.

Billion BiPAC 7300(G) RA (802.11g) ADSL2+ Firewall Router

Easy Sign On

User just installs all of ca les and uses the rowser to surf Internet. At this time, the EZSO WEB

GUI will e popped up and request you to input some asic information you get from ISP. After

this, you can surf Internet right away.

Troubleshooting

1. None of the LEDs are on when you turn on the router.

Check the connection etween the adapter and the router. If the error persists, you may have

a hardware pro lem. In this case you should contact technical support.

2. You have forgotten your router login and/or password.

Try the default login and password, please refer to Chapter 3. If this fails, you can restore

your router to its factory settings y holding the Reset utton on the ack of your router for 6

seconds or more.

3. Can’t ping any PCs on the LAN.

Check the Ethernet LEDs on the front panel. The LED should e on for a port that has a PC

connected. If it is off, check the ca les etween your router and the PC. Make sure you have

uninstalled any software firewall for trou leshooting. Verify that the IP address and the su net

mask are consistent etween the router and the workstations.

4. Frequent loss of ADSL linesync (disconnections).

Ensure that all other devices connected to the same telephone line as your router (e.g.

telephones, fax machines, analogue modems) have a line filter connected etween them and

the wall socket (unless you are using a Central Splitter or Central Filter installed y a qualified

and licensed electrician), and ensure that all line filters are correctly installed and the right

way around. Missing line filters or line filters installed the wrong way around can cause

pro lems with your ADSL connection, including causing frequent disconnections. If you have

a ack-to- ase alarm system you should contact your security provider for a technician to

make any necessary changes.

Product Support and Contact Information

Most pro lems can e solved y referring to the Troubleshooting section in the User’s Manual.

If you cannot resolve the pro lem with the Troubleshooting chapter, please contact the dealer

where you purchased this product.

Contact Billion

WORLDWIDE: http://www.billion.com

7300(G) RA:V1.03EN

Andere Handbücher für BiPAC 7300G RA

Dieses Handbuch passt für folgende Modelle

Andere Billion Netzwerk-Router Handbücher

Billion

Billion BiPAC 7404VNOX Bedienungsanleitung

Billion

Billion BiPAC 5200 Bedienungsanleitung

Billion

Billion BiPAC 5200 Bedienungsanleitung

Billion

Billion BiPAC 7560G Bedienungsanleitung

Billion

Billion BiPAC 7402G Bedienungsanleitung

Billion

Billion BiPAC 8501 R3 Bedienungsanleitung

Billion

Billion BiPAC 4700AZ Bedienungsanleitung

Billion

Billion (802.11g) ADSL2+ Modem/Router BIPAC 5102G Bedienungsanleitung

Billion

Billion BiPAC 7404VGOX Bedienungsanleitung

Billion

Billion BiPAC 7402G Bedienungsanleitung

Billion

Billion BiPAC 8700NEXL R2 Bedienungsanleitung

Billion

Billion BiPAC 5100 Bedienungsanleitung

Billion

Billion BIPAC 6600 Bedienungsanleitung

Billion

Billion BiPAC 7402(G)X(L) Series Bedienungsanleitung

Billion

Billion BiPAC 7800(N)X(L) Bedienungsanleitung

Billion

Billion BiPAC 7300M Bedienungsanleitung

Billion

Billion BiPAC 8700VAX(L)-1600 Bedienungsanleitung

Billion

Billion BiPAC 7800 Bedienungsanleitung

Billion

Billion BiPAC 7402G Bedienungsanleitung

Billion

Billion BiPAC 5200W RC Bedienungsanleitung

Billion

Billion BiPAC 7402NX Bedienungsanleitung

Billion

Billion BiPAC 6404VGP R3 Bedienungsanleitung

Billion

Billion BiPAC 7402VL Bedienungsanleitung

Billion

Billion BiPAC 7300G Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Korenix

Korenix JetNet 5710G Series Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise

LevelOne

LevelOne FBR-1416 Bedienungsanleitung