Black Box HS523 Bedienungsanleitung

Hookswitch

HS523

FCC INFORMATION

FEDERAL COMMUNICATIONS COMMISSION

AND

INDUSTRY CANADA

RADIO FREQUENCY INTERFERENCE STATEMENTS

This equipment generates, uses, and can radiate radio frequency energy and if not installed and used

properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio

communication. It has been tested and found to comply with the limits for a Class A computing device in

accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide

reasonable protection against such interference when the equipment is operated in a commercial

environment. Operation of this equipment in a residential area is likely to cause interference, in which case

the user at his own expense will be required to take whatever measures may be necessary to correct the

interference.

Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

This digital apparatus does not exceed the Class A limits for radio noise emission from digital apparatus set out in the

Radio Interference Regulation of Industry Canada.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils

numériques de classe A prescrites dans le Règlement sur le brouillage radioélectrique publié par Industrie Canada.

HOOKSWITCH

FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT

1. The Federal Communications Commission (FCC) has established rules which permit this device to be

directly connected to the telephone network with standardized jacks. This equipment should not be

used on party lines or coin lines.

2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device

should be disconnected until the source of the problem can be determined and until the repair has

been made. If this is not done, the telephone company may temporarily disconnect service.

3. If you have problems with your telephone equipment after installing this device, disconnect this device

from the line to see if it is causing the problem. If it is, contact your supplier or an authorized agent.

4. The telephone company may make changes in its technical operations and procedures. If any such

changes affect the compatibility or use of this device, the telephone company is required to give

adequate notice of the changes.

5. If the telephone company requests information on what equipment is connected to their lines, inform

them of:

a. The telephone number that this unit is connected to.

b. The ringer equivalence number.

c. The USOC jack required: RJ-11C.

d. The FCC registration number.

CDC STATEMENT

Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used

to determine how many devices can be connected to your telephone line. In most areas, the sum of the

RENs of all devices on any one line should not exceed five (5.0). If too many devices are attached, they

may not ring properly.

6. In the event of an equipment malfunction, all repairs should be performed by your supplier or an

authorized agent. It is the responsibility of users requiring service to report the need for service to the

supplier or to an authorized agent.

CERTIFICATION NOTICE FOR EQUIPMENT USED IN CANADA

The Canadian Department of Communications label identifies certified equipment. This certification means

that the equipment meets certain telecommunications-network protective, operation, and safety

requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of

the local telecommunications company. The equipment must also be installed using an acceptable method of

connection. In some cases, the company’s inside wiring associated with a single-line individual service may be

extended by means of a certified connector assembly (extension cord). The customer should be aware that

compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility—in this case,

your supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions,

may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility,

telephone lines, and internal metallic water pipe system, if present, are connected together. This precaution

may be particularly important in rural areas.

HOOKSWITCH

CAUTION:

Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority,

or electrician, as appropriate.

The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load to be

connected to a telephone loop which is used by the device, to prevent overloading. The termination on a

loop may consist of any combination of devices, subject only to the requirement that the total of the load

numbers of all the devices does not exceed 100.

NORMAS OFICIALES MEXICANAS (NOM) ELECTRICAL SAFETY STATEMENT

INSTRUCCIONES DE SEGURIDAD

1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico

sea operado.

2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.

3. Todas las advertencias en el aparato eléctrico y en sus instrucciones de operación deben ser respetadas.

4. Todas las instrucciones de operación y uso deben ser seguidas.

5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de baño, lavabo,

sótano mojado o cerca de una alberca, etc..

6. El aparato eléctrico debe ser usado únicamente con carritos o pedestales que sean recomendados por

el fabricante.

NOM STATEMENT

7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el

fabricante.

8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las

instrucciones de operación. Todo otro servicio deberá ser referido a personal de servicio calificado.

9. El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso. La colocación

del aparato eléctrico sobre una cama, sofá, alfombra o superficie similar puede bloquea la ventilación,

no se debe colocar en libreros o gabinetes que impidan el flujo de aire por los orificios de ventilación.

10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como radiadores, registros

de calor, estufas u otros aparatos (incluyendo amplificadores) que producen calor.

11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en el

instructivo de operación, o como se indique en el aparato.

12. Precaución debe ser tomada de tal manera que la tierra fisica y la polarización del equipo no sea

eliminada.

13. Los cables de la fuente de poder deben ser guiados de tal manera que no sean pisados ni pellizcados

por objetos colocados sobre o contra ellos, poniendo particular atención a los contactos y receptáculos

donde salen del aparato.

14. El equipo eléctrico debe ser limpiado únicamente de acuerdo a las recomendaciones del fabricante.

15. En caso de existir, una antena externa deberá ser localizada lejos de las lineas de energia.

16. El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un largo periodo

de tiempo.

HOOKSWITCH

17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u

orificios de ventilación.

18. Servicio por personal calificado deberá ser provisto cuando:

A: El cable de poder o el contacto ha sido dañado; u

B: Objectos han caído o líquido ha sido derramado dentro del aparato; o

C: El aparato ha sido expuesto a la lluvia; o

D: El aparato parece no operar normalmente o muestra un cambio en su desempeño; o

E: El aparato ha sido tirado o su cubierta ha sido dañada.

TRADEMARKS USED IN THIS MANUAL

Any trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.

HOOKSWITCH

Contents

1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

1.1 Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

1.2 Components. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

2. Installation and Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

2.1 How the Hookswitch Device Works . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

2.2 Connecting the Hookwitch Device to the Base. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

2.3 Attaching the Hookswitch Device to Your Telephone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

2.4 Setting Up the Hookswitch Device. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

3. Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

3.1 Calling Black Box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

3.2 Shipping and Packaging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

CHAPTER 1: Introduction

1. Introduction

1.1 Description

The Hookswitch is designed to be

used with the 2.4-GHz Wireless

Remote Unit.

1.2 Components

A. Hookswitch Device

1. Lifting Film (standard)

2. Lifting Height Termination

Switch (standard lifting

height is position 2)

3. Microphone

4. Microphone Housing

(360° adaptable)

B. Cord with Modular Plugs

(connected when shipped)

C. Cleaning Towelette

D. Self-Adhesive Pads

E. Lifting Film (extra high)

Figure 1-1. Components.

Inhaltsverzeichnis

Andere Black Box Schalten Handbücher

Black Box

Black Box LBS005A Bedienungsanleitung

Black Box

Black Box LIG1014A Bedienungsanleitung

Black Box

Black Box COS-2 Bedienungsanleitung

Black Box

Black Box KV9204A Bedienungsanleitung

Black Box

Black Box KV2004A Bedienungsanleitung

Black Box

Black Box KV7000A Bedienungsanleitung

Black Box

Black Box SW175A Bedienungsanleitung

Black Box

Black Box SW1003A Bedienungsanleitung

Black Box

Black Box AC1032A-2 Bedienungsanleitung

Black Box

Black Box LBS216AE-R3 Bedienungsanleitung

Black Box

Black Box SW1040A Bedienungsanleitung

Black Box

Black Box LPB208A-R2 Bedienungsanleitung

Black Box

Black Box Active Star Hub IC207A Bedienungsanleitung

Black Box

Black Box LEV2525A Sicherheitsleitfaden

Black Box

Black Box ServSwitch Ultra KV5002MA-R2 Bedienungsanleitung

Black Box

Black Box SP530A-R2 Bedienungsanleitung

Black Box

Black Box LB005A Bedienungsanleitung

Black Box

Black Box ACX576 Bedienungsanleitung

Black Box

Black Box SW722A-R2 Bedienungsanleitung

Black Box

Black Box KV5300 Series Bedienungsanleitung

Black Box

Black Box Stackable MiniHub Le2801a Bedienungsanleitung

Black Box

Black Box LIG1014A Bedienungsanleitung

Black Box

Black Box LGB5128A Bedienungsanleitung

Black Box

Black Box SW1000A Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung